Page 3 - C O N T E N T S
C O N T E N T S S A F E T Y P R E C A U T I O N S NAMES OF PARTS INDOOR UNIT DISPLAY OPERATING INSTRUCTIONS PROTECTION INSTALLATION MANUAL MAINTENANCE TROUBLESHOOTING EMERGENCY FUNCTION & AUTO-RESTART FUNCTION REMOTE CONTROLLER .......................................................................
Page 4 - SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER
1 During the installation of the indoor and outd-oor units the access to the working area should be forbidden to children.Unforeseeable accidents could happen. Make sure that the base of the outdoor unit isfirmly fixed. Check that air cannot enter the refrigerant sys- tem and check for refrigerant l...
Page 5 - SAFETY RULES AND RECOMMENDATIONS FOR THE USER
2 SAFETY RULES AND RECOMMENDATIONS FOR THE USER Do not try to install the conditioner alone; always contact specialized technical personnel. Cleaning and maintenance must be carried out by specialised technical personnel. In any case disconnect the appliance from the mains elect-ricity supply before...
Page 6 - SAFETY RULES AND PROHIBITIONS; Do not use extensions or power board.
3 SAFETY RULES AND PROHIBITIONS Do not bend , tug or compress the power cord since this could damage it. Electrical shocks orfire are probably due to a damaged power cord. Specialised technical personnel only must repl-ace a damaged power cord. Do not use extensions or power board. Do not touch the ...
Page 7 - NAMES OF PARTS; Stick position optional; INDOOR UNIT
NAMES OF PARTS No. Description 1 2 Front panel Air filter Optional filter (if installed) 3 Terminal block cover 4 Emergency button 5 6 LED Display Signal receiver 7 Airflow direction louver 8 Deflectors 9 Remote controller 10 Note: the above figures are only intended to be a simple diagram of the ap...
Page 8 - INDOOR UNIT DISPLAY; Led
INDOOR UNIT DISPLAY 1 2 5 3 4 1 2 3 4 5 The shape and position of switches and indicators may be different according to the model, but their function is the same. 1 2 4 5 3 5 1 2 3 4 5 3 1 2 3 5 4 No. Led Function POWER This symbol appears when the unit is power on 1 2 3 4 5 Temperature display (if ...
Page 9 - EMERGENCY FUNCTION & AUTO-RESTART FUNCTION; when the power restores, the unit; display PCB; EMERGENCY FUNCTION; front panel
6 EMERGENCY FUNCTION & AUTO-RESTART FUNCTION R e m a r k : t h e e x t e r n a l s t a t i c p r e s s u r e o f h e a t p u m p s i s 0 P a f o r a l l m o d e l s . The shape and position of the emergency button may be different according to the model, but their function is the same. ON/OFF Em...
Page 10 - REMOTE CONTROLLER; Button
Mode Fan Eco Temp Swing Timer Display Sleep Mildew Turbo Health 8 3 6 7 9 10 5 12 4 1 2 11 REMOTE CONTROLLER 7 The shape and position of buttons and indicators may vary according to the model, but their function is the same. The outlooking and some function of remote control may vary according to th...
Page 11 - Meaning
REMOTE CONTROLLER Remote controller DISPLAY Meaning of symbols on the liquid crystal display 8 1 2 3 4 5 6 7 8 9 10 11 12 13 14 FEEL mode indicator COOLING indicator DEHUMIDIFYING indicator FAN ONLY OPERATION indicator HEATING indicator SIGNAL RECEPTION indicator TIMER OFF indicator TIMER ON indicat...
Page 12 - Remote controller holder; Replacement of Batteries; When you insert/change the batteries for the first time in the
9 REMOTE CONTROLLER Signal receptor + + + Remote controller holder Replacement of Batteries Remove the battery cover plate from the rear of the remote controller, by sliding it in the direction of the arrow.I nstall the batteries according the direction (+and -)shown on the Remote Controller.Reinsta...
Page 13 - OPERATING INSTRUCTIONS; flaps; SWING
10 OPERATING INSTRUCTIONS Filter Heat Fan Exchanger “ SWING ” CONTROL OF THE AIR FLOW flaps flapmovement Deflectors The direction of the air outlet is motorized up and down by flaps, and manually moved right and left by the vertical deflectors, for some models, the vertical deflectors could becontro...
Page 14 - COOLING MODE; HEATING MODE; HEAT; HEAT
11 OPERATING INSTRUCTIONS COOLING MODE The cooling function allows the air condit-ioner to cool the room and at the same timereduces Air humidity. COOL To activate the cooling function ( COOL ) , press the MODE button until the symbol ( COOL ) appears on the display. HEATING MODE The cooling functio...
Page 15 - Indoor display; TIMER; Set the rest time by pressing the; When the time is set correctly on the; TIMER ON
12 OPERATING INSTRUCTIONS POWER SLEEP TIMER RUN Indoor display TIMER MODE----TIMER OFF TIMER MODE----TIMER ON POWER SLEEP TIMER RUN Indoor display TIMER To set the time of the air conditioner To program the automatical switching-on time, the appliance should be power off.Press TIMER at the fist time...
Page 16 - FAN MODE; FAN
13 OPERATING INSTRUCTIONS FAN The conditioner works in only ventilation. To set the FAN mode , Press MODE until ( FAN ) appears in the display. While pressing FAN button the speed changes in the following sequence: LOW/ MEDIUM/HIGH /AUTO in FAN mode. The remote control also stores the speed that was...
