Page 3 - Please retain this manual for future reference.; DANGER AND WARNINGS; You Must Read This Owner’s Guide Before Operating Your Gas Grill.; DANGER
User Guide for models: PRO-C, PRO-S, PRO-SNG Please retain this manual for future reference. DANGER AND WARNINGS You Must Read This Owner’s Guide Before Operating Your Gas Grill. DANGER 1. If you smell gas: 2. Shut off gas to the appliance. 3. Extinguish any open flames. 4. Open lid. 5. If odor cont...
Page 7 - For Installation In Canada; • Details of 20lb LP cylinder
• Do not use with charcoal fuel. • The areas around the LP cylinder must be free and clear from debris. • If it’s evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the outdoor cooking appliance being put into operation. Replacement pressure regulators and ...
Page 8 - Storage And / Or Non Use; and the LP cylinder stored outdoors in a well-ventilated space.; Operating
Storage And / Or Non Use • The gas must be turned off at the liquid propane cylinder when the gas barbecue is not in use. • When the gas barbecue is stored indoors, the gas supply must be DISCONNECTED and the LP cylinder stored outdoors in a well-ventilated space. • LP cylinder must be stored outdoo...
Page 9 - Product View
Product View Lid Assembly Warming Rack Cast Iron Grate Diffuser Panel Control Knob Residue Tray Side Handles (2) Ignition Box Front & Rear Panel Wheel Base Casters (4)
Page 10 - Exploded View
Page 12 - Installation; Parts Included
Installation Parts Included Tools Needed (Not Included) Lid Handle Control Knob Tank Hook x1 M6 Screws x8 (B) M5 Screws x8 (A) Phillips Head Screw Driver Temperature Gauge AA Battery Utility Knife / Box Cutter M6 Step Screw x2 (C) M6 Wing Nut x2 (D) ø6.5 Washer x2 (E) ø6.5 Lock Washer x2 (F) Door Cl...
Page 13 - Step 1
Quick Set-up Guide Step 1 A: Fasten rear panel grill base with four screws (M5) B: Assemble tank hook to marked label with two screws (M6) C: Assemble door clasp to rear panel with two screws (M6)” *Note: Install all screws loose before tightening any screw completely.
Page 14 - Step 2; Insert the AA battery into the battery pack with the + end facing the
Step 2 Insert the control knob onto the control valve. Insert the AA battery into the battery pack with the + end facing the battery pack cap.
Page 15 - Step 3
Step 3 Place control assembly upside down on the floor or low flat surface. Place assembled rear door and grill base onto the control assembly with four screws (M5)
*Note: Install all screws loose before tightening any screw completely. (A) x4 (M5)
Page 16 - Step 4
Step 4 A. Slide support spine onto control assembly. B. Insert support spine to firebox support top. C. Fasten two screws (M6) to grill base. (B) D. Now the grill can be flipped onto its wheels. (B) x2 (M6)
Page 17 - Step 5; depress top spring-hinge and release once aligned into position.
Step 5 Install front panel: insert bottom hinge first, then use your finger to depress top spring-hinge and release once aligned into position.
Page 18 - washer and washer in the order shown in the drawing below.
Step 6 A. Install the temperature gauge into the cooking lid. B. Install the lid handle onto the lid. Be sure to use both the locking washer and washer in the order shown in the drawing below. x2 (D) x2 (E) x2 (F)
Page 19 - Step 7
Step 7 A. Place diffuser panel, cast iron grate, and grill lid in place. Please note that the grill grate should be positioned with the “FACE DOWN” writing as the bottom side of the grate. B. Insert the residue tray shield into the residue tray and slide residue tray into place in the space between ...
Page 20 - Step 8; and lower hinge sections with use of the M6 Step Screws.
Step 8 Install the lid onto the firebowl assembly and screw together the upper and lower hinge sections with use of the M6 Step Screws. (C) x2 (M6 Step) C C
Page 21 - Step 9; the correct orientation of the legs on the warming rack.
Step 9 Install the warming rack into the lid and firebowl assembly. Please note the correct orientation of the legs on the warming rack.
Page 23 - hook) and connect the LP gas hose with regulator assembly to the LP
Step 11 Gas hook up (LP gas is Standard). Open the front door, install a standard 20lb LP cylinder (Type 1) into the opening of the grill base (Note: the tank must be hanging from the tank hook) and connect the LP gas hose with regulator assembly to the LP cylinder. Proper procedures for gas leakage...
Page 24 - Lighting Instruction Manual
Lighting Instruction Manual Warning : Before Lighting, please make sure that the control knob is in the off position and the regulator assembly is in good condition. Control Knob. IMPORTANT Do not leave items on or against the barbecue. Keep flammable product and sprays away. For outdoor use only. S...
Page 25 - DUAL ZONE BURNERS
Cooking with Zone 1 The outer burner can be turned on to cook the food through indirect cooking. Place the food in the center of the grill. Turn the control knob to “O”. Since the food is not being exposed to direct heat from the burners it will cook more evenly and be less likely to burn on the exp...
Page 26 - LP Gas Hook-Up for Type 1 or QCC1 Regulator
LP Gas Hook-Up for Type 1 or QCC1 Regulator LP Tank Requirements: A dented or rusted LP tank may be hazardous and should be checked by your local supplier. Never use a cylinder with a damaged valve. The cylinder used must include a collar to protect the cylinder valve. Always check for leaks after e...
Page 27 - Leak Testing
Leak Testing To Test: Make sure all control valves are in the “OFF” position. Turn the gas supply “ON”. Check all connections from the supply line, or LP cylinder up to and including the manifold pipe assembly. Apply the soap solution around the connection, valve, tubing and end of the manifold. Soa...
Page 28 - Maintenance
Maintenance WARNING: IMPORTANT! Before lighting, inspect the gas supply piping or hose prior to turning the gas “on”. If there is evidence of cuts, wear or abrasion, it must be replaced prior to use. Grill Burner: Remove grill lid, diffuser panel, grate, and burner. Remove the screws holding burner ...
Page 32 - Limited Warranty Information:
Limited Warranty Information: Fuego Living LLC (“Seller”) and the person or entity that acquires these goods from Seller (“Purchaser”) hereby agree to the following terms and conditions of the sale: Shipping fees are the responsibility of the Purchaser whether freight prepaid or freight collect. Sel...