Page 2 - C O N T E N T S
C O N T E N T S S A F E T Y P R E C A U T I O N S NAMES OF PARTS INDOOR UNIT DISPLAY OPERATING INSTRUCTIONS PROTECTION INSTALLATION MANUAL MAINTENANCE TROUBLESHOOTING EMERGENCY FUNCTION & AUTO-RESTART FUNCTION REMOTE CONTROLLER .......................................................................
Page 3 - SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER
During the installation of the indoor and outd-oor units the access to the working area should be forbidden to children.Unforeseeable accidents could happen. Make sure that the base of the outdoor unit isfirmly fixed. Check that air cannot enter the refrigerant sys- tem and check for refrigerant lea...
Page 4 - SAFETY RULES AND RECOMMENDATIONS FOR THE USER
SAFETY RULES AND RECOMMENDATIONS FOR THE USER Do not try to install the conditioner alone; always contact specialized technical personnel. Cleaning and maintenance must be carried out by specialised technical personnel. In any case disconnect the appliance from the mains elect-ricity supply before c...
Page 5 - SAFETY RULES AND PROHIBITIONS; Do not use extensions or gang modules.
SAFETY RULES AND PROHIBITIONS 3 Do not bend , tug or compress the power cord since this could damage it. Electrical shocks orfire are probably due to a damaged power cord. Specialised technical personnel only must repl-ace a damaged power cord. Do not use extensions or gang modules. Do not touch the...
Page 6 - NAMES OF PARTS; Stick position optional; DIS; CL; INDOOR UNIT
NAMES OF PARTS No. Description 1 2 Front panel Air filter Optional filter (if installed) 3 Terminal block cover 4 Emergency button 5 6 LED Display Signal receiver 7 Airflow direction louver 8 Deflectors 9 Remote controller 10 Note: the above figures are only intended to be a simple diagram of the ap...
Page 7 - INDOOR UNIT DISPLAY; Led
INDOOR UNIT DISPLAY 1 2 5 3 4 1 2 3 4 5 The shape and position of switches and indicators may be different according to the model, but their function is the same. 1 2 4 5 3 5 1 2 3 4 5 3 1 2 3 5 4 No. Led Function POWER This symbol appears when the unit is power on 1 2 3 4 5 Temperature display (if ...
Page 8 - EMERGENCY FUNCTION & AUTO-RESTART FUNCTION; when the power restores, the unit; display PCB; EMERGENCY FUNCTION; front panel
EMERGENCY FUNCTION & AUTO-RESTART FUNCTION 6 R e m a r k : t h e e x t e r n a l s t a t i c p r e s s u r e o f h e a t p u m p s i s 0 P a f o r a l l m o d e l s . The shape and position of the emergency button may be different according to the model, but their function is the same. ON/OFF Em...
Page 9 - REMOTE CONTROLLER; In HEAT ode, the unit will; Button
REMOTE CONTROLLER 7 The shape and position of buttons and indicators may vary according to the model, but their function is the same. The outlooking and some function of remote control may vary according to the model. The unit confirms the correct reception of each press button with a beep. SLEEP TI...
Page 10 - EC; Meaning; TURBO
Auto Feel Cool Dry Heat Low Mid High Sleep Swing TimerOFF Timer Fan REMOTE CONTROLLER Remote controller DISPLAY Meaning of symbols on the liquid crystal display ON OFF ON C AUTOQUIET POWERFUL hrDELAY DRY FAN HEAT TIMER HEALTHY AIRSWING FANSPEED COOL FEEL 8 C h C h MID AUTO SLEEP TIMER ON HIGH LOW TM...
Page 11 - Remote controller holder; Replacement of Batteries; When you insert/change the batteries for the first time in the
REMOTE CONTROLLER Signal receptor 9 DRY FAN HEAT TIMER HEALTHY AIRSWING FANSPEED COOL FEEL DRY FAN HEAT TIMER HEALTHY AIRSWING FANSPEED COOL FEEL + + + DIS PLAY HEAL THY 3D O N /O FF SW IN G FA N TI M ER SU PE R SL EE P M OD E EC O CLOC K Remote controller holder DISP LAY HEA LTH Y 3D ON /OFF SW ING...
Page 12 - OPERATING INSTRUCTIONS; flaps; SWING
OPERATING INSTRUCTIONS Filter Heat Fan Exchanger “ SWING ” CONTROL OF THE AIR FLOW 10 flaps flapmovement Deflectors ON/OFF MODE TIMER FAN SPEED SUPER ECO SWING SLEEP HEALTHY ANTI-MILDEW MODE FAN SLEEP ECO TIMER SWING TURBO HEALTHY DISPLAY SWING AIRSWING OFF ON C AUTOQUIET POWERFUL hr DELAY TIMER HEA...
Page 13 - COOLING MODE; HEATING MODE; COOL; HEAT
OPERATING INSTRUCTIONS COOLING MODE The cooling function allows the air condit-ioner to cool the room and at the same timereduces Air humidity. COOL To activate the cooling function ( COOL ) , press the MODE button until the symbol ( COOL ) appears on the display. 11 HEATING MODE OFF ON C AUTOQUIET ...
