Electrolux RM 6501 Manual - Free PDF Download

Page 3 - IF THE REFRIGERATOR FAILS

OPERATING AND INSTALLATION INSTRUCTIONSFOR ELECTROLUX REFRIGERATORS INTRODUCTION We are pleased that you have chosen this refrigeratorand hope you will derive much satisfaction from using it,but first a few well-meant words of advice: It is important to read through these instructions care-fully bef...

Page 4 - OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS CONTROLS FIG. 1The refrigerator can be run on 230-240 V, 12 V or LPgas. Changing between these modes of operation iscarried out by means of the control buttons positionedas shown in fig. 1.The energy selector (A) can be set at either "AC" (230-240 V), "DC" (12 ...

Page 6 - INSTALLATION INSTRUCTIONS; REPOSITIONING THE HINGES; Model

If the refrigerator is not cooling sufficiently, thereason may be:1. Inadequate ventilation of the cooling unit due to theintake and/or exhaust air vents being partly orcompletely blocked. 2. The evaporator is frosted up. 3. The thermostat setting is incorrect . 4. Gas pressure is incorrect - please...

Page 8 - Ventilation heights; LP GAS CONNECTION

The flue gases are dispersed through the upper ventgrille or the roof vent together with the ventilation air. The top, bottom and sides of the ventilation passageshould be insulated to prevent condensation and colddraughts. Ventilation heights Minimum ventilation heights in mm. Model Installation wi...

Page 9 - ELECTRICAL CONNECTION; WARNING- THIS APPLIANCE MUST BE EARTHED; blue: neutral; 2 V supply of reigniter and interior light

It must be of a type approved for use with continuouslyoperating bottled gas appliances, and have threadedcompression connections throughout. PUSH-ON CON-NECTIONS MUST NOT BE USED (We do not recom-mend the use of "rubber" type flexible tubing forconnecting permanently operating appliances of...

Page 10 - Push the lamp cover back in place.; TECHNICAL DATA; Recess dimensions

Interior light - bulb - change If the bulb has to be replaced, proceed as follows:1. Remove the cover from the lamp body by pushing itbackwards. 2. Remove the bulb. 3. Put in a new bulb (12 V, max. 5 W).Spare part number for bulb: 200 72 90-03. 4. Push the lamp cover back in place. TECHNICAL DATA RM...