Page 2 - Fi-4110CU Image Scanner Operator’s Guide; FOR SAFE OPERATION; Treatment of This Manual; Adjust or relocate the receiving antenna.; Changes or modifications not expressly approved by the; The length of the power cord must be 3 meters (10 feet) or less.
Fi-4110CU Image Scanner Operator’s Guide FOR SAFE OPERATION Treatment of This Manual Since this manual contains important information for using the fi-4110CU, read it thoroughly beforeusing the product. Use the fi-4110CU only after thoroughly reading and understanding especially thesection "Impo...
Page 3 - Bescheinigung des Herstellers/Importeurs; Hiermit wird bescheinigt, daß der/dieldas
fi-4110CU Image Scanner Operator’s Guide i Notice toCanadian Users This digital apparatus does not exceed the class B limits for radio noiseemissions from digital apparatus set out in the Radio InterferenceRegulations of the Canadian Department of Communications. This class B digital apparatus compl...
Page 4 - Warning; FUJITSU LIMITED
ii fi-4110CU Image Scanner Operator’s Guide Warning : This equipment may cause electromagnetic interference. It has not been tested to show compliance with AS3548 Class A equipment, which is designed to provide reasonable protection againstsuch interference. Operation of this equipment in a resident...
Page 5 - fi-4110CU Image Scanner Operator’s Guide; Preface
fi-4110CU Image Scanner Operator’s Guide i Preface Thank you very much for your purchase of the fi-4110CU Image Scanner. The fi-4110CU Image Scanner can read very fine color images. As this manual explains the basic handling of the scanner, read it carefully to use thescanner properly. In this manua...
Page 6 - Important Notes to Users
ii fi-4110CU Image Scanner Operator’s Guide Important Notes to Users Every user is requested to use this product including the manuals and software suppliedwith the product at the user's own responsibility. Fujitsu assumes no liability with respect to any damage or loss caused to data as theresult o...
Page 7 - Contents; Notes Concerning Installation
fi-4110CU Image Scanner Operator’s Guide iii Contents CHAPTER 1 Notes Concerning Use ..................................................................... 1-1 1.1 Outline ........................................................................................................... 1-1 1.1.1 fi-4110CU I...
Page 8 - APPENDIX
vi fi-4110CU Image Scanner Operator’s Guide 4.4 Consumables and Regular Replacement Components .................................. 4-6 4.4.1 Parts Number and Replacement Cycle of Consumables andRegular Replacement Components ............................................................. 4-6 4.4.2 Proc...
Page 9 - CHAPTER; Notes Concerning Use; Confirming the Content of Packing Box
fi-4110CU Image Scanner Operator’s Guide 1-1 CHAPTER 1 Notes Concerning Use This section provides an outline of the product and explains its characteristics andcomponents. 1.1 Outline This section provides an outline of the fi-4110CU Image Scanner and explains itscharacteristics. 1.1.1 fi-4110CU Ima...
Page 10 - Component Names and Functions
1-2 fi-4110CU Image Scanner Operator’s Guide 1.3 Component Names and Functions This section shows the components of the scanner and explains their functions. Automatic document feeder Stacker Copy density dial Operator panel Document guide Document support Front Function No. display panel Function b...
Page 13 - Installation and Connection; Notes concerning Installation
fi-4110CU Image Scanner Operator’s Guide 2-1 CHAPTER 2 Installation and Connection This section explains how to install the image scanner and connect it to a personalcomputer. See Appendix A, “Installation Specifications,” for the external dimensions of theimage scanner. 2.1 Notes concerning Install...
Page 14 - Mounting the Document Support; Key
2-2 fi-4110CU Image Scanner Operator’s Guide 2.2 Mounting the Document Support Follow the procedure below to mount the stacker and document support. 1) Hold the document support and insert it into the hole on the lower part of thescanner until it stops. 2) Hold the document support and insert its ta...
Page 17 - Note; Installing the Device Driver and Software
fi-4110CU Image Scanner Operator’s Guide 2-5 2.3.4 Connecting to the Computer This section explains how to connect the scanner to the computer. Connect the scanner as follows: 1) Connect the type B connector of the interface cable (accessory of this scanner) tothe scanner until it clicks. 2) Connect...
Page 18 - Setting up the Stacker and Document Support; Hold the tab of the stacker and pull.
