Ei Electronics Ei100B - Manual

Ei Electronics Ei100B

Ei Electronics Ei100B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – Installing your Smoke Alarm; Looking after your Smoke Alarm; Connection and Replacement of Batteries.; EI; EI; Figure 6
  • Page 3 – Important Safeguards; Planning your Escape for when the Alarm goes off; NEVER
  • Page 4 – MUST; be given to the householder.; VOLT IONISATION; IMPORTANT NOTICE; THIS IS NORMAL
Loading the manual

A Smoke Alarm is an early warning device. Used correctly it can
give you and your family valuable extra time to escape.

Note:-

·

When the battery is first connected the Alarm may sound for
2-3 seconds - this is normal.

·

A Smoke Alarm does not prevent fires.

·

Install correctly, in the center of the ceiling if possible.

·

Test weekly.

·

Replace battery yearly or when it beeps once a minute.

·

Plan your escape route.

·

Proper protection may require more than one Smoke Alarm.

·

If you have any doubt or query about Smoke Alarms consult
the supplier or your local Fire Brigade.

·

Nuisance alarms can be quickly silenced by fanning with a
newspaper or similar to help remove smoke from the unit.

Locating your Smoke Alarm

Sufficient smoke must enter your Smoke Alarm before it will re-
spond. Your Smoke Alarm needs to be within 10 paces (23 feet)
of the fire to respond quickly. It also needs to be in a position
where its alarm can be heard throughout your home, so it can
wake you and your family in time for you all to escape. A

single

Smoke Alarm will give some protection if it is properly installed,
but most homes will require

two

or more to ensure that a reliable

early warning is given. For maximum protection you should put
individual Smoke Alarms in all the rooms where fire is most likely
to break out.

Your first Smoke Alarm should be located between the sleeping
area and the most likely sources of fire (living room or kitchen for
example). But it should not be more than 10 paces (seven me-
tres) from the door to any room where a fire might start and block
your escape from the house.

(a) Single Storey Dwelling.

If your Home is on one level (a bungalow or mobile home for ex-
ample) you should put your first Smoke Alarm in a corridor or
hallway between the sleeping and living areas. Place it as near
to the living area as possible, but make sure you can hear it
loudly enough to wake you in the bedroom. (for example, see
figure 1)

If your bungalow is very large and the corridor or hallway is more
than say 22 paces (15 metres) long, one Smoke Alarm will not
be sufficient. This is because no matter where it is located it will
be more than 7.5 metres from potential fires.

In houses with more than one sleeping area, Smoke Alarms
should be placed between each sleeping area and the living
area (for example, see figure 2).

(b) Multi Storey Dwellings.

If your home is on more than one level you will require a smoke
alarm on each storey (see figure 3).

This is because an upstairs smoke alarm is unlikely to detect a
fire on lower floors in sufficient time to ensure an adequate es-
cape.

(c) Maximum Protection.

For maximum protection you should put individual Smoke
Alarms in all the rooms where fire is most likely to break out
(apart from the locations to avoid, mentioned on page 5). The liv-
ing room is the most likely place for a fire to start at night, fol-
lowed by the kitchen and then the dining room. You should also
consider putting Smoke Alarms in any bedrooms where fires
might occur, for instance, where there is an electrical appliance
such as an electric blanket or heater, or where the occupant is a
smoker. You could also consider putting Smoke Alarms in any
rooms where the occupant is unable to respond very well to a
fire starting in the room, such as an elderly or sick person or a
very young child.

(d) Checking you can hear your Smoke Alarm.

With the Smoke Alarm sounding in its intended location, check
you are able to hear it in each bedroom with the door closed,
above the sound of your radio. The radio should be set to a rea-
sonably loud conversation level. If you can’t hear it over your ra-
dio the chances are that it wouldn’t wake you.

If a Smoke Alarm is too far away for it to wake you, it is best to link
it to another Smoke Alarm near the bedroom. The Interconnect
Smoke Alarm

EI

100C is designed for this - when one alarm senses smoke, all

connected alarms respond. (see page 9 for further details).

Positioning your Smoke Alarm

(a) Ceiling Mounting.

Hot smoke rises and spreads out, so a central ceiling position is
the preferred location. The air is “dead” and does not move in
corners, therefore Smoke Alarms must be mounted away from
corners. Place the unit at least 30cm (12 inches) from any light
fitting or decorative object which might obstruct smoke entering

the Smoke Alarm. Keep at least 15 cm (6 inches) away from
walls and corners. See figure 4.

