Page 7 - Contents
A26361-D1419-Z120-1-7419 Contents Introduction........................................................................................................................................ 1 Notational conventions ...............................................................................................
Page 9 - Introduction; Notational conventions; Text in this bold typeface; Important notes
A26361-D1419-Z120-1-7419 English - 1 Introduction This technical manual describes the mainboard D1419, which can be equipped with up to two Intelprocessors. You will find further information in the "BIOS Setup" description. Further information about drivers is provided in the readme files on...
Page 10 - Information about boards
Important notes 2 - English A26361-D1419-Z120-1-7419 The shipped version of this board complies with the requirements of the EECdirective 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installa...
Page 11 - Features
Features A26361-D1419-Z120-1-7419 English - 3 Features • ServerWorks GC LE533 chipset • two processor sockets for Prestonia or Nocona processors with 2.2 GHz and higher,socket 604, with 133 MHz Front Side Bus and quad pumped data bus • 512 Kbyte second level cache • 6 slots for main memory. PC2100 m...
Page 12 - Interfaces and connectors
Features 4 - English A26361-D1419-Z120-1-7419 Interfaces and connectors 1 2 3 4 5 6 7 8 9 10 11 12 14 15 16 17 19 22 13 23 20 21 1 = Floppy disk drive (TX300) 2 = Floppy disk drive (RX300) 3 = Power supply ATX 4 = PC98 5 = Power supply 12 V 6 = Fan connector for CPU 0 7 = Fan connector for CPU 1 8 =...
Page 13 - External ports; Temperature / System monitoring; Temperature monitoring:
Features A26361-D1419-Z120-1-7419 English - 5 External ports 1 2 3 4 5 6 7 8 1 = PS/2 mouse port 2 = Serial port COM2 3 = Parallel port LPT 4 = LAN connector 5 = VGA port 6 = USB ports (2x) 7 = Serial port COM1 8 = PS/2 keyboard port The components and connectors marked are not necessarily present o...
Page 14 - LAN connector; Device
Features 6 - English A26361-D1419-Z120-1-7419 LAN connector This mainboard has a BCM5703C from Broadcom. This LAN controller supports the transfer rates of10 Mbit/s, 100 Mbit/s and 1 Gbit/s. The LAN controller is equipped with a 512 byte transmission andreceiving buffer (FIFO) and supports WOL funct...
Page 15 - PCI bus resources; PCI slots; PCI slot; PCI IRQ line x - Assignment of the PCI interrupts
Features A26361-D1419-Z120-1-7419 English - 7 PCI bus resources PCI slots The following table shows an overview of the PCI slots: PCI slot 64bit/32b it Frequency in MHz PCIX Description 1 64 bit 100/133 yes 64 bit PCI bus slot 2 64 bit 100 yes 64 bit PCI bus slot 3 64 bit 100 yes 64 bit PCI bus slot...
Page 16 - Screen resolution
Features 8 - English A26361-D1419-Z120-1-7419 A B C D Slot 1 PCI IRQ line 4 PCI IRQ line 5 PCI IRQ line 6 PCI IRQ line 7 Slot 2 PCI IRQ line 6 PCI IRQ line 7 PCI IRQ line 4 PCI IRQ line 5 Slot 3 PCI IRQ line 8 PCI IRQ line 9 PCI IRQ line 10 PCI IRQ line 11 Slot 4 PCI IRQ line 12 PCI IRQ line 13 PCI ...
Page 17 - SCSI/Host RAID configuration utility; Working with the keyboard; Starting the SCSI/Host RAID configuration program; Terminating the SCSI/Host RAID configuration program
Features A26361-D1419-Z120-1-7419 English - 9 SCSI/Host RAID configuration utility The BIOS of the onboard U320 SCSI controller includes a menu-driven SCSI/Host RAIDconfiguration program. This program allows you to change almost all of the option settings of theSCSI controller. When you boot the sys...
Page 18 - Activating and Configuring Host RAID; Host RAID
Features 10 - English A26361-D1419-Z120-1-7419 Ê To quit the Configuration program press the [ESC] key until a corresponding message is displayed . Select Yes to quit. Activating and Configuring Host RAID To configure Host RAID select the menu entry Configure/View Host RAID Settings . If this entry ...