2-6 fi-4110CU Image Scanner Operator’s Guide 2.4 Setting up the Stacker and Document Support Raise the Paper Extension of the document support and pull out the stacker accordingto the document size as follows: 1) Hold the tab of the stacker and pull. Tab Stacker B 2) Insert a finger into the dent at...
Page 20 - Operation; Notes concerning Operation; When operating the equipment, adhere to the following points:
fi-4110CU Image Scanner Operator’s Guide 3-1 CHAPTER 3 Operation Set a document on the document support and read it by automatic document feeder. This section provides notes concerning operation, and explains how to read eachdocument. 3.1 Notes concerning Operation When operating the equipment, adhe...
Page 21 - Before Scanning or Copying a Document
3-2 fi-4110CU Image Scanner Operator’s Guide Fire, electrical shock, or fault - Do not allow liquids and items such ascoffee or metal clips to get into theequipment. - Do not put water on the equipment or get itwet with water. - If foreign matter such as water, metal clips,or liquid gets into the eq...
Page 24 - Scanning Documents
fi-4110CU Image Scanner Operator’s Guide 3-5 A B C ABC Base side Set the documents (Read side of last page) 3.3 Scanning Documents This section explains how to scan documents. 1) Make sure that the powers of the personal computer and the scannerare ON. 2) Check the document condition. For details, s...
Page 26 - Daily Maintenance; Handling a Paper Jam; Remove the document from the document support.; Remove the jammed document.
fi-4110CU Image Scanner Operator’s Guide 4-1 CHAPTER 4 Daily Maintenance This section explains how to perform paper jam handling, daily maintenance, andcleaning. u Key point Clean the automatic document feeder based on the standard cleaning proceduredescribed in Section 4.3.2, "Cleaning the Auto...
Page 27 - Daily Maintenance; Especially, be sure to clean the automatic document feeder.
4-2 fi-4110CU Image Scanner Operator’s Guide 4) Restore the automatic document feeder into position by pushing its center. After restoring the automatic document feederinto position, make sure that it is closedcompletely. If the automatic document feederis not properly closed, a paper jam or reading...
Page 28 - Cleaning the Surface of the Scanner and the Document Support; Key point; Cleaning the Automatic Document Feeder; When you use the above documents, clean the ADF as a routine work.
fi-4110CU Image Scanner Operator’s Guide 4-3 4.3 Cleaning This section explains how to clean the image scanner. Fire or electrical shock - When cleaning the equipment, turn off thepower, and then disconnect the interfacecable and disconnect the AC adapter powerplug from the outlet. 4.3.1 Cleaning th...
Page 30 - Parts to be Cleaned on the Automatic Document Feeder; Restore the automatic document feeder into position.
fi-4110CU Image Scanner Operator’s Guide 4-5 Parts to be Cleaned on the Automatic Document Feeder 3) Restore the automatic document feeder into position. After restoring the automatic document feederinto position, make sure that it is closedcompletely. If the automatic document feederis not properly...
Page 31 - Consumables and Regular Replacement Components; Replacement Components; Procedure for Replacing the Pad Unit
4-6 fi-4110CU Image Scanner Operator’s Guide 4.4 Consumables and Regular Replacement Components Fire or electrical shock - When replacing any of the equipment'sconsumables , first turn off the power , thendisconnect the interface cable anddisconnect the AC adapter power plug fromthe outlet. Be aware...
Page 32 - Procedure for Replacing the Pick Roller Unit; Replace the pick roller unit through the following procedure:
fi-4110CU Image Scanner Operator’s Guide 4-7 a b Step 1 Pick arm Pad unit Step 2 Pad 4) When mounting a new pad unit, push the pick arm downward with one hand whilemounting the pad unit with the other hand. Pad unit Pad Check that the pad unit is mounted completely.If the pad unit is not mounted cor...
Page 34 - When you suspect that a fault occurred; Problem
fi-4110CU Image Scanner Operator’s Guide 5-1 CHAPTER 5 When you suspect that a fault occurred When you suspect a fault occurred while using the image scanner, check the itemslisted below. Problem Item to be Checked Correction Is the AC adapter connectedcorrectly? Connect the AC adapter correctly. Po...
Page 36 - Installation Specifications
fi-4110CU Image Scanner Operator’s Guide A-1 APPENDIX A Installation Specifications The table below lists the installation specifications of the equipment. Item Specification Width Depth Height External dimensions (mm) 308.5 154 130 Weight (kg) 2.5 Voltage 100 V to 240 V Number of phases Single Inpu...
