Fujitsu D1961 - Manual

A26361-D1961-Z120-1-7419, edition 2 English - 1 Mainboard D1961 Your mainboard is available in different configuration levels. Depending on the configuration chosen, some of the hardware components described may not be available on your mainboard. Additional information Information on the BIOS Setup...

Important notes 2 - English A26361-D1961-Z120-1-7419, edition 2 Important notes With the mainboard installed you must open the system to access the mainboard. How to dismantle and reassemble the system is described in the operating manual accompanying the system. Connecting cables for peripherals mu...

List of features A26361-D1961-Z120-1-7419, edition 2 English - 3 List of features Onboard features D1961-A Chipset SiS661FX /964 Board size µATX VGA ! Audio / 6-channel / S/PDIF 5.1 ! / ! / - Buzzer / int. Speaker Support - / ! LAN 1 Gbit / 100 Mbit / 10 Mbit - / ! / ! LAN ASF / with Alert-on-LAN / ...

List of features A26361-D1961-Z120-1-7419, edition 2 English - 5 Special features Your mainboard is available in different configuration levels. Depending on the configuration, your mainboard is equipped with or supports the features described in the following. Silent Fan LT A controller regulates t...

6 - English A26361-D1961-Z120-1-7419, edition 2 Brief instructions on installing mainboard If you have purchased a separate mainboard, you can install it in your system in accordance with the following brief instructions. The activities described here assume a basic knowledge of PCs and cannot be ca...

Brief instructions on installing mainboard A26361-D1961-Z120-1-7419, edition 2 English - 7 Installation ► Equip the mainboard with the processor, heat sink and memory modules before installation if possible. Further information can be found in "Replacing the processor" chapter. ► Open the ca...

8 - English A26361-D1961-Z120-1-7419, edition 2 Interfaces and connectors The positions of the interfaces and connectors are shown on page "Cover". The components and connectors marked are not necessarily present on the mainboard. External ports The positions of the external ports are shown ...

Internal ports and connectors A26361-D1961-Z120-1-7419, edition 2 English - 9 Internal ports and connectors The positions of the internal ports and connectors are shown on the Cover. Additional information on some ports is also provided here. Hard disk connection An ultra ATA/66 or ultra ATA/100 har...

Internal ports and connectors 10 - English A26361-D1961-Z120-1-7419, edition 2 Using external audio connections 123 Analogue 2-channel audio output With the 2-channel configuration the functions Line-Out, Line-In and MIC are available. 1 = Line-In (blue) 2 = Line-Out (front channels, green) 3 = MIC ...

Pin assignment of internal ports A26361-D1961-Z120-1-7419, edition 2 English - 11 Pin assignment of internal ports The pin assignment of some internal connections is shown in English in the following. i Some of the following connectors may be optional! Front panel Watch the poling of the LEDs. The p...

Pin assignment of internal ports 12 - English A26361-D1961-Z120-1-7419, edition 2 Audio front panel 1 2 Pin Signal Pin Signal 1 Micro input 2 Analogue GND 3 Micro bias 4 Analogue VCC 5 Right line output 6 Right line return 7 not connected 8 Key 9 Left line output 10 Left line return If the audio fro...

Pin assignment of internal ports A26361-D1961-Z120-1-7419, edition 2 English - 13 Floppy interface 1 Pin Signal Pin Signal 1 GND 18 Step DIR (low asserted) 2 FDHDIN (low asserted) 19 GND 3 GND 20 Step Pulse (low asserted) 4 not connected 21 GND 5 Key 22 Write Data (low asserted) 6 not connected 23 G...

Pin assignment of internal ports 14 - English A26361-D1961-Z120-1-7419, edition 2 ATA interface 1 2 Pin Signal Pin Signal 1 Reset drive (low asserted) 2 GND 3 Data 7 (high asserted) 4 Data 8 (high asserted) 5 Data 6 (high asserted) 6 Data 9 (high asserted) 7 Data 5 (high asserted) 8 Data 10 (high as...

Pin assignment of internal ports A26361-D1961-Z120-1-7419, edition 2 English - 15 Power supply BTX (ATX compatible) 1 13 Pin Signal Pin Signal 1 +3.3 V (P3V3P) 13 +3.3 V (P3V3P) 2 +3.3 V (P3V3P) 14 -12 V (P12VN) 3 GND 15 GND 4 +5V (VCC) 16 PS on (low asserted) 5 GND 17 GND 6 +5V (VCC) 18 GND 7 GND 1...

