Edelbrock Carburetor - Manual

INSTRUCTION SUPPLEMENT FOR 2003-

LATER POLARIS PREDATOR

Removing stock c arburetor and c able s.

1.

Remove se at a n d g as ta nk.

Ma k e sure fuel

petcoc k is in “off” position.

2. Remove throttle ca ble p aying close a tte n tio n

to rou tin g , as th e n ew ca ble(s) will ne e d to o
b e ro ute d th e same .

3. Remove stock carb uretor a n d stock throttle

h o using . Stuff a clea n, dry rag in to ma nifold
to ke e p d e bris o u t o f motor.

Twist Throttle Instructions

1. Install th e throttle ca bles into th e su p plied

throttle h o using a n d place o nto cle a n
h a n dle b ar e n d .

2. Rou te throttle ca bles throu g h frame as stock

cable was route d .

3. Install th e p ull ca ble in to th e 4 :0 0 p osition

a n d th e return ca ble e n d into th e 1:0 0
p osition o f th e ca ble wh e el. Secure ca bles
to ca ble bracket by replacing e n d piece a n d
Phillips screw. Se e fig ure 2 .

NOTE: SEE FIGURE 1 TO ID ENTIFY CABLES.
The bottom c able is the pull c able .

Figure 1 .

Fig ure 2.

Thumb Throttle Instructions

NOTE: # 3 1 9 6 KIT REQUIRES THE USE OF
A SUZUKI THUMB THROTTLE HOUSING.
PART # 5 7 1 0 0-07 G 0 0 CAN BE ORDERED
FROM ANY SUZUKI DEALER.

1. Threa d n ew throttle ca ble in to h o usin g a n d

insert ca ble e n d in to throttle lever.

2. Install ca ble into ca ble wh e el o n carburetor

in th e 4:0 0 p ositio n a n d secure ca ble in to
lower slot o n ca ble bracket by replacing e n d
piece a n d Phillips screw. Se e fig ure 6 .

Carburetor installation