Fujitsu D1561 - Manual

List of features A26361-D1562-Z120-2-6319 English - 3 List of features Onboard features D1562-A D1561-A Chipset Intel 865 G Intel 865 G Board size µATX µATX VGA ü ü Audio / 6-channel / S/PDIF 5.1 ü / - / ü ü / - / ü Buzzer / int. Speaker Support - / ü - / ü LAN / Gigabit LAN / with Alert-on-LAN /Ale...

List of features 4 - English A26361-D1562-Z120-2-6319 Internal ports (continued) D1562-A D1561-A SMBus Connector * ( Case Temperature ) 1 - Intrusion Connector* (Case Open) 1 - Power Connectors ATX / ATX12V / AGP PRO 1 / 1 / - 1 / 1 / - External ports D1562-A D1561-A VGA 1 1 Audio Line in / Line out...

A26361-D1562-Z120-2-6319 English - 6 Brief instructions on installing mainboard If you have purchased a separate mainboard, you can install the mainboard in your system inaccordance with the following brief instructions. The activities described here assume a basic knowledge of PCs and cannot be car...

Brief instructions on installing mainboard A26361-D1562-Z120-2-6319 English - 7 Ê Should no suitable connection field beprovided in the case, then you mustinstall the connection field (1) provided. Ensure the plate is aligned properly so thatthe connections are suitable for themainboard later. Ê Set...

8 - English A26361-D1562-Z120-2-6319 Interfaces and connectors The positions of the interfaces and connectors are shown on page "Cover". The components and connectors marked are not necessarily present on the mainboard. External ports The positions of the external ports are shown on page ...

Internal ports and connectors A26361-D1562-Z120-2-6319 English - 9 Graphics port - Supported screen resolutions Depending on the operating system used, the screen resolutions in the following table refer to themainboard screen controller. If you are using an external screen controller, you will find...

Pin assignment of internal ports 10 - English A26361-D1562-Z120-2-6319 Pin assignment of internal ports The pin assignment of some internal connections is shown in English in the following. i Some of the following connectors may be optional! Front panel Watch the poling of the LEDs. The positive pol...

Pin assignment of internal ports A26361-D1562-Z120-2-6319 English - 11 Pin Signal Pin Signal 1 GND 2 Transmit data positive 3 Transmit data negative 4 GND 5 Receive data negative 6 Receive data positive 7 GND 8 Key ATA interface 1 2 Pin Signal Pin Signal 1 Reset drive (low asserted) 2 GND 3 Data 7 (...

Pin assignment of internal ports 12 - English A26361-D1562-Z120-2-6319 Audio S/PDIF 1 Pin Signal 1 VCC 2 SPDIF out 3 GND CD audio input 1 Pin Signal 1 Left CD audio input 2 CD GND 3 CD GND 4 Right CD audio input AUX audio in 1 Pin Signal 1 Left AUX audio input 2 Analogue GND 3 Analogue GND 4 Right A...

Pin assignment of internal ports A26361-D1562-Z120-2-6319 English - 15 Serial port 2 1 2 Pin Signal Pin Signal 1 DCD 2 2 DSR 2 3 SIN 2 4 RTS2 5 SOUT 2 6 CTS 2 7 DTR 2 8 RI 2 9 GND Fan 1 (processor fan - only for 3 pin fans) 1 Pin Signal 1 GND 2 Controlled FAN voltage (0V, +6V, ... +12V, max. 1A) or ...

Pin assignment of internal ports 16 - English A26361-D1562-Z120-2-6319 Power supply ATX 1 11 Pin Signal Pin Signal 1 +3.3V(P3V3P) 11 +3.3V(P3V3P) 2 +3.3V(P3V3P) 12 -12V (P12VN) 3 GND 13 GND 4 +5V (VCC) 14 PS on (low asserted) 5 GND 15 GND 6 +5V (VCC) 16 GND 7 GND 17 GND 8 Powergood (high asserted) 1...

Pin assignment of internal ports A26361-D1562-Z120-2-6319 English - 17 Settings with switches and jumpers Your mainboard is equipped with switches or jumpers. The positions of the switches or jumpers areshown on page "Cover". 1 2 3 4 O N Switch 1 = Skipping system and BIOS SetuppasswordSwitc...

