Furuno Hub-101 - Manual
Furuno Hub-101 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Name
- Page 3 – Installation; Mounting considerations; Wiring; Remount the cable clamp, shield cover and body cover in that order.
- Page 4 – Connected unit; NavNet 3D equipment; DIP switches; Fuse
- Page 5 – Turning Power on, LED function; LED display; Power on sequence; LED; Power; Power LED
INSTALLATION GUIDE
ETHERNET HUB HUB-101
WARNING
Do not open the shield
cover unless totally familiar
with electrical circuits.
Only qualified personnel
should work inside the
equipment.
Do not install the unit where it may get
wet from rain or water splash.
Water in the unit can result in fire, electrical
shock or damage the equipment.
Use only the specific power cable.
Fire or damage to the equipment can result
if a different cable is used.
Do not disassemble or modify the
equipment.
Fire, electrical shock or sirious injury can
result.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
CAUTION
HUB-101
0.80 m
0.50 m
standard
compass
steering
compass
www.furuno.co.jp
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 System Configurations The HUB-101 Ethernet HUB uses an Ethernet interface (100BASE-TX/10BASE-T) to provide the network communication among the NavNet 3D equipments, and PC. Eight ports are provided on this HUB. Three HUB-101 can be installed in a LAN series. Specifications ETHERNET HUB HUB-101 Equ...
3 Installation Mounting considerations The HUB-101 can be mounted on a desktop or a bulkhead. When choosing a mounting location for desktop or bulkhead mounting, keep in mind the following points: • Locate the unit well away from areas subject to water splash and rain.• Keep the unit out of direct s...
4 Interconnection To connect the NavNet 3D equipments, use the NavNet 3D optional cables shown below depend-ing on the unit connected. DIP switch setting When multiple MFD8/12/-BBs are connected to the HUB-101 by using MOD-Z072 cables, you can power all of them by turning on one. The number of DIP s...
