Page 2 - CONTENTS; PRODUCT DESCRIPTION; CONTROL PANEL; Visit our website to:; General information and tips; Subject to change without notice.; WE’RE THINKING OF YOU
2 www.electrolux.com CONTENTS 1.1 Conditions Of Use 1.2 Child Safety 1.3 General Safety 1.4 Installation 1.5 Use 1. SAFETY INFORMATION ........................................................................................................ 4 .............................................................
Page 4 - SAFETY INFORMATION
4 www.electrolux.com SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. This appliance is intended to be used in household and similar applications such a...
Page 6 - May cause electric shock!
6 www.electrolux.com 1.3 General Safety It is dangerous to alter the specifica- tions or attempt to modify this product in any way.During high temperature wash program the door glass may get hot. Do not touch it!Make sure that small pets do not climb into the drum. To avoid this, please check inside...
Page 9 - Accessories; Plastic Caps
9 Drum Lifter (X3) Drain Pump Filter Door 2.2 Accessories To connect the drain hose on the edge of a sink. To close the holes on the rear side of the cabinet after the removal of the transit bolts. Plastic Caps Plastic Hose Guide Softener Prewash Main Wash Stainless Steel Washing Drum Drain Pump Fil...
Page 12 - Woolmark Apparel Care - Blue
12 www.electrolux.com 1) Energy Saver program with 40degC and 1200rpm is recommended for a full load of normally soiled cottons, and is the Water and Energy rating label program. Program; Temperature range 1200 rpm 1200 rpm – – Type of load and soil level Max. Spin Speed Max. Load (Dry Clothes) Cold...
Page 13 - Program Options Compatibility; Temperature Touchpad; Program
13 3.3 Program Options Compatibility 1 ) Vapour option can be combined with temperature 40 to 90 °C only. The door stays locked with the water in the drum. To continue the cycle, you must press (Start/Pause). Temperature Touchpad Press this touchpad repeatedly to increase or decrease the wash temper...
Page 14 - Time Manager; NOTE
deselect this option by pressing “Delay End” touchpad repeatedly till the display shows delay time “ ”; 14 www.electrolux.com Delay End ( ) Touchpad Time Manager This option allows you to adjust the wash time. Press this touchpad repeatedly to decrease or increase the wash time according to the soil...
Page 15 - Extra Rinse Touchpad
15 Prewash ( ) Touchpad Select this option if you wish your laundry to be pre-washed before the main wash. Use this option for heavy soil. The indicator of this option will be on. This option is recommended for people who are allergic to detergents, and in areas where the water is very soft. Press t...
Page 16 - Buzzer; To set “Child Lock” option:
16 www.electrolux.com This setting permits you to either enable or disable the buzzer at the end of the program. As an example, you might wish to disable this buzzer when you start a wash when going to bed, so that when the wash finished approximately 1 hour later, it will not disturb you through th...
Page 17 - BEFORE FIRST USE
17 3.6 Start/Pause ( ) and Add Clothes ( ) Touchpad This touchpad has 2 functions: Start/Pause ( ) 1. To interrupt a program which is running, press this touchpad to pause the machine, the Start/Pause pilot light flashes. After you have selected the desired program and options, press this touchpad t...
Page 18 - DAILY USE; Loading The Laundry; Please read “Detergents Type and; Using Detergent And; IMPORTANT
18 www.electrolux.com DAILY USE 5. Press the On/Off button to turn on the washing machine. Turn the knob to set a program. The washing machine will propose a temperature and automatically select the spin value provided for the program you have chosen. Check and remove objects (if there are any) that...
Page 21 - You must drain the water to
21 When the program is completed and the door lock indicator “ ” goes off, you can open the door. 5.10 When The Washing Program Is Completed, But There Is Water In The Drum The drum turns regularly to prevent the creases in the laundry. (Option “Rinse Hold ” is used) You must drain the water to open...
Page 22 - WASHING HINTS; Sorting The Laundry; Temp Soil level; Before Loading The; Clothes Load Quantity
22 www.electrolux.com WASHING HINTS 6. Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. 6.1 Sorting The Laundry 6.2 Temperatures 90°C Temp Soil level 60°C 50°C 40°C 30°C Co...
Page 23 - Quantity of detergent to be
23 Oil based paint : moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains : moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust : oxalic acid dissolved in ...
Page 24 - INTERNATIONAL WASH CODE SYMBOLS
24 www.electrolux.com the washload to turn grey, greasy clothes. oversudsing, inadequate rinsing. reduced washing effect, Not enough detergent causes: Too much detergent causes: you are washing a small load, large amounts of foam during washing. the laundry is lightly soiled, Use less detergent if: ...
Page 25 - CARE AND CLEANING; Do not use alcohol, solvents or; External Cleaning; To run a maintenance wash:
25 CARE AND CLEANING 8. You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine. Clean the appliance only with soap...
Page 26 - To clean the drain pump:
26 www.electrolux.com Flush it out under a tap to remove any traces of accumulated powder. Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse program w...
Page 28 - To clean the water inlet filters:
28 www.electrolux.com 8. Put the filter back into the housing with exposed section facing up. Make sure that you correctly tighten the filter to prevent leakages. 9. Close the drain pump door. Remove the water inlet hose from the water tap. Clean the filter in the inlet hose with a stiff brush. If y...
Page 29 - Emergency Drain; Frost Precautions
29 If the appliance is installed in an area where the temperature can be less than 0 °C, remove the remaining water from the inlet hose and the drain pump. Emergency Drain 8.9 Frost Precautions Disconnect the main plug from the main socket. Turn off the water tap. 1. 2. Remove the water inlet hose.3...
Page 30 - Possible Failures; TROUBLESHOOTING
30 www.electrolux.com 9.1 Possible Failures TROUBLESHOOTING 9. The door has not been closed. (Error code: ) Close the door firmly. The plug is not properly inserted into the power socket. Insert the plug into the power socket. There is no power at the socket. Please check your domestic electrical in...
Page 33 - Emergency Door Opening
33 In case of power failure or appliance failure, the appliance door remains locked. The wash program continues when power is restored. If the door remains locked in case of failure, it is possible to open it using the emergency unlock feature. Before opening the door: 9.2 Emergency Door Opening Mak...
Page 34 - Unpacking
34 www.electrolux.com TECHNICAL DATA 10. INSTALLATION 11. 11.1 Unpacking Use gloves. Remove the external film. If necessary, use a cutter. 1. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. All transit bolts and packing must b...
Page 38 - Hooked over the edge of a sink; Water Drainage; Fitting Hose Guide
38 www.electrolux.com Loosen the ring nut to angle the hose to the left or right depending on the position of your water tap. Do not place the inlet hose downwards. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. The end of the drain hose can be positioned i...
Page 39 - Electrical Connection
39 This machine is designed to operate on a 220-240 V~, single-phase, 50 Hz supply. 11.5 Electrical Connection “An incorrect power supply may void your warranty.” Check that your domestic electrical installation can take the maximum load required (2.1 kW), also taking into account any other applianc...
Page 40 - ENVIRONMENT CONCERNS
40 www.electrolux.com The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropyleneThis means that they can be recycled by disposing them properly in appropriate collection containers. To save water, energy and to help protect the enviro...