Page 19 - enabled
Features A26361-D1419-Z120-1-7419 English - 11 Default Settings in the menu Configure/View SCSI Controller Settings SCSI Bus Interface Definitions Default setting SCSI Controller ID 7 SCSI Controller Parity Enabled SCSI Controller Termination Enabled Additional Options Default setting Boot Device Co...
Page 20 - SCSI Bus Interface Definitions; Additional Options
Features 12 - English A26361-D1419-Z120-1-7419 SCSI Bus Interface Definitions SCSI Controller ID All SCSI devices on one SCSI bus, including the SCSI controller, must be set to separate SCSIaddresses. The SCSI controller is normally set to ID 7. You do not normally need to change the SCSI address, n...
Page 21 - SCSI Device Configuration
Features A26361-D1419-Z120-1-7419 English - 13 SCSI Device Configuration Sync Transfer Rate Fast SCSI devices, including the U320-SCSI controller, are capable of transferring data to and fromthe SCSI bus at speeds ranging up to 320 Mbyte/s at synchronous data transfer. The configurable maximum data ...
Page 22 - Include in BIOS Scan; Advanced Configuration Options; Reset SCSI Bus at IC Initialization; Extended Int 13 Translation for DOS Drives > 1Gbyte; FDISK; POST Display Mode
Features 14 - English A26361-D1419-Z120-1-7419 Include in BIOS Scan With this setting it can be determined for every SCSI address on this SCSI bus, whether the SCSIBIOS while initializating checks or not that a SCSI device with this special address is connected tothe bus. The default setting is Yes ...
Page 23 - SCSI Controller Int 13 Support; Domain Validation; SCSI Disk Utilities; Verify
Features A26361-D1419-Z120-1-7419 English - 15 SCSI Controller Int 13 Support The default setting for the Int 13 SCSI controller's support is Enabled . With this the SCSI controller´s BIOS is enabled. If you are only running SCSI devices , from which you don't want to boot and if you need space for ...
Page 24 - Settings with switches; Recovering System BIOS - switch 1
Settings with switches 16 - English A26361-D1419-Z120-1-7419 Settings with switches 1 2 3 4 ON i Preset for switches 1 to 4 = Off . The clock frequency of the processor is set automatically. Recovering System BIOS - switch 1 Switch 1 enables recovery of the old system BIOS after an attempt to update...
Page 26 - Slot sequence
Add-on modules 18 - English A26361-D1419-Z120-1-7419 LEDs Normal operation Another operating mode Heartbeat LED (flashes):"BMC is activated"(indicates that thesystem monitoringfunction is active) flashing on/off: BMC is not working LED L1 (yellow):"Auxiliary voltage“ on off: no auxiliary...
Page 27 - Installing the processor with heat sink and fan; Mounting heat sink
Add-on modules A26361-D1419-Z120-1-7419 English - 19 Installing the processor with heat sink and fan Ê Remove the heat sink including the fan fixed upon it. 3 4 Ê Push the lever in the direction of the arrow (1) and lift it as far as it will go. Ê Remove the old processor from the socket (2). Ê Inse...
Page 28 - Upgrading main memory
Add-on modules 20 - English A26361-D1419-Z120-1-7419 11 1 1 1 When using a new heat sink: Ê Remove the protection cover from theunderside of the heat sink. When using the previous heat sink: Ê Completely remove the old residues of theheat conducting paste. Ê Apply an even coat of heat conducting pas...
Page 29 - Installing a memory module; Removing a memory module
Add-on modules A26361-D1419-Z120-1-7419 English - 21 Installing a memory module 2 2 Ê Push the holders on each side of the memory slot outwards. Ê Insert the memory module in the slot while folding the side holders up until the memory moduleengages (2). Removing a memory module 1 1 Ê Push the clips ...
Page 30 - Replacing lithium battery
Add-on modules 22 - English A26361-D1419-Z120-1-7419 Replacing lithium battery In order to permanently save the system information, a lithium battery is installed to provide theCMOS-memory with a current. A corresponding error message notifies the user when the charge istoo low or the battery is emp...
Page 31 - Glossary
Glossary A26361-D1419-Z120-1-7419 English - 23 Glossary The technical terms and abbreviations given below represent only a selection of the full list ofcommon technical terms and abbreviations.Not all technical terms and abbreviations listed here are valid for the described mainboard. ACPI Advanced ...
