Ericsson TMX-8810 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS; NOTES

Copyright© October 1989, General Electric Company TABLE OF CONTENTS Page INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . 3 UNPACKING AND CHECKING EQUIPMENT . . . . . . . 3 STANDARD EQUIPMENT . . . . . . . . . . . . . . . . . . 3 OPTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . ...

Page 3 - UNPACKING AND CHECKING EQUIPMENT

(19D901983 Sh 3 Rev.3) OPTION INTERCONNECTION DIAGRAM 22 INTRODUCTION This manual contains installation instructions for the TMX-8825 and TMX-8810 Mobile Radios and associated accessories. Included are mountinginstructions, for connecting the ignition cable assemblies and suggested cableroutings. In...

Page 4 - NOTE; INTERCONNECTION DIAGRAM

Option LS1E (LS01) - External Speaker (Dash Mount) 19C850550G6(requires Option CC08) Option SU1C (SU01) - External Alarm (Horn) Relay 19A705499P1 (requires Option CC08) and SU02) Option SU1F (SU02) - External Alarm ON/OFF Switch 19C851585P7(requires Option SU01) Option MA1L (MA03) - Desk Radio Mount...

Page 6 - WARNING

The accompanying illustrations should help you in your installation. PLANNING THE INSTALLATION Before starting, plan your installation carefully so that it will be: •• Safe for the operator and passengers in the vehicle. •• Safe to operate within easy reach of controls and microphone. •• Protected f...

Page 7 - SPEAKER MOUNTING BRACKET; CAUTION

5. Plug the connector into P2 of the Option Cable. EXTERNAL ALARM (HORN) RELAY OPTION SU1C(SUO1) (19A705499P1) The Alarm Relay Option requires the the use of Option Cable CC3N (CC08). External Alarm ON/OFF Switch Option SU1F (SU02) is required toallow the horn relay to be disabled when desired. The ...

Page 10 - OPTIONAL ACCESSORIES

With some accessory points, the voltage only drops when theignition switch is in the START position. A connection pointshould be used where the voltage is completely off when theignition switch is in the START position. NOTE Certain problems may be encountered when accessory equip-ment is connected ...

Page 11 - INSTALLING THE RADIO

Figure 8 - Bottom View Figure 9 - Bottom View (Cover Removed) 14 Coil up the surplus cables and secure them out of the way with the retaining strap provided. Be sure to leave some slack in the cables going to the radio sothat it may be pulled out for servicing with power applied. INSTALLING THE RADI...

Page 12 - ANTENNA

MICROPHONE CONNECTIONS Normally, the microphone is shipped connected to the microphone jack on the bottom of the radio. A cable clamp is used for strain relief and is attachedto the bottom of the radio using a M4-0.7x8 Hex Head screw. MICROPHONE BRACKET Mount the magnetic microphone bracket where it...

Page 24 - Mobile Communications; TMX; Installation Manual

Printed in U.S.A. Mobile Communications TMX   — 8825 (25W) TMX   — 8810 (10 W) LBI-38389B Installation Manual