18 - English A26361-D1562-Z120-2-6319 Add-on modules / Upgrading ! Exit energy-saving mode, switch off the system and remove the power plug from themains outlet, before carrying out any of the procedures described in this chapter!Even when you have switched off the device, parts (e.g. memory modules...

Replacing processor A26361-D1562-Z120-2-6319 English - 19 Mounting heat sink Be sure to use heat conducting material between the processor and the heat sink. If a heatconducting pad (rubber-like foil) is already applied to the heat sink, then use it. Otherwise you mustapply a very thin layer of heat...

Upgrading main memory 20 - English A26361-D1562-Z120-2-6319 Upgrading main memory Technical data Technology: DDR 266, DDR 333 or DDR 400 unbuffered DIMM modules184-Pin; 2.5 V; 64 Bit, no ECC Size: 128 Mbytes up to 4 Gbyte DDR 266 SDRAM128 Mbytes up to Gbyte DDR 333 SDRAM128 Mbytes up to Gbyte DDR 40...

Upgrading AGP screen controllers 22 - English A26361-D1562-Z120-2-6319 Upgrading AGP screen controllers Technical data: The AGP slot supports the modes 4x/8x with 32 bits and 66 MHz. Only 1.5 V AGP graphics cardsare supported. i Some older 3.3 V AGP graphics cards are coded like 1.5 V AGP graphics c...

Adding PCI cards A26361-D1562-Z120-2-6319 English - 23 Controller or slot INT Mechanical slot Onboard controller 1 2 3 4 USB 1,1 AC97 PCI slot PCIInterruptLine 1 st 2 nd 3 rd 4 th US B 2, 0 SMB u s A udio Modem LA N AGP 1 2 3 1 (A) X - - X - - - - - A - - - 2 (B) - - - - - X X X - B - - - 3 (C) - - ...

Adding PCI cards 24 - English A26361-D1562-Z120-2-6319 Replacing the lithium battery In order to permanently save the system information, a lithium battery is installed to provide theCMOS-memory with a current. A corresponding error message notifies the user when the charge istoo low or the battery ...

BIOS update A26361-D1562-Z120-2-6319 English - 25 BIOS update When should a BIOS update be carried out? Fujitsu Siemens Computers makes new BIOS versions available to ensure compatibility to newoperating systems, new software or new hardware. In addition, new BIOS functions can also beintegrated. A ...

Microcode Update 26 - English A26361-D1562-Z120-2-6319 Ê Set the switch for "Restore system BIOS" to OFF . Ê Close the casing as described in the operating manual. Ê Remove the floppy disk from the drive. Ê Start the PC and invoke BIOS Setup . Ê Select the menu item Reset Configuration in th...

Drivers A26361-D1562-Z120-2-6319 English - 27 Microcode update under DOS with bootable microcode update floppy disk - brief description Ê Download the update file from out website to your PC. Ê Insert an empty floppy disk (1.44 MB). Ê Run the update file under DOS (e.g. 1495101.EXE ). Ê A bootable u...

28 - English A26361-D1562-Z120-2-6319 Annex Electrical Properties Loadability for connections and fuses i Make sure that the connected devices do not overload the connections. Fuse no. Fuse Connection Maximum loadability - - Fan1, Fan2 1000 mA each 1 750 mA Keyboard Not specified Mouse Not specified...

APM and ACPI system status, energy-saving modes A26361-D1562-Z120-2-6319 English - 29 APM and ACPI system status, energy-saving modes System status ACPI Status ) 1 APM Status Power LED I ) 2 Power LED II ) 3 Sleep LED Power consum ption Wake-up time Normal operation G0 S0 On On/Off On Off Normal Sim...

Mainboard Revision and BIOS Version 30 - English A26361-D1562-Z120-2-6319 Mainboard Revision and BIOS Version The compatibility, e.g. with new processors, can be independent of the BIOS version or the revisionstatus of the mainboard used. The CPU and BIOS compatibility lists are available on the Int...

A26361-D1562-Z120-2-6319 English - 31 Error messages This chapter contains error messages generated by the mainboard. Available CPUs do not support the same bus frequency - System halted!Memory type mixing detectedNon Fujitsu Siemens Memory Module detected - Warranty voidThere are more than 32 32 RD...

A26361-D1562-Z120-2-6319 English - 35 Glossary The technical terms and abbreviations given below represent only a selection of the full list ofcommon technical terms and abbreviations.Not all technical terms and abbreviations listed here are valid for the described mainboard. ACPI Advanced Configura...