Page 17 - Ambient temp; DRY; I FEEL MODE; SLEEP MODE; FEEL
14 OPERATING INSTRUCTIONS Ambient temp Auto temp. 20 23 23 26 20 ~ 26 Operation mode HEATING ( FOR HEAT PUMP TYPE) DRY COOL 18 FAN (FOR COOL ONLY TYPE) To optimize the function of the air conditioner, adjust the temperature(only 2 )(1), the speed (2) and the direction of the air flow (3) by pressing...
Page 18 - PROTECTION; For T1 Climate condition models:; MODE; Ambient temperature
PROTECTION 15 The air conditioner is programmed for comfortable and suitable living conditions, if it is used in abnormal conditioner as below, certain safety protection features might come into effect. Outdoor temperature is -15 ~28 2 Room temperature is 30 1 3 Heating Cooling Dry Outdoor temperatu...
Page 19 - Installation Diagram; Select a site where the condensed water can be easily drained
16 INSTALLATION MANUAL---Selecting the Installation Place condensed water drain pipe 150 150 1 5 0 Sleeve insulating covering electrical cable Mounting plate Do not install the outdoor unit near sources of heat, steam or flammable gas. Do not install the unit in too windy or dusty places. Do not ins...
Page 20 - Installation of the mounting plate
17 INSTALLATION MANUAL---Installation of the Indoor unit 50 5mm Note : Keep the drain pipe down towards the directionof the wall hole, otherwise leakage may occur. Before starting installation, decide on the position of the indoor and outdoor units, taking into account the minim-um space reserved ar...
Page 22 - INSTALLATION OF THE INDOOR UNIT
19 INSTALLATION MANUAL---Installation of the Indoor unit INSTALLATION OF THE INDOOR UNIT refrigerant pipe refrigerant pipe insulation sleeve connection (for heat-pump) cable 1 connection cable Probe cable(for heat-pump) Condensed waterdrain pipe Covered by vinyl tape After having connected the pipe ...
Page 23 - right
20 INSTALLATION MANUAL---Installation of the outdoor unit outdoor unit screw wiring diagram on the back of the cover Screw the flare nuts to the outdoor unit coupling with the same tightening procedures described for the indoor unit. connection pipes flare nuts liquid tap gas tap indoor unit protect...
Page 24 - Indoor unit test; BLEEDING
21 INSTALLATION MANUAL---Installation of the outdoor unit The air and humidity left inside the refrigerant circulat-ion can cause compressor malfunction. After having co-nnected the indoor and outdoor units, bleed the air and humidity from the refrigerant circulation using a va-cuum pump. Refrigeran...
Page 25 - k
INSTALLATION MANUAL---Information for the installer 22 (1) Refer to the data rating label sticked on the outdoor unit. TIGHTENING TORQUE FOR PROTECTION CAPS AND FLANGE CONNECTION PIPE 1/4( 6) 3/8( 9.52) 1/2 ( 12) 5/8( 15.88) TIGHTENING TORQUE [N x m] TIGHTENING TORQUE [N x m] CORRESPONDING STRESS (u...
Page 26 - WIRING DIAGRAM; Please see the pasted diagram instruction on the unit first
INSTALLATION MANUAL---Information for the installer 23 INSTALLATION MANUAL---Information for the installer WIRING DIAGRAM Note: The cable wires hasbeen connected to the main PCB of indoor unit by manufacturer according to the model without terminal block, see the wiring diagram on the right part of ...
Page 27 - CABLE WIRES SPECIFICATION
INSTALLATION MANUAL---Information for the installer CABLE WIRES SPECIFICATION 24 MODEL capacity (Btu/h) 9k 12k 18k 24k Power supply cable Connection supply cable N L E 1 2 3 N L 2 1.5mm 2 1.5mm 2 2.5mm 2 1.5mm 2 0.75mm 2 0.75mm 2 0.75mm 2 0.75mm 2 1.5mm / 2 1.5mm 2 0.75mm 2 0.75mm 2 0.75mm 2 0.75mm ...
Page 28 - MAINTENANCE; ANTIDUST FILTERS; CLEANING THE HEAT EXCHANGER; antidust filter
25 MAINTENANCE Periodic maintenance is essential for keeping your air conditioner efficient.Before carrying out any maintenance , disconnect the power supply by taking the plug out from the socket. INDOOR UNIT ANTIDUST FILTERS 1. Open the front panel following the direction of the arrow2. Keeping th...
Page 29 - TROUBLESHOOTING; MALFUNCTION; Air filter is blocked.
TROUBLESHOOTING 26 MALFUNCTION Strange odour The appliance does not operate Noise of running water A fine mist comes from the air outlet Insufficient airflow, eitherhot or cold The appliance does not respond to commands The display is off Switch off the air conditioner immediately and cut off the po...
Page 30 - C O N T A C T D E T A I L S
C O N T A C T D E T A I L S G l e n D i m p l e x A u s t r a l i a P t y L t d1 3 4 0 F e r n t r e e G u l l y R o a dS c o r e s b y V I C 3 1 7 9A u s t r a l i a P h : 1 3 0 0 5 5 6 8 1 6W e b : w w w. d i m p l e x . c o m . a u G l e n D i m p l e x N e w Z e a l a n d L t d3 8 H a r r i s R ...