16 - English A26361-D1961-Z120-1-7419, edition 2 Settings with switches and jumpers Setting via control-panel plug connector A C 12 12 B 12 Pin pair A inserted = Skipping system and BIOS Setup password Pin pair B inserted = System BIOS recovery Pin pair C inserted = factory setting i Please pay atte...

A26361-D1961-Z120-1-7419, edition 2 English - 17 Add-on modules / Upgrading ! Exit energy-saving mode, switch off the system and remove the power plug from the mains outlet, before carrying out any of the procedures described in this chapter! Even when you have run down the device, parts of the devi...

Replacing the processor A26361-D1961-Z120-1-7419, edition 2 English - 19 Mounting heat sink Be sure to use heat conducting material between the processor and the heat sink. If a heat conducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you must apply a very t...

Upgrading main memory 20 - English A26361-D1961-Z120-1-7419, edition 2 Upgrading main memory Technical data Technology: DDR 333 or DDR 400 unbuffered DIMM modules 184-Pin; 2.5 V; 64 Bit, without ECC Size: 128 Mbyte to 2 Gbyte 333 DDR-SDRAM 128 Mbyte to 2 Gbyte 400 DDR-SDRAM Granularity: 128, 256, 51...

Upgrading AGP screen controllers A26361-D1961-Z120-1-7419, edition 2 English - 21 Removing a memory module 1 1 ► Push the clips on the right and left of the memory slot outward (1). ► Pull the memory module out of the memory slot (2). Upgrading AGP screen controllers Technical data The AGP slot supp...

Adding PCI cards 22 - English A26361-D1961-Z120-1-7419, edition 2 PCI bus interrupts - Selecting correct PCI slot i To achieve optimum stability, performance and compatibility, avoid the multiple use of ISA IRQs or PCI IRQ Lines (IRQ sharing). Should IRQ sharing be unavoidable, then all involved dev...

Replacing the lithium battery A26361-D1961-Z120-1-7419, edition 2 English - 23 Replacing the lithium battery In order to permanently save the system information, a lithium battery is installed to provide the CMOS-memory with a current. A corresponding error message notifies the user when the charge ...

BIOS update 24 - English A26361-D1961-Z120-1-7419, edition 2 BIOS update When should a BIOS update be carried out? Fujitsu Siemens Computers makes new BIOS versions available to ensure compatibility to new operating systems, new software or new hardware. In addition, new BIOS functions can also be i...

BIOS Recovery - Recovering System BIOS A26361-D1961-Z120-1-7419, edition 2 English - 25 BIOS Recovery - Recovering System BIOS i All BIOS settings are reset to the default values. ► Open the casing as described in the operating manual. ► Set the switch for "Restore system BIOS" to ON . ► Clo...

Microcode Update 26 - English A26361-D1961-Z120-1-7419, edition 2 Microcode Update What is a microcode update? As there are no drivers for processors, Intel offers the possibility from the P6 family (Pentium Pro) on to update the command set (microcode) of the processor. This enables minor errors to...

28 - English A26361-D1961-Z120-1-7419, edition 2 Annex Electrical Properties Loadability for connections and fuses i Make sure that the connected devices do not overload the connections. Fuse no. Fuse Connection Maximum loadability 1 750 mA Keyboard port Not specified Mouse port Not specified Gamepo...

APM and ACPI system status, energy-saving modes A26361-D1961-Z120-1-7419, edition 2 English - 29 APM and ACPI system status, energy-saving modes System status ACPI Status ) 1 APM Status Power LED I ) 2 Power LED II ) 3 Power consump tion Wake-up time Normal operation G0 S0 On On/Off On Normal Simple...

Mainboard Revision and BIOS Version 30 - English A26361-D1961-Z120-1-7419, edition 2 Mainboard Revision and BIOS Version The compatibility, e.g. with new processors, can be independent of the BIOS version or the revision status of the mainboard used. Mainboard Revision The revision status of the mai...

A26361-D1961-Z120-1-7419, edition 2 English - 31 Error messages This chapter contains error messages generated by the mainboard. Available CPUs do not support the same bus frequency - System halted! Memory type mixing detected Non Fujitsu Siemens Memory Module detected - Warranty void There are more...

A26361-D1961-Z120-1-7419, edition 2 English - 35 Glossary The technical terms and abbreviations given below represent only a selection of the full list of common technical terms and abbreviations. Not all technical terms and abbreviations listed here are valid for the described mainboard. ACPI Advan...