Evenflo Triumph User Manual - Free PDF Download

Page 2 - CANADIAN REGULATORY NOTICE; Symbol Legend; Airbag Symbol – Alerts you to important; INTERACTIVE PDF; Important Information

3 2 More children are killed every year as passengers in car crashes than by any other type of injury. To reduce the risk of SERIOUS INJURY or DEATH, read this owner’s manual and your vehicle owner’s manual before installing and using this child restraint. Using a child restraint makes a big differe...

Page 3 - Before using this child restraint for preterm or low birth; PREMATURE INFANT USE; Important; CHILD REQUIREMENTS; Warning: Failure to follow these Child Requirements could; IMPORTANT: Once your child exceeds any of the; MUST

5 4 TOC Before using this child restraint for preterm or low birth weight infants, ensure the Child Requirements are met and follow the guidelines in this section. According to the U.S. National Highway Traffic Safety Administration, a properly installed child restraint reduces the risk of death by ...

Page 4 - Air Bag Warning; Vehicles built prior to the 2002 model year:; The forward facing back seat is the; General Warnings; rear-facing and forward-facing use of this child; Location Warnings; Children have STRANGLED; WARNING

7 6 TOC Air Bag Warning • DO NOT use this child restraint in the front seat of a vehicle equipped with an air bag, unless the air bag has been deactivated. Interaction between a rear-facing restraint and air bags may cause serious injury or death. Air bags may cause serious injury or death to childr...

Page 5 - Location Warnings – continued; Forward-facing Only Warnings; seat where the child restraint is to be installed,; Seat Belt Warnings

9 8 TOC Location Warnings – continued Rear-facing and Forward-facing Use for a tight installation. If the child restraint cannot be properly installed, DO NOT use the child restraint. Consult vehicle owner’s manual, try a different seating location, or call Evenflo for further assistance. • ONLY use...

Page 6 - LATCH Warnings; Tethers for Children) is a system for attaching the child; Tether Strap Warnings; Forward-facing Use Only; Additional Warnings

11 10 TOC LATCH Warnings Rear-facing and Forward-facing Use • DO NOT use the lower anchors of the child restraint anchorage system (LATCH system) to attach this child restraint when restraining a child weighing more than 22.7 kg (50 lbs) with the internal harnesses of the child restraint. • The LATC...

Page 7 - Safe Practices; Everyone rides buckled up or the vehicle does; Public Notice for Canadian Customers; When used with the internal; Motor Vehicle/Aircraft Usage; ip; store the instructions on; For future reference, record the model number of your; Storing Your Instructions

13 12 TOC Safe Practices • Everyone rides buckled up or the vehicle does not go. Make no exceptions for adults or children. If someone unbuckles, stop the vehicle. Being firm and consistent from the start will mean fewer discipline problems as children get older. An unrestrained person can be thrown...

Page 8 - Consult your vehicle; Visual Glossary

15 14 TOC 12 0 4 A I R B A G 20 30 10 Front Seat Lap and Shoulder Belts Front Seat Retractor Front Headrests Your vehicle components may be significantly different than pictured. Consult your owner’s manual to help you identify your vehicle components. Back Seat Belt Buckles Center Lap Belt Tether A...

Page 9 - Front; Child Restraint Features; Description

17 16 TOC buckle storage buckle storage Front Back * Not all features are available on all models. Styles may vary. Child Restraint Features Child Restraint Features Description 1 8 12 11 23 4 5 9 10 7 13 6 14 15 16 17 Important 1. Adjustable Headrest* 2. Harness Tabs 3. Harness Straps 4. Buckle Ton...

Page 10 - Secure child restraint to the vehicle seat.; Using the Child Restraint; DO NOT; Rear-facing Installation Checklist

19 18 TOC 1. Secure child restraint to the vehicle seat.  Child restraint is in Position #1 (page 20).  Install with vehicle seat belt (page 20) or lower anchor connector assembly (page 24).  Install locking clip, if necessary (page 22).  Towel rolled up and placed beneath the base, if necessary...

Page 11 - Infants; NEVER; Rear-facing Installation with Seat Belt; If the vehicle seat belts are not routed and

21 20 TOC A Position #1 B Infants MUST always ride facing the rear of the vehicle. The back of the child restraint supports and protects the baby and absorbs crash forces. NEVER turn a child restraint forward-facing with an infant weighing less than 10 kg (22 lb.). Crash forces may cause serious inj...

Page 12 - The seat belt must be; Install Locking Clip (not

23 22 TOC Check your work. Make certain the belts are tight. If you can move the child restraint more than 25 mm (1 in.) side to side or front to back at the rear-facing belt path C , the vehicle belt is not tight enough. If you have not tightly secured the child restraint, try again, move it to ano...

Page 13 - Know Your Lower Anchor; SecureRightTM

25 24 TOC SecureRight™ Quick Connector™ Rear-facing Installation with Lower Anchor Connectors Remove both lower anchor connector hooks A or clips B from the storage clips on the base C . 1 A C 2 Remove the lower anchor connector assembly E from the forward-facing position (back openings). Remove the...

Page 14 - DOUBLE CHECK; Correct

27 26 TOC Using your full weight, push the child restraint firmly into the vehicle seat while pulling up on the lower anchor connector assembly strap to tighten. 7 H IMPORTANT: Make sure both lower anchor Quick Connectors are facing upward and the straps are not twisted. 5 After the lower anchor con...

