Fujitsu AIR CONDITIONER - Manual

En-5 : See page ► 10 ► 6 • 7 • 12 ► 10 ► ► 12 ► 11 ► 12 ► 7 ► 7 ► 7 ► 9 ► 9 ► 6 ► 6 ► 6 • 13~19 ► 7 ► 12 MIN. HEAT button POWERFUL button TEMP. button Signal Transmitter START/STOP button MODE button FAN button SWING button ECONOMY button OUTDOOR UNIT LOW NOISE button SET button CLOCK ADJUST button ...

En-6 PREPARATION CAUTION ● Take care to prevent infants from acciden- tally swallowing batteries. ● When not using the Remote Controller for an extended period, remove the batteries to avoid possible leakage and damage to the unit. ● If leaking battery fl uid comes in contact with your skin, eyes, o...

En-7 To Start Operation Press the START/STOP button . The indoor unit’s OPERATION Indicator Lamp (green) will light. The air conditioner will start operating. To Select Mode Operation Press the MODE button to select the desired mode. Each time the button is pressed, the mode will change in the follo...

En-8 About AUTO CHANGEOVER Operation AUTO: ● When AUTO CHANGEOVER operation fi rst selected, the fan will operate at very low speed for about a few minutes, during which time the indoor unit detects the room conditions and selects the proper operation mode. Room temperature is higher than the de fi ...

En-9 Vertical Air Direction Adjustment Press the SET button . Each time the button is pressed, the air direction range will change as follows: 1 2 3 4 5 6 7 Types of Air fl ow Direction Setting: 1, 2, 3 : During Cooling/Dry4, 5, 6, 7 : During Heating The Remote Controller's display does not change. ...

En-10 This program automatically controls the temperature setting when there is no one in the room for a while, and prevents electricity from being wasted. To enable the ENERGY SAVING ENERGY SAVING is set at the time of purchase. Press the SENSOR button . “ ” on the remote controller will be display...

En-11 ECONOMY OPERATION Begin Air Conditioner operation before performing this procedure. To Use the ECONOMY Operation Press the ECONOMY button . The ECONOMY indicator Lamp (green) will light.ECONOMY operation begins. To Stop the ECONOMY Operation Press the ECONOMY button again. The ECONOMY Indicato...

En-12 MANUAL AUTO OPERATION Use the MANUAL AUTO operation in the event the Remote Controller is lost or when the battery runs out. How To Use the Main Unit Controls Press the MANUAL AUTO button more than 3 seconds and less than 10 seconds on indicator. To stop operation, press the MANUAL AUTO button...

En-13 ON/OFF TIMER OPERATION 1 Press the TIMER SETTING button . At the beginning, “ ” will be fl ashing, so press the SELECT button to select either “ ” or “ ” within “ ”. Press the NEXT button . 2 Press the SELECT button to set the desired On time or OFF timer. 3 Press the SEND button . In the case...

En-14 PROGRAM TIMER OPERATION 1 Press the TIMER SETTING button . At the beginning, “ ” will be fl ashing, so press the SELECT button to select “ ” within “ ”. Press the NEXT button . 2 Press the SELECT button to set the desired ON time .   Press the NEXT button . 3 Press the SELECT button to set the...

En-15 SLEEP TIMER OPERATION About the SLEEP timer To prevent excessive warming or cooling during sleep, the SLEEP timer function automatically modi fi es the temperature setting in accordance with the set time setting. When the set time has elapsed, the air conditioner completely stops. During Cooli...

En-16 WEEKLY TIMER OPERATION The “OFF Timer” at which the operation will be stopped and the “ON Timer” at which the operation will be started can be combined, and up to 4 reservations (program ) can be applied for one day, and 28 reservations for a week. Before creating the program, please adjust th...

En-20 CLEANING AND CARE CAUTION ● Before cleaning the indoor unit, be sure to turn it off and disconnect the electrical breaker and so on. ● Be sure the Intake Grille is installed securely. ● When removing or replacing the air fi lters, be sure not to touch the heat exchanger, as personal injury may...

En-22 In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the electrical breaker and consult authorized service personnel.Merely turning off the unit’s power switch will not completely disconnect the unit from the power source. Always be sure to turn off the ele...

En-23 Symptom Items to check See Page CHECK ONCE MORE Doesn’t operate at all: ● Has the circuit breaker been turn off? ● Has there been a power failure? ● Has a fuse blown out, or a circuit breaker been tripped? — ● Is the intake grille completely closed? 20 ● Is the timer operating? 13 - 19 Poor Co...