EverFocus EHD360 - Manual
EverFocus EHD360 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – and in an IP66; Mounting; OVERVIEW; Color dome camera with SONY 1/3” Super HAD CCD sensor.; PACKAGE CONTENTS
- Page 5 – save the plug as it will be used to close the rear conduit hole.; Conduit plug
- Page 6 – General Connection and Setup; reverse polarity will damage the camera and void the warranty).; If you move the camera module; , it is necessary to loosen the dome and liner and; Lens adjustment
- Page 7 – EverFocus Electronics Corp.; Shangdi Information Industry Base,
EVERFOCUS
High Resolution Vandal Proof
Weather Resistant 3-Axis IR Dome Camera
Operation Instructions
Model No.
EHD360
Please read this manual first for correct installation and operation. This manual should be retained
for future reference. The information in this manual was current when published. The
manufacturer reserves the right to revise and improve its products. All specifications are therefore
subject to change without notice.
PRECAUTIONS
1.
Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers
and audio speakers since the electromagnetic fields generated from these devices may distort
the video image or otherwise interfere with camera operation.
2.
Never disassemble the camera beyond the recommendations in this manual nor
introduce materials other than those recommended herein.
Improper disassembly or introduction of corrosive materials may result in equipment failure
or other damage.
3.
Try to avoid facing the camera toward the sun.
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or
internal circuits, as well as creating unbalanced illumination beyond the capability of the
camera to compensate.
4.
Keep the power cord away from water and other liquids and never touch the power
cord with wet hands.
Touching a wet power cord with your hands or touching the power cord with wet hands may
result in electric shock.
5.
Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.
6.
Cleaning
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with
the hands. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor and
the camera lens. Use a damp soft cloth to remove any dirt from the camera body. Please do
not use complex solvents, corrosive or abrasive agents for cleaning of any part of the camera.
7.
Do not operate the camera beyond the specified temperature, humidity or power source
ratings. This camera is suitable for indoor and outdoor operation.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
1 Use the camera at temperatures within -10°C to +50°C (14°F to 122°F) and in an IP66 compliant environment; this device is not rated as submersible. The input power source is 12VDC. Be sure to connect the proper + / - polarity and voltage, as incorrect polarity or too high a voltage will likely cau...
4 3. Tighten the 4 mounting screws to secure the camera body to the mounting surface. 3. If you need to wire cable through side conduit hole, use a coin to remove the conduit plug ; save the plug as it will be used to close the rear conduit hole. 4. Disconnect the power and video wire from the camer...
5 6. (Optional) Pass the power/video wire under the base plate and up through the center hole. 7. Position the power/video wire so that it does not interfere with the camera module and carefully attach the connector to the camera board, being sure to position the connector so it fit properly onto th...
