Edelbrock 6652 - Manual
Edelbrock 6652 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©2002 Edelbrock Corporation
Page 1 of 2
Rev. 8/02
Catalog #6652, #6752, & #6852
Catalog #6653, #6753, & #6853
Pro-Flo Header
For 1994-2001 Acura Integra GSR
Catalog #6652, #6752, #6852
& For 1997-2001 Acura Integra Type R
Catalog #6653, #6753, & #6853
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Pro-Flo Header. They provide general guidelines to
be studied and understood before you remove your stock system. Failure to follow these instructions may void your
warranty. If you have any questions or problems, please contact our
Technical Hotline at : 1-800-416-8628
from
7 am – 5 pm, Monday through Friday, Pacific Standard Time or e-mail us at
. Please fill out
and mail your warranty card.
DESCRIPTION:
Edelbrock Pro-Flo header components are designed to improve the exhaust efficiency of the Acura 1.8L
engine. A performance gain can be expected with the installation of the system. This system requires no welding for
installation and retains all stock emissions equipment.
Suggested tools needed for installation: This vehicle has some metric fasteners.
❑
3/8” ratchet socket set with extensions and a good assortment of metric sockets
❑
Combination wrenches (metric)
❑
Universal 12mm and 14mm swivel sockets
❑
Jackstands, screwdrivers, pliers, crescent wrench, etc.
❑
Liquid penetrant (GM #1052627 or equivalent); anti-seize compound (GM #5613695 or equivalent)
SPECIAL NOTICE:
This Edelbrock part has received an Executive Order number (E.O. #) from the California Air Resources
Board (C.A.R.B.) making it legal for street use on pollution-controlled motor vehicles in all 50 states. To assist you with
emissions equipment certification, we have included a silver fan shroud decal to help testing personnel verify that this part
is a legal replacement part on the vehicle for which it is cataloged. The adhesive-backed decal should be affixed to your
fan shroud next to the existing emission and engine specification decal. Do not cover your original equipment specification
decal with the Edelbrock fan shroud decal.
WARNING:
The use of “Thermal Wrap” or any aftermarket coating process will void the warranty on your Pro-Flo header.
Those products can cause excessive heat and moisture build up resulting in corrosion and early failure of the system.
DISASSEMBLY:
1. Disconnect battery negative cable from battery.
2. Raise vehicle and support with jackstand.
3. The use of penetrating oil when removing and the use of anti-seize compound when installing nuts and bolts will
prevent the possibility of broken or stripped nuts and bolts.
4. Make sure converter is cool.
5. Remove O2 sensor (if applicable) being careful not to destroy or rupture the unit. Warning: Do not clean this unit
in any cleaning solvents and do not rupture wire.
6. Remove the two nuts from hanger bracket. Remove the two bolts and springs at the catalytic converter. Then
unbolt the three bolts at the mid-section of manifold and remove lower portion of manifold (B-section).
7. Remove the bolt that is attached to the engine block in the lower section of manifold. Remove bolts from manifold
at cylinder head and pull manifold out from top side.
Note:
Save all factory nuts, bolts and springs to be used
during re-assembly.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
