Furuno FELCOM 250 - Manual

Furuno FELCOM 250

Furuno FELCOM 250 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
Page: / 66

Table of Contents:

  • Page 3 – SAFETY INSTRUCTIONS; CAUTION; Mandatory Action; Read these safety instructions before you operate the equipment.; WARNING
  • Page 4 – ii; SYSTEM CONFIGURATION; Antenna unit
  • Page 5 – iii; EQUIPMENT LISTS; Standard Supply
  • Page 6 – iv; Name
  • Page 7 – HOW TO INSTALL THE UNIT; Antenna Unit; General; NOTICE
  • Page 8 – Locate away from passengers and crew; MICROWAVE RADIATION !
  • Page 9 – Minimum distance from other antennas; Distance from radar antenna; More than 5 m
  • Page 10 – Compass safe distance; Other important mounting guidelines are; Mast strength; • It must be able to support radome mass plus at least 2.5; Antenna unit mass
  • Page 11 – Antenna mast and mounting base; the antenna unit to the ground bolt.; Fixing Hole
  • Page 12 – FELCOM 500: How to install the antenna unit; Carefully unpack the radome and check for damage.; Procedure; Lift the antenna unit to the mounting location.
  • Page 14 – FELCOM 250: How to install the antenna unit; Item
  • Page 15 – Put the antenna unit on the mounting base.
  • Page 16 – The cable entry hole (
  • Page 17 – Ask the shipyard to prepare and mount an antenna mast (diameter; Mounting pole
  • Page 18 – Communication Unit; the outline drawing and provide some additional length in cables.; How to install the CU
  • Page 19 – IP Handset; Refer to the outline drawing.
  • Page 20 – to a magnetic compass.; How to install on the bulkhead or bridge panel; Remove four screws from the unit to remove the lid.
  • Page 22 – The hooks supplied are not used in the installation.; Align
  • Page 23 – How to change modem settings; Compass safe distance label
  • Page 24 – How to mount; The catch in the receiver cradle func-; Bottom view
  • Page 25 – ) Remove the plastic sheet and recording sheet.
  • Page 26 – CONNECTIONS; Standard Connection
  • Page 27 – Antenna Cable; Mast; Mouting
  • Page 30 – FMC connector
  • Page 31 – Alarm unit
  • Page 32 – Cable fixture
  • Page 33 – Notice for network connection; Never connect as follows:
  • Page 34 – Hook into slot
  • Page 36 – LAN Cable Fabrication; Armor; Drain wire
  • Page 37 – SETTING AFTER INSTALLATION; Preparation for Setting; Power switch
  • Page 38 – button on upper right hand side on the screen.The Login win-; Login
  • Page 39 – Settings; The sub menu of the Basic settings appears; Basic settings
  • Page 40 – GPS Setting; on the Basic settings sub menu.; Apply; GPS
  • Page 41 – Analog Port Setting; Analog ports; Analog port
  • Page 42 – Incoming Indicator Setting; If the optional Incoming Indicator is connected, set it as follows.; in the Basic settings sub menu.; button to conclude the setting.; Incoming Indicator
  • Page 43 – Serial Port Setting; Set for the equipment that is connected to the RS-232C port.; button to complete the setting.
  • Page 44 – Satellite Setting; Satellite
  • Page 45 – OTA Setting; in the Basic setting sub menu.; OTA
  • Page 46 – Handset Setting; Web software setting; in the Settings sub menu at the left side of the screen.; Extension; in the PBX Setting sub menu.; Add; The registered number appears on the Extension screen.
  • Page 47 – Setting in the IP handset; key at the idle screen to show the main menu.; Enter; key to
  • Page 50 – APPENDIX 1 JIS CABLE GUIDE; TT; Insulation Type
  • Page 51 – 㧼㧭㧯㧷㧵㧺㧳ޓ㧸㧵㧿㨀
Loading the manual

www.furuno.co.jp

All brand and product names are trademarks, registered trademarks or service marks of their respective holders.

Installation Manual

INMARSAT FLEETBROADBAND

FELCOM 250/FELCOM 500

SAFETY INSTRUCTIONS ............................................................................................................. i

SYSTEM CONFIGURATION ........................................................................................................ ii

EQUIPMENT LISTS ..................................................................................................................... iii

1. HOW TO INSTALL THE UNIT ................................................................................................. 1

1.1 Antenna Unit ...................................................................................................................... 1
1.2 Communication Unit ......................................................................................................... 12
1.3 IP Handset ....................................................................................................................... 13
1.4 Incoming Indicator (option)............................................................................................... 14
1.5 Facsimile FAX-2820 (Option) ........................................................................................... 16
1.6 Telephone FC755D1 (Option) .......................................................................................... 17

2. CONNECTIONS ..................................................................................................................... 20

2.1 Standard Connection ....................................................................................................... 20
2.2 Antenna Cable ................................................................................................................. 21
2.3 Communication Unit ......................................................................................................... 24
2.4 Notice for network connection .......................................................................................... 27
2.5 Desktop Installation of Communication Unit to

comply with IPX2 (dripping) standard ..... 28

2.6 LAN Cable Fabrication ..................................................................................................... 30

3. SETTING AFTER INSTALLATION ........................................................................................ 31

3.1 Preparation for Setting ..................................................................................................... 31
3.2 GPS Setting ..................................................................................................................... 34
3.3 Analog Port Setting .......................................................................................................... 35
3.4 Incoming Indicator Setting................................................................................................ 36
3.5 Serial Port Setting ............................................................................................................ 37
3.6 Satellite Setting ................................................................................................................ 38
3.7 OTA Setting...................................................................................................................... 39
3.8 Handset Setting................................................................................................................ 40

APPENDIX 1 JIS CABLE GUIDE ...........................................................................................AP-1
PACKING LIST ......................................................................................................................... A-1
OUTLINE DRAWINGS.............................................................................................................. D-1
INTERCONNECTION DIAGRAM ............................................................................................. S-1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - SAFETY INSTRUCTIONS; CAUTION; Mandatory Action; Read these safety instructions before you operate the equipment.; WARNING

i SAFETY INSTRUCTIONS Do not open the equipment unless totally familiar with electrical circuits and service manual. Only qualified personnel should work inside the equipment. Do not approach the radome closer than 1.4 m (FELCOM 500) or 0.7 m (FELCOM 250) when it is transmitting. The radome emits ra...

Page 4 - ii; SYSTEM CONFIGURATION; Antenna unit

ii SYSTEM CONFIGURATION Antenna unit FB-1500 (FELCOM 500) FB-1250 (FELCOM 250) Communication unit FB-2000 IP HandsetFB-8000 Incoming indicatorFB-3000 Network Equipment G3 facsimile Analog telephone Analog telephoneAnalog telephone Navigation equipment External alarm PC or Router AC-DC Power supplyPR...

Page 5 - iii; EQUIPMENT LISTS; Standard Supply

iii EQUIPMENT LISTS Standard Supply *: See lists at the back of this manual. Optional Supply Name Type Code No. Qty Remarks Antenna unit FB-1500 - 1 For FELCOM 500 FB-1250 - For FELCOM 250 Communication unit FB-2000 - 1 IP handset FB-8000 - 1 Installation materials* CP16-04100 000-015-746 1 30 m ant...

Other Furuno Models

All Furuno Other