Electrolux Wine Cooler - Manual

Electrolux Wine Cooler – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – Site Preparation; Figure 3; Figure 1
Page 3 – Wood Trim; WINE RACKS WITH WOOD TRIM; YOU CANNOT STAIN THE WOOD TRIM ONCE YOU APPLY THE
Page 4 – Installation
Page 5 – Leveling; LEVELING THE UNIT; Figures 4 and 5; Figure 5; Figure 4
Page 6 – Door Reversal; REVERSING THE DOOR; Figure 6; Figure 9

Loading the manual

Installation

INSTALLING THE WINE COOLER

Your Electrolux wine cooler has been designed for either free-standing or built-in
installation(refer to the

Built-in Installation

section of this manual for instructions).

In either case, the front grille must NOT be obstructed.

SITE PREPERATION

Position the unit on a flat, level surface, capable of supporting the entire
weight of the unit. Remember the unit will be significantly heavier once it is
fully loaded.

This unit requires a grounded and polarized 115 VAC, 60Hz, 15A circuit
(normal household current).

Avoid connecting the unit to a Ground Fault Interruptor (GFI). GFIs are prone
to nuisance tripping which will cause the unit to shut down. GFIs are generally
not used on circuits which power equipment that must run unattended for
long periods of time.

The unit must be installed according to your local codes and ordinances.

DA N G E R

A N G E R

ELECTROCUTION HAZARD!

Electrical Grounding Required. This appliance is equipped with a three prong
(grounding) polarized plug for your protection against possible shock hazards.

•

NEVER remove the round grounding prong from the plug.

•

NEVER use a two-prong grounding adapter.

•

NEVER use an extension cord to connect power to the unit.

Where a two-prong wall receptacle is encountered or a longer power cord is required,
contact a qualified electrician to have it replaced in accordance with applicable
electrical codes.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Was this manual helpful?

About this manual

Brand: Electrolux
Model: Wine Cooler
Document type: Manual
Language(s): English
Pages: 7
File size: 692.2 KB
Format: PDF

Summary

Page 2 - Site Preparation; Figure 3; Figure 1

Site Preparation 5 Position the unit to allow free air flowthrough the front grille (see Figure 3 ). 6 Wipe out inside of unit with a damp cloth. 7 Final finish of the wooden wine rack trimmust be applied at least 24 hours before re-installing the wooden rack trim into thecabinet. 8 Be sure to insta...

Page 3 - Wood Trim; WINE RACKS WITH WOOD TRIM; YOU CANNOT STAIN THE WOOD TRIM ONCE YOU APPLY THE

Wood Trim WINE RACKS WITH WOOD TRIM Your Electrolux wine cooler is equipped with a natural wood trim on the wine racksfor appearance and durability. The wood trim has been coated at the factory with aclear vinyl sealer, which will adequately protect the wood in normal usage. You have 3 options regar...

Page 4 - Installation

Wood Trim To stain for a different wood color: 1 Remove five racks with wood trim from unit, see Rack Removal/ Installation . 2 Remove screws securing wood trim to racks. 3 Apply Minwax Water-Based Wood Stain® to wood with a synthetic foambrush. Stain must penetrate approximately 3 minutes. After th...