Page 2 - Precautions; Safety Instructions • English
Precautions This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipment. This symbol is intended to alert the user of the presence of uninsulated dangerous voltage within the product’s enclosure that may pres...
Page 3 - 安全须知; 注意; 声明; FCC Class A Notice
Precautions 安全须知 • 中文 这个符号提示用户该设备用户手册中有重要的操作和维护说明。 这个符号警告用户该设备机壳内有暴 露的危险电压，有触电危险。 注意 阅读说明书 • 用 户 使 用 该 设 备 前 必 须 阅 读 并 理 解 所 有 安 全 和 使 用 说 明 。 保存说明书 • 用户应保存安全说明书以备将来使 用。 遵守警告 • 用户应遵守产品和用户指南上的所有安 全和操作说明。 避免追加 • 不要使用该产品厂商没有推荐的工具或 追加设备，以避免危险。 警告 电源 • 该 设 备 只 能 使 用 产 品 上 标 明 的 电 源 。 设 备 必 须 使 用 有 地 线 的 ...
Page 5 - MTPT U R Series • Table of Contents; Table of Contents
MTPT U R Series • Table of Contents About this Manual ................................................................... 2 About the MTP Universal Receivers ............................... 2 TP cable advantages ................................................................. 4Transmission distance...
Page 6 - MTP U R Series • Introduction; About this Manual; Introduction; Figure 1 — MTP U R series features
MTP U R Series • Introduction About this Manual This manual details the installation and operation of the Extron MTP U R series of mini twisted pair universal receivers. • MTP U R RSA SEQ mini twisted pair receiver with RS-232, audio, and skew equalization • MTP U R RS SEQ mini twisted pair receiver...
Page 8 - TP cable advantages; Video; It is possible to exceed the recommended distance
Introduction, cont’d MTP U R Series • Introduction TP cable advantages Twisted pair cable is much smaller, lighter, more flexible, and less expensive than coaxial cable. These TP products make cable runs simpler and less cumbersome and termination with RJ-45 connectors is simple, quick, and economic...
Page 9 - Receiver Jumpers; Setting JMP1 for RS-232 communication; Figure 3 — Setting jumper 1 to uni-directional
MTP U R Series • Introduction 5 JMP1 JMP3 JMP2 Default settings asviewed from rear N The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free A/V cable terminated in accordance with the TIA/EIA T 568 A wiring standard. CAT 5 cables are acceptable but less prefera...
Page 10 - Setting the jumpers to positive vertical and/or; Figure 4 — Inverting sync with jumpers 2 and 3; Transmitter Jumper
Introduction, cont’d MTP U R Series • Introduction 6 6 . If applicable, reinstall the receiver and reconnect all cables. N Jumper 1 should be set to uni-directional when an MTP DA is installed as part of the system to avoid any RS-232 /Audio detection issues. When an MTP U R series receiver is used ...
Page 11 - Figure 5 — MTP U R and MTPX switcher; Application Diagrams; Source; MTP U R; Figure 6 — MTP U R and SW4 MTP T 15HD A switcher; Figure 7 — MTP U R and Xpoint 450 switcher
MTP U R Series • Introduction UTP UTP MTP U R RSA SEQ Vid S-Video YUVRGB RS-232 Audio Vid S-Video YUV RGB RS-232 Audio Plasma/LCD MTP U R RSA SEQ Projector UTP UTP UTP UTP Source MTP Transmitters MTPX Matrix Switcher MTP U R Receivers Display Devices MTP T SV A MTP T AV MTP T 15HD RS Control System ...
Page 12 - MTP U R Series • Installation; Installation; UL guidelines for rack mounted devices; Elevated operating ambient temperature; Rack mounting
MTP U R Series • Installation Installation Installation C Installation and service must be performed by authorized personnel only. The 1U high, quarter rack width, MTP U R receiver can be mounted on a rack shelf, to a rack without a shelf, under a desk or tabletop, or on a projector bracket. UL guid...
Page 13 - • RSU 129, Standard universal 1U rack shelf kit; Figure 8 — Mounting the MTP on a VersaTools shelf
MTP U R Series • Installation 9 • RSU 129, Standard universal 1U rack shelf kit (part # 60-190-01 ) • RSB 129, Basic universal 1U rack shelf (part # 60-604-02 ) On the standard rack shelf, the MTP U R mounts in one of four locations to the rear of the rack or in one of four locations to the front of...
Page 14 - Fxtron recommends where more than one shelf is; Back of the rack mounting; Figure 10 — Attaching the back of the rack kit
MTP U R Series • Installation Installation, cont’d 10 N Fxtron recommends where more than one shelf is required, rack mount shelves are installed at least 1U apart, to allow for air flow and proper cooling between the shelves. 3 . Install false faceplate(s) or other unit(s) to the rack shelf. 4. Mou...
Page 15 - Rear; Figure 11 — Typical back of the rack installations; Furniture or projector mounting; ON; Figure 12 — Desk and projector mounting the MTPs
MTP U R Series • Installation 11 MAV SER IES AV MA TRIX SWITCH ER I/O AUD AUD IO S ETU P PRE SET VID IR +dB- dB ENT ER 2 7 6 5 2 4 1 INPU TS OUT PUT S 8 3 1 8 6 5 4 3 7 M T P S E R IE S Rear Front Figure 11 — Typical back of the rack installations Furniture or projector mounting Use the optional mou...
Page 17 - Connections and Settings; Rear panel connectors and features for the MTP U R series of; Figure 13 — Receivers’ rear panel features
MTP U R Series • Installation 13 Connections and Settings Rear panel connectors and features for the MTP U R series of receivers are shown below. INPUT 1 RGB POWER 12V 0.5A MAX L MONO AUDIO R VID Y/C B-Y Y R-Y OUTPUTS RS-232 Tx Rx SPARE INPUT 1 POWER 12V 0.5A MAX RGB VID Y/C OUTPUTS M T P U R A L MO...
