Ei Electronics Ei166RC - Manual
Ei Electronics Ei166RC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – IMPORTANT INFORMATION; CHANGING
- Page 3 – CHANGING THE BATTERY; ALARM REMOVAL
- Page 4 – If the unit is beeping
- Page 5 – Optical Smoke Alarm only; unit beeps and the red light does; not; flash at the same; ” section on page 10.; GETTING YOUR ALARM SERVICED; CLEANING YOUR ALARM; Electrical shock hazard. Disconnect the AC mains
- Page 6 – When; sure; that it is just a nuisance alarm, simply press the; Hush Feature
- Page 7 – IMPORTANT SAFEGUARDS; PLANNING YOUR ESCAPE ROUTE
- Page 8 – Limitations of Smoke / Heat Alarms; INSTALLER INSTRUCTIONS
- Page 11 – INDEX
- Page 12 – USER INSTRUCTIONS
2. ALARM REMOVAL
SLIDE ALARM OFF BASE
WITH THE SCREWDRIVER STILL INSERTED, PUSH THE LOWER
HALF OF THE ALARM AWAY FROM THE SCREWDRIVER, IN THE
DIRECTION OF THE ARROW ON THE COVER
HOLD THE LOWER HALF OF THE ALARM AND REMOVE FROM
THE BASE PLATE BY MOVING IT VERTICALLY DOWNWARDS,
TOWARDS THE FLOOR.
REMOVE ALARM
LOCATE REMOVAL SLOT
LOCATE THE ARROW ON THE FRONT FACE OF THE ALARM.
THE SLOT IS LOCATED DIRECTLY ABOVE THE ARROW.
INSERT SCREWDRIVER
INSERT A FLAT-BLADED SCREWDRIVER HORIZONTALLY
APPROX. 1cm INTO THE CENTRE OF THE REMOVAL SLOT
TO REMOVE PUSH
& PUSH COVER AW
AY
SCREWDRIVER INT
O SLOT
2
B16009-R0-160RC SERIES-U&C 17/1/07 11:13 AM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Do not paint your alarm. Do not allow paint, water or dust to contaminate your alarm. Your alarm is a mains 230V AC electrical appliance. Do not open or insert anything into the alarm. 3. IMPORTANT INFORMATION Regularly check that the green mains indicator light on the cover is lit. If alarm beeps o...
4. CHANGING THE BATTERY (Models Ei141 / 144 / 146 only) 1. Switch off mains power to alarm (green light on cover should go out). 2. Remove unit as shown in “ ALARM REMOVAL ” section on page 2. 3. Locate battery slot in base of alarm as shown below. 4. Unclip battery from battery snap connectors. 5. ...
will stop when the button is released. Pressing the test buttonsimulates the effect of smoke or heat during a real fire and isthe best way to ensure the Alarm is operating correctly. WARNING: DO NOT TEST WITH FLAME This can set fire to the Alarm and damage the house We do not recommend testing with ...
