Electrolux RM 4280 Manual - Free PDF Download

Page 2 - CONTENTS

OPERATING AND INSTALLATION INSTRUCTIONS FORELECTROLUX REFRIGERATORS INTRODUCTION We are pleased that you have chosen this refrigerator andhope you will derive much satisfaction from using it, but firsta few well-meant words of advice: It is important to read through these instructions carefullybefor...

Page 3 - OPERATING INSTRUCTIONS; Only use one source of energy at a time

OPERATING INSTRUCTIONS CONTROLS The refrigerator can be run on either 230 V, 12 V or LP gas.Changing between these modes of operation is carried outby means of the controls of the control panel shown in fig 3. Two rocker switches are used to select the electric powersupply, one for 230 V (B) and one...

Page 4 - If the refrigerator is not cold enough it may be because:

TRAVEL CATCH Make sure that the travel catch is engaged when the cara-van is on the move, (fig 1). The travel catch at the top of the door can be set in twodifferent positions. In one position the door is held tightlyshut. In the other position the door is secured ajar so thatthe refrigerator can be...

Page 5 - INSTALLATION INSTRUCTIONS; The sealed cooling system must not be opened, since

2. The evaporator is frosted up. 3. The temperature control setting is incorrect. 4. The gas pressure is incorrect - check the pressure regu- lator at the gas container. 5. The ambient temperature is too high. 6. To much food is loaded at one time. 7 . The door is not properly closed or the magnetic...

Page 6 - LP GAS CONNECTION; CAUTION! CHECK THAT THE GAS SUPPLIED TO THE

BUILDING-IN The refrigerator is intended for installation in a caravan ormotorhome, and the description relates to this application. The refrigerator must not be exposed to radiated heat fromhot objects (e.g. below a cooker without proper heat shiel-ding). Excessive heat irradiation impairs performa...

Page 7 - ELECTRICAL CONNECTION; Electrical leads must be routed and secured so that

The gas installation should only be carried out by an autho-rized gas fitter. The supply pipe should preferably be of copper. If any othermaterial is used, it must be of a type approved for use withcontinuously operating bottled- gas appliances, and havethreaded compression connections throughout. P...