Page 14 - When the time is set correctly on the
OPERATING INSTRUCTIONS POWER SLEEP TIMER RUN Indoor display 12 TIMER MODE----TIMER OFF TIMER MODE----TIMER ON POWER SLEEP TIMER RUN Indoor display TIMER ON OFF ON C AUTOQUIET POWERFUL hr DELAY TIMER HEALTHY AIRSWING FANSPEED ON/OFF MODE TIMER FAN SPEED SUPER ECO SWING SLEEP HEALTHY DRY FAN HEAT COOL...
Page 15 - FAN MODE; DRY
OPERATING INSTRUCTIONS 13 FAN The conditioner works in only ventilation. To set the FAN mode , Press MODE untill ( FAN ) appears in the display. Whith pressing FAN button the speed changes in the following sequence: LOW/ MEDIUM/HIGH /AUTO in FAN mode. The remote control also stores the speed that wa...
Page 16 - Ambient temp; I FEEL MODE; Indoor display; FEEL; SLEEP MODE; I FEEL
OPERATING INSTRUCTIONS Ambient temp Auto temp. 20 23 23 26 20 ~ 26 Operation mode HEATING ( FOR HEAT PUMP TYPE) DRY COOL 18 FAN (FOR COOL ONLY TYPE) To optimize the function of the air conditioner, adjust the temperature(only 2 )(1), the speed (2) and the direction of the air flow (3) by pressing th...
Page 17 - PROTECTION; For T1 Climate condition models:; MODE; Ambient temperature
PROTECTION 15 The air conditioner is programmed for comfortable and suitable living conditions, if it is used in abnormal conditioner as below, certain safety protection features might come into effect. Outdoor temperature is over 24 2 Room temperature is over 27 Outdoor temperature is below -7 1 3 ...
Page 18 - Installation Diagram; Select a site where the condensed water can be easily drained
INSTALLATION MANUAL---Selecting the Installation Place condensed water drain pipe 150 150 1 5 0 Sleeve insulating covering electrical cable Mounting plate Do not install the outdoor unit near sources of heat, steam or flammable gas. Do not install the unit in too windy or dusty places. Do not instal...
Page 19 - Installation of the mounting plate
INSTALLATION MANUAL---Installation of the Indoor unit 50 5mm Note : Keep the drain pipe down towards the directionof the wall hole, otherwise leakage may occur. Before starting installation, decide on the position of the indoor and outdoor units, taking into account the minim-um space reserved aroun...
Page 21 - INSTALLATION OF THE INDOOR UNIT
INSTALLATION MANUAL---Installation of the Indoor unit INSTALLATION OF THE INDOOR UNIT refrigerant pipe refrigerant pipe insulation sleeve connection (for heat-pump) cable 1 connection cable Probe cable(for heat-pump) Condensed waterdrain pipe Covered by vinyl tape After having connected the pipe acc...
Page 22 - right
INSTALLATION MANUAL---Installation of the outdoor unit outdoor unit screw wiring diagram on the back of the cover Screw the flare nuts to the outdoor unit coupling with the same tightening procedures described for the indoor unit. connection pipes flare nuts liquid tap gas tap indoor unit protection...
Page 23 - Indoor unit test; BLEEDING
INSTALLATION MANUAL---Installation of the outdoor unit The air and humidity left inside the refrigerant circulat-ion can cause compressor malfunction. After having co-nnected the indoor and outdoor units, bleed the air and humidity from the refrigerant circulation using a va-cuum pump. Refrigerant f...
Page 25 - O u t d o o r h a n d l e c o v e r
INSTALLATION MANUAL---Information for the installer WIRING DIAGRAM 23 Note: For some models the wires has been connected to the main PCB of indoor unit by manufacturer without terminal block. For different models, the wiring diagram may be different. Please refer to the wiring diagrams pasted on the...
Page 26 - CABLE WIRES SPECIFICATION
INSTALLATION MANUAL---Information for the installer CABLE WIRES SPECIFICATION 24 MODEL capacity (Btu/h) 5k 7k 9k 12k 15/18k 22/24k 28/30k/36k Power supply cable Connection supply cable N L E 1 2 3 N L 2 1.0mm 2 1.0mm 2 1.0mm 2 1.0mm 2 0.75mm 2 0.75mm 2 0.75mm 2 1.0mm 2 1.0mm 2 1.5mm 2 2.5mm 2 4.0mm ...
Page 27 - MAINTENANCE; ANTIDUST FILTERS; CLEANING THE HEAT EXCHANGER; antidust filter
MAINTENANCE Periodic maintenance is essential for keeping your air conditioner efficient.Before carrying out any maintenance , disconnect the power supply by taking the plug out from the socket. INDOOR UNIT ANTIDUST FILTERS 1. Open the front panel following the direction of the arrow2. Keeping the f...
Page 28 - TROUBLESHOOTING; MALFUNCTION; Air filter is blocked.
TROUBLESHOOTING 26 MALFUNCTION Strange odour The appliance does not operate Noise of running water A fine mist comes from the air outlet Insufficient airflow, eitherhot or cold The appliance does not respond to commands The display is off Switch off the air conditioner immediately and cut off the po...
Page 29 - C O N T A C T D E T A I L S
C O N T A C T D E T A I L S G l e n D i m p l e x A u s t r a l i a P t y L t d1 / 2 1 L i o n e l R o a dM o u n t W a v e r l e y V I C 3 1 4 9A u s t r a l i a P h : 1 3 0 0 5 5 6 8 1 6W e b : w w w. d i m p l e x . c o m . a u G l e n D i m p l e x N e w Z e a l a n d L t d3 8 H a r r i s R o a ...
