Euro Appliances ECT60WCX - User Manual

Page 2 - Warning; General Safety

This manual explains the proper installation and use of your appliance, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. In case of failure, only the Authorize d Technical Service may repair this hob. Oth...

Page 3 - Safety Instructions; Safety When Installation

2 Children’s Safety ⚫ The cooking zones will become hot when you cook. Therefore, always keep small children away from the appliance. ⚫ The appliance is not intended for use by young children or infirm persons without supervision. ⚫ Young children should be supervised to ensure that they do not play...

Page 5 - Product Description; Enamel; Pan support; Burner

4 Product Description No. Model Burner* FSD Pan supports Knob position Total gas consuption Over view 1 ECT600GS 1W+2SR+1A With Enamel Front LPG: 27.5MJ/h NG: 26.0MJ/h 2 ECT60WCX 1W+2SR+1A With Cast iron Front LPG: 30.5MJ/h NG: 29.5MJ/h 3 ECT60GS 1R+2SR+1A With Cast iron Right LPG: 30.5MJ/h NG: 29.5...

Page 7 - Installation; When you have installed the hob, make sure that; Cupboard Cutting; Bench top thickness, 30

6 Installation Before Installation: ⚫ Before cutting into any bench tops, ensure the minimum clearances to walls, adjacent surfaces and overhead surfaces required by the relevant gas appliance installation code (see above) will comply. Dimensions are specified in millimeters (mm) Overhead cupboards ...

Page 8 - Electrical Connection; practice applicable.

7 2. Place Burner Box Apply the adhesive sealing tape to the underside lip of the burner box. Shown at G opposite. Place burner box into cutout hole and fit clamping brackets to clamp the hotplate to the bench. 3. Fit Burners And Trivet. Replace burners and ensure they are correctly repositioned ove...

Page 9 - Wiring diagram; For Universal LPG: see page 9; SETTING THE GAS PRESSURE:

8 After having installed the hotplate, the GPO must always be in an accessible position. ECT60WCX , ECT600GS, ECT60GX ECT900GX Wiring diagram 4. Gas Connection Install in accordance with relevant gas standards and/or codes of practice applicable. Connect the elbow fitting to the appliance gas manifo...

Page 11 - ADJUSTING THE BURNER MINIMUM FLAME HEIGHT:; from Natural gas to Universal LPG or vice versa.; For model ECT60WCX

10 ADJUSTING THE BURNER MINIMUM FLAME HEIGHT: NOTE: This adjustment can only be performed by the installer or an authorised service personnel. The minimum burner flame is factory adjusted for the gas type stated on the gas type label adjacent to the gas connection and should not require adjustment. ...

Page 12 - Start Using Your Appliance; Description

11 Start Using Your Appliance ECT60WCX ， ECT600GS ， ECT60GX ECT900GX Description Explanation Zone indicators These show which zone is under control. Flame power Flame power of the zones, is the lowest and is the highest. The hotplates are fitted with mains powered electronic spark ignitors, so must ...

Page 14 - Maintenance & Troubleshooting; STAINLESS STEEL

13 Maintenance & Troubleshooting Cleaning and maintenance should be carried out with the appliance cold especially when cleaning the enameled parts. Avoid leaving alkaline or acid substances(lemon juice, vinegar etc.) on the surfaces. STAINLESS STEEL The stainless steel hob of the hotplate must ...

Page 15 - TROUBLESHOOTING; DO NOT MODIFY THIS APPLIANCE.; Excessively yellow or sooting flame type.

14 TROUBLESHOOTING Servicing of the hotplates must only be done by an authorised service representative, and the hotplate must not be modified. Power must be disconnected before any servicing or maintenance is conducted. DO NOT MODIFY THIS APPLIANCE. It is recommended the hotplate serviced by an aut...

Euro Appliances ECT60WCX - User Manual

Table of Contents:

Summary

Other Euro Appliances Hobs Models