(b) Wall Mounting.

When a ceiling position is not practical (for example on a ceiling
having exposed beams or joists, or built-in radiant heating) put
the top edge of your Smoke Alarm between 15 and 30 cm (6 and
12 inches) below the ceiling. Keep at least 15cm (6 inches) from
corners. (see figure 4).

(c) On a sloping Ceiling.

In areas with sloping or peaked ceilings install your Smoke
Alarm 90 cm (3 feet) from the highest point measured horizon-
tally (see figure 5), because “dead air” at the apex may prevent
smoke from reaching the unit.

(d) Locations to Avoid.

Don’t place your Smoke Alarm in any of the following areas:

·

Bathrooms, kitchens, shower rooms, garages or other rooms
where the smoke alarm may be triggered by steam, conden-
sation, normal smoke or fumes. Keep at least 6 metres (20
feet) away from sources of smoke - wall mounting if neces-
sary.

·

Attics or other places where extremes of temperature may
occur (below 4

°

C/34

°

F or above 40

°

C/104

°

F).

·

Near a decorative object, door, light fitting, window molding
etc., that may prevent smoke from entering the Smoke Alarm.

·

Surfaces that are normally warmer or colder than the rest of
the room (for example attic hatches, uninsulated exterior
walls etc). Temperature differences might stop smoke from
reaching the unit.

·

Next to or directly above heaters or air conditioning vents,
windows, wall vents etc. that can change the direction of air-
flow.

·

In very high or awkward areas where it may be difficult to
reach the alarm (for testing, battery replacement etc).

(e) Nuisance/False Alarms.

If, when the alarm goes off, there is no sign of smoke heat or
noise to indicate that there is a fire, you should get your family
into a safe place, before you start investigating.

Check the house carefully in case there is a small fire smolder-
ing somewhere.

Check whether there is some source of smoke or fumes, for ex-
ample cooking fumes being drawn past the Smoke Alarm by an
extractor.

If there are frequent nuisance/false alarms it may be necessary
to re- locate the device away from the source of the fumes.

The Silencer Smoke Alarm

EI

100S is designed for more difficult

areas, as you can silence the alarm for 8 minutes. This gives
time for smoke or fumes to clear, (see page 10 for more details).

Figure 4

Figure 5

90cm

(3 FEET)

DEAD AIR SURFACES

NEVER WITHIN 15cm

OF ANY CORNER

15 TO 30cm

(6 to 12")

IDEAL IN CENTRE

OF CEILING

Figure 2: Single Storey Dwelling with seperate sleeping areas

BEDROOM

BEDROOM

LIVING

BEDROOM

RECREATION

DINING

KITCHEN

Figure 3: Two Storey Dwelling

BEDROOM

BEDROOM

BEDROOM

KITCHEN

DINING

Figure 1: Single Storey Dwelling

Recommended protection, Figures 1,2 & 3

Minimum protection

·

each storey

·

each sleeping area

·

every 7.5 metres (25ft) of hallways and rooms

Maximum protection

All rooms (except bathrooms & kitchens)

2

3

4

5

P/N B10277

- Pages 2 to 5 -

Rev 7

Basic Information about your Smoke Alarm

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Installing your Smoke Alarm; Looking after your Smoke Alarm; Connection and Replacement of Batteries.; EI; EI; Figure 6

Installing your Smoke Alarm (a) Attaching to Ceiling or Wall. (NB: for wiring the EI 100C Interconnect model see page 9 ) The Smoke Alarm is battery operated and needs no wiring, ( EI 100C excepted). Use figure 6 below, as a help in mounting. 1. Pull Cover open at Tab (2). Remove Cover from Base bys...

Page 3 - Important Safeguards; Planning your Escape for when the Alarm goes off; NEVER

A maximum of 250 metres (820ft) of 18 AWG (0.82mm) wire canbe used, (maximum resistance between detectors 50 ohm). Theunits are interconnected by wiring all the terminals marked 1 to-gether, and all the terminals marked 2 together, as shown in Fig-ure 10. An opening should be made in the label cover...

Page 4 - MUST; be given to the householder.; VOLT IONISATION; IMPORTANT NOTICE; THIS IS NORMAL

Getting your Smoke Alarm Serviced If your Smoke Alarm fails to work after you have read the sec-tions on “Connecting the battery” and “Looking after your SmokeAlarm” contact Customer Assistance at the nearest addressgiven at the end of this leaflet. If it needs to be returned for repairor replacemen...

Other Ei Electronics Models

All Ei Electronics Other