Page 18 - Do not
MTP U R Series • Installation Installation, cont’d 14 a Power connector — Plug the included external 12 VDC power supply into this 2-pole captive screw connector. See “Power supply wiring” to wire the connector. b Input 1 connector — Connect one end of the cable from the transmitter. See “TP cable t...
Page 19 - RS-232 connector —; Connect a serial communications port to; Figure 14 — Pin assignments for RS-232 wiring; Audio connector (MTP U R RSA SEQ and MTP U R A models; Connect a suitable audio device to this 5-pole captive; Unbalanced Output; Figure 15 — Audio connector wiring
MTP U R Series • Installation 15 g RS-232 connector — Connect a serial communications port to this 3.5 mm, 5-pole captive screw connector for bidirectional RS-232 communication. Wire the connector as shown below. Ground Tx Rx Gnd Receive Transmit Connected RS-232 Device Pins MTP Pins Spare Spare Fig...
Page 20 - Power supply wiring; Wire the supplied male power connector (plug) as in figure 16.; Figure 16 — Power connector wiring
MTP U R Series • Installation Installation, cont’d 16 Power supply wiring N This product is intended to be supplied by a UL Listed power supply and output rated at 12 VDC, 2A. Wire the supplied male power connector (plug) as in figure 16. Power Supply Output Cord Captive Screw Connector SECTION A–A ...
Page 21 - TP cable termination; Figure 17 — TP cable termination; Pin; Figure 18 — MTP pin assignments
MTP U R Series • Installation 17 TP cable termination N RJ-45 termination must comply with TIA/EIA T 568A or TIA/EIA T 568B wiring standards for all connections. Figure 17 details the recommended termination of TP cables with RJ-45 connectors in accordance with the TIA/EIA T 568A or TIA/EIA T 568B w...
Page 22 - Front Panel Controls and Indicators; Front panel features on the MTP U R receivers are shown below.; Figure 19 — MTP U R series front panels
MTP U R Series • Installation Installation, cont’d 18 Front Panel Controls and Indicators Front panel features on the MTP U R receivers are shown below. RGB DELAY PEAKING LEVEL MTP U R RSA SEQ R G B SELECT ADJUST SIGNAL AUDIORS-232 VID Y/CYUV RGB RGB DELAY PEAKING LEVEL MTP U R RS SEQ R G B SELECT A...
Page 23 - Power LED —
MTP U R Series • Installation 19 a Power LED — Indicates power is applied to the MTP. b Signal LEDs — The appropriate LED lights when its signal type is present and auto-detected. The signal types indicated are either composite video, Y/C, YUV, or RGB. c Select button (SEQ models only) — This recess...
Page 24 - Audio LED (MTP U R RSA SEQ models only) —; Peaking and Level Adjustment; green
MTP U R Series • Installation Installation, cont’d 20 The maximum setting (at the clockwise limit) provides 100% peaking. Adjust this control while viewing the displayed image to obtain the optimum picture sharpness. See “Peaking and Level Adjustment” section below for details. N To avoid possible v...
Page 25 - Skew Delay Compensation; SEQ receiver skew compensation; cannot
MTP U R Series • Installation 21 N Since this product differs from the standard MTP receiver by its ability to auto detect the video format received, based on the video signal quality, it requires a reasonable adjusted signal for both level and peaking. There is some margin for over peaking, but if ...
Page 26 - 0 ns of delay may be necessary before a change in the; Non-SEQ receivers skew compensation
MTP U R Series • Installation 22 Installation, cont’d N A 2-nanosecond (ns) adjustment is very fine. Up to 10 ns of delay may be necessary before a change in the display is detectable. Maximum delay possible is 62 nanoseconds. c . Use a Tweeker or other small screwdriver to press the Select button o...
Page 27 - MTP U R Series • Specifications; Specifications
Specifications MTP U R Series • Specifications 23 Specifications Video Gain ................................................ Unity Video input Number/signal type ..................... 1 set of proprietary analog signalsConnectors .................................... 1 female RJ-45 Video output Numbe...
Page 28 - Specifications, cont’d; level; Audio input — MTP U R RSA SEQ, MTP U R A — See MTP; pole captive screw connector
MTP U R Series • Specifications Specifications, cont’d 24 THD + Noise ................................. 0.15% @ 1 kHz, 0.3% @ 20 kHz at nominal level S/N ................................................. >70 dB at maximum output (unweighted) Audio input — MTP U R RSA SEQ, MTP U R A — See MTP Seri...
Page 29 - Serial control pin configurations . Captive screw connectors:; General; Specifications are subject to change without notice.
MTP U R Series • Specifications 25 N Protocol is mirrored between the transmitter and the receiver. Serial control pin configurations . Captive screw connectors: 1 = TX, 2 = RX, 3 = GND General External power supply ................. 100 VAC to 240 VAC, 50/60 Hz, external, autoswitchable; to 12 VDC,...
Page 30 - MTP receivers; Enhanced Skew-FreeTM A/V UTP cables are not
MTP U R Series • Specifications Specifications, cont’d Part Numbers MTP receivers Receiver Part number MTP U R RSA SEQ receiver 60-869-01 MTP U R RS SEQ receiver 60-869-02 MTP U R A receiver 60-869-03 MTP U R RS receiver 60-869-04 Accessories Accessories Part number P/S 123 Multiple output 12 V powe...
Page 31 - Extron’s Warranty; and Central America:; will begin the repair process as quickly as possible.
Extron’s Warranty Extron Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/or materials, Extron Electronics will,...
