Edelbrock 5721 - Manual
Edelbrock 5721 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
©2007 Edelbrock Corporation
Brochure #63-5721
Catalog #5721
Rev. 12/07 - AJ/mc
Page 1 of 1
®
EDELBROCK CAT-BACK EXHAUST SYSTEM
For 2007-2008 Toyota FJ Cruiser 2WD & 4WD
Catalog #5721
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Edelbrock Cat-Back Exhaust System. If you have any
questions, please contact our
Technical Hotline at: 1-800-416-8628
, 7am - 5pm, Monday-Friday, Pacific Standard
Time or e-mail us at
Suggested Tools for Installation:
❑
3/8" ratchet and metric sockets
❑
14mm, 15mm, and 17mm Wrenches
❑
Jack and jackstands
❑
Liquid penetrant and rubber lubricant
DISASSEMBLY
1. Raise and support vehicle.
2. Remove factory exhaust system from the flange
located behind the catalytic converter.
ASSEMBLY
1. Disconnect the fuel vapor return line from the vapor
canister located just above the rear-end housing. Place
the heat shield sleeve over return line and reconnect it
to the canister.
NOTE:
Since fuel lines contain harmful
vapors, this procedure should be done in a well
ventilated area clear of any open flames or extreme
heat.
Safety glasses should also be worn when
performing this action.
2. Using the supplied 10mm bolts, lock washers, and flat
washers from the kit, install the I-pipe assembly #25-
3285 placing the hangers in the rubber isolators.
3. Using a 2-1/2” band clamp and hanger clamp assembly
#23-4107 from the kit, install muffler #25-55742.
NOTE:
Only snug all clamps at this time for adjusment
later.
4. Install overaxle pipe assembly #25-3286.
WARNING!!!
Exhaust gas contains carbon monoxide, a deadly
invisible gas. Correct any leaks before driving!
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.
KIT CONTENTS
Catalog #5716
Qty.
Part #
Description
❑
1
25-3285
I-Pipe Assembly
❑
1
25-3286
Overaxle Assembly
❑
1
25-3298
Tailpipe Assembly
❑
1
25-5582
Tailpipe Tip (Polished)
❑
1
22-5721
Installation Kit
❑
1
25-55742
Muffler
5. Using a 2-1/2” band clamp, install tailpipe assembly
#25-3298 placing the hanger in the rubber isolator.
6. Using a 2-1/2” band clamp, install tailpipe tip #25-
5582.
7. Working from the front of the system to the rear, adjust,
align, and tighten all the band clamps. Give adequate
clearance for fuel lines, brake lines, electrical wiring,
and the spare tire.
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: (800) 416-8628 Office: (310) 781-2222
E-Mail: [email protected]
®
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
