Fanimation WR501WH - User Manual

How to Wire and Operate Your Wall Control

WR501WH Wall Control

DESCRIPTION:

3-speed ceiling fan control with light dimmer switch and canopy receiver.

ELECTRICAL SPECS:

120V, 60Hz Ceiling Fan

FAN MODELS USED:

most Fanimation fans - see catalog or visit our website, fanimation.com for
more information

SPECIFICATION and INSTRUCTION SHEET

NOTE:

If fan or supply wires are different colors than

indicated, have this unit installed by a qualified electrician.

1.

If fan and/or light kit are controlled by a pull chain, fan
must be set to high and light kit must be switched on.

2.

Install Receiver in the Hanger Bracket:

• Connect wires using connectors as shown in Figure 1.
• Position all connected wires and receiver antenna to
allow installation of ceiling canopy. (Figure 2)
• Using canopy screws threaded into the hanger bracket
reinstall ceiling canopy.
• Restore electrical power

3.

Dip Switch Set Up

(Figure 3)

WARNING

To avoid possible electrical shock, be sure electricity is

Figure 2

Figure 3

Figure 1

NOTE:

The remote unit has 32 different code

combinations. To prevent possible interference from or
to other remote units, simply change the combination
code in the remote and receiver.

NOTE: Factory setting is all up. Do not use this position.

• To set the code on receiver unit, slide dip switches to
the same positions as set on the remote.

• To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
firmly up or down to same as receiver unit.

Dip Switch

Dip Switch

AC120V 60HZ

INPUT

WHITE (AC IN N)

BLACK (AC IN L)

BLUE

BLACK

WHITE

BLUE(FOR LIGHT)

BLACK(TO MOTOR L)

WHITE(TO MOTOR N)

BLACK

(ANTENNA)

WHITE

(AC IN N )

BLACK
(AC IN L)

BLACK

(TO MOTOR L)

WHITE

(TO MOTOR N)

BLUE

(FOR LIGHT)

BLACK (AC IN L)

BLACK

BLACK

BLACK (TO MOTOR L)

BLACK (AC IN L)

GROUND WIRE

GREEN / YELLOW