Elo 4600L - Manual

User Manual– Interactive Digital Signage SW601176 Rev F , Page 6 of 40 Note: For your health and safety, it is strongly recommended that at least two people handle, lift, or move these touchmonitors. Handles are provided on the unit’s back for easier handling. Check that the following items are pres...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 7 of 40 Chapter 3 - Touchmonitor Installation Connector Panel & Interfaces Remove the cable cover on the bottom rear (when viewed in landscape orientation) to access the touchmonitor’s connector panel.

User Manual– Interactive Digital Signage SW601176 Rev F , Page 8 of 40 3200L 4200L / 4600L / 5500L Touchmonitor Connections 1. Connect the HDMI and/or VGA video cables between the monitor’s HDMI/VGA input connectors and your HDMI/VGA video source, respectively. Tighten the VGA cable’s screws for bes...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 11 of 40 Chapter 4 Computer Module Installation Installation Note: Disconnect AC power from the touchmonitor before installing the Computer Module. Installing the Computer Module while AC power is connected to the touchmonitor will damag...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 14 of 40 Operating System Setup Windows ® 7, Windows ® XP Operating Systems The initial setup of the operating system takes approximately 5 minutes. Additional time might be needed for different touchcomputer hardware and operating syste...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 17 of 40 Installing the Touchscreen Technology Software Drivers for Elo Computer Modules with Windows XP Visit the Elo Touch Solutions website www.elotouch.com for: • The latest touch driver versions • Additional touch driver information...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 18 of 40 Chapter 5 – Mounting Note: For your health and safety, it is strongly recommended that at least two people handle, lift, or move these touchmonitors. Two handles are provided on the unit’s back for easier handling. Note: When la...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 19 of 40 5500L: Rear VESA Mount For the 32” model: A four-hole, 400x200mm mounting pattern is provided on the rear of the monitor. The VESA FDMI-compliant mounting is coded: VESA MIS-F, 400X200, Y, 6, 90 For the 42”, 46”, and 55” models:...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 20 of 40 Optional Stand To install the optional stand: Lay the monitor face-down on a table with the bottom edge flush to the edge of the table. Mount the two “feet” from the optional stand using all of the provided screws. 3200L 4200L /...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 21 of 40 Chapter 6 – Operation Power To turn the touchmonitor on or off, press the touchmonitor power button once. To power on the Computer Module, press the touchmonitor power button once. To power off the Computer Module and touchmonit...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 23 of 40 IntelliTouch Touchscreen Technology The IntelliTouch touchscreen can be re-calibrated to your displayed video image, if needed, through the Calibration function in the Elo driver control panel. Optical Touchscreen Technology Whe...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 27 of 40 OSD and Power Lockouts Press and hold the “Menu” and “Up” buttons for two seconds to enable/disable the OSD Locking feature. When the OSD Locking is enabled, pressing any of the Menu, Up, Down, or Select keys will have no effect...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 28 of 40 Chapter 7 – Technical Support If you are experiencing trouble with your touchmonitor, refer to the following suggestions. If the problem persists, please contact your local dealer or contact Elo Touch Solutions Customer Service....

User Manual– Interactive Digital Signage SW601176 Rev F , Page 29 of 40 Chapter 8 Safety & Maintenance Safety To avoid risk of electric shock, follow all safety notices and do not disassemble the touchmonitor or Computer Module. They are not user-serviceable. The slots located on the sides and t...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 30 of 40 Care and Handling The following tips will help keep your touchmonitor functioning at an optimal level: • Disconnect the AC power cable before cleaning. • To clean the display unit cabinet, use a cloth lightly dampened with a mil...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 37 of 40 Chapter 9 - Regulatory Information I. Electrical Safety Information: Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power ...

User Manual– Interactive Digital Signage SW601176 Rev F , Page 39 of 40 Chapter 10 – Warranty Information Except as otherwise stated herein, or in an order acknowledgment delivered to Buyer, Seller warrants to Buyer that the Product shall be free of defects in materials and workmanship. The warranty...