Page 15 - Forward-facing Installation Checklist; For

29 28 TOC 1. Secure child restraint to the vehicle seat.  Child restraint is in Position #2 or #3 (page 30).  Child restraint base sits flat on vehicle seat.  Install with vehicle seat belt (page 30) or lower anchor connector assembly (page 36).  Install tether strap (page 34 or 40).  Install l...

Page 16 - Forward-facing Installation with Seat Belt; Lap and Shoulder

31 30 TOC The child must weigh 10 to 22.7 kg (22 - 50 lb.). 1 Forward-facing Installation with Seat Belt A Adjust the recline to Positions #2 or #3 by lifting the back of the seat slightly while pulling the ReclineRight lever A . Intermediate Recline Position (Position #2) Full Upright Position (Pos...

Page 17 - The vehicle seat belt

33 32 TOC D 8 The vehicle seat belt must be as tight as possible. Using your full weight, push the child restraint firmly into the vehicle seat as you tighten the vehicle belt C . C D 7 • If vehicle seat belts are not routed and fastened correctly, the child restraint may not protect your child in a...

Page 18 - • To avoid a strangulation hazard, you; This page is intentionally blank.; Note: Refer to your vehicle owner’s manual for the

35 34 TOC Connect the tether hook E to the vehicle tether anchor F behind the vehicle seat, as shown. (Please consult your vehicle owner’s manual, as tether anchor locations may vary.) Pull the strap G and tighten the tether securely. • To avoid a strangulation hazard, you MUST tightly roll or fold ...

Page 19 - Remove two lower anchor connector hooks

37 36 TOC Forward-facing Installation with Lower Anchor Connectors LATCH is a system for attaching the child restraint to your vehicle seat. It is to be used in place of your vehicle’s seat belts, and can be used in vehicles with LATCH anchors. Your vehicle owner’s manual may refer to this system as...

Page 20 - are facing upward and the straps are not twisted.

39 38 TOC Remove the lower anchor connector strap E from the rear-facing position (front openings). 3 E 4 Insert the ends of the lower anchor connector strap E in the forward-facing belt path openings, as shown (back openings). Note: Make sure the adjustment buckle F enters the opening on the correc...

Page 21 - The baby’s back and; Securing Your Child in the Child Restraint; General

41 40 TOC Connect the tether hook I to the vehicle tether anchor J behind the vehicle seat, as • To avoid a strangulation hazard, you MUST tightly roll or fold excess tether strap and secure with the strap/rubber band. • Attach the tether hook to the storage clip when not in use. This will keep an u...

Page 22 - NOT; Adjusting the Crotch Strap; As your child grows, you will need to change the crotch; Rear Position

43 42 TOC D buckle storage buckle storage E buckle storage buckle storage buckle storage buckle storage Insert both buckle tongues A into the buckle C . Pull up on the harness strap to check that the buckle tongues are fastened. Fasten the chest clip E by snapping the two halves together, as shown. ...

Page 23 - Removing Child from the Restraint; Removing the Lower Anchor; Not available on all

45 44 TOC buckle storage buckle storage SecureRight™ Quick Connector™ D C buckle storage buckle storage 1 Removing Child from the Restraint buckle storage buckle storage Press the red buckle release B , and remove the buckle tongues. 2 3 Press the adjuster release button A to loosen harness strap. W...

Page 24 - Removing the Seat Pad; Removing the Tether Strap

47 46 TOC buckle storage buckle storage You will need to remove your seat pad for cleaning. 1 Removing the Seat Pad Carefully remove the seat pad B from around each cup holder C .* Unbuckle harness straps and disconnect chest clip. Starting at the bottom of the seat, unfasten all seat pad hooks A . ...

Page 25 - Installing the Seat Pad

49 48 TOC buckle storage buckle storage Push BeltTrac access flap B behind harness straps and bring buckle assembly through the seat pad, as shown. buckle storage buckle storage Installing the Seat Pad 1 4 Open the BeltTrac access flap and remove the seat pad B from the seat shell. B Place seat pad ...

Page 26 - Removing the Adjustable Headrest

51 50 TOC Installing the AccessoriesThe Body Pillow and Infant Head Support For about the first three months, a baby’s head needs extra support. The optional Infant Head Support D should lie flat against the seat back, as shown. Be sure to cut off the plastic attachment between the head support and ...

Page 28 - Installing Child Restraint; IMPORTANT: Before installing the child restraint,; Secure your Child in the Child Restraint

55 54 TOC The aircraft seat belt A must be as tight as possible. Route the excess seat belt strap F back through the rear-facing belt path D opening, as shown above. Using your full weight, push the child restraint firmly onto the aircraft seat while pulling on the excess seat belt strap to tighten....

Page 29 - Note: Because of the fixed length of aircraft seat belts, the; Care and Cleaning

57 56 TOC The aircraft seat belt must be as tight as possible. Route the excess aircraft seat belt strap E back through the forward-facing belt path D opening, as shown above. Using your full weight, push the child restraint firmly onto the aircraft seat while pulling on the excess seat belt strap t...

Page 30 - To order replacement parts you can order on-line at; Replacement Parts; bk; Limited Warranty; Proper Disposal of this Child Restraint; To prevent injury due to hidden damage, lost instructions,

59 58 TOC To order replacement parts you can order on-line at www.evenflo.com or contact Evenflo. When you contact us, please have the product model number and date of manufacture (found on the back of the child restraint). Replacement Parts Locking Clip: Not included with child restraint, see page ...