Fisher-Price H5988 - Manual
Fisher-Price H5988 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; All Shown Actual Size; Tighten or loosen all screws with a; Parts; Please remove all parts from the package and; CAUTION
- Page 3 – You may need the help of another adult to help you balance; Assembly
- Page 4 – • Set the frame assembly aside.; CORRECT
- Page 5 – Look at opening in the straight end of the tube. It should be round.; Look at opening in the straight end of the tube. It should be oval.
- Page 6 – outside
- Page 7 – “snap”
- Page 8 – • From under the seat, fit the elastic loops onto the tabs; • From behind the seat, fit the pad elastic loops to the tabs on
- Page 9 – • Fit the toybar hubs to the seat tubes.; Assembly is now complete.; • Fit and; the tray onto the seat armrests.
- Page 10 – Swing; alkaline; We recommend using; Battery Installation
- Page 11 – • Do not mix old and new batteries or batteries of different; Before each use, inspect this product for damaged
- Page 12 – Setup and Use; Make sure you; As with most battery-powered swings, a heavier child will reduce; TIGHTEN; Securing your Infant
- Page 13 – • Lift or lower the seat wire into the grooves on the seat back.; Adjusting the Seat; • Slide the lights switch to
- Page 14 – If sounds or lights slow or dim or turn off altogether, it’s time; Parent Activated
- Page 15 – Storage; • The pad, frame and toy bar may be wiped clean using a mild; Care; • Remove the four pad elastic loops from the seat back and; • Press the button on each housing and push the rear legs
- Page 16 – Consumer Information
1
Product features and decorations may vary from picture above.
Instructions
Model Number: H5988
Please read these instructions before assembly and use of this product.
Adult assembly is required. Tool needed for assembly: Phillips Screwdriver (not included).
Requires four LR20 (“D”)
alkaline
batteries (not included) for swing operation.
Requires four LR6 (“AA”)
alkaline
batteries (not included ) for toybar operation.
Only to be used by children that cannot climb out of seat.
WARNING
IMPORTANT! PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
www.fisher-price.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 2 WARNING To prevent serious injury or deathfrom falls and being strangled inthe restraint system: • Always use the restraint system. Never rely on the tray to restrain child. • Never use with an active child who may be able to climb out of the seat. • Not recommended for children who can sit up b...
IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts. 3 3 1 Button Leg Housing • Place a housing on a f...
4 4 HUBS FACING OUT FRONTBASECURVESINWARD HUBS FACING IN • Check to be sure you have assembled the leg assemblies to the bases correctly. Please refer to the illustrations above.• If the leg assemblies are assembled incorrectly to the bases, simply pull the legs from the bases. Please re-read and re...
