Dewalt DWS780 XE - User Manual

Page 3 - READ ALL INSTRUCTIONS; Double Insulation

1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: Indicates...

Page 5 - Electrical Connection; Young children and the infirm.; Accessories

3 Electrical Connection The electric motor has been designed for one voltage only. Always check that the power supply corresponds to the voltage on the rating plate. 230 V AC means your tool will operate on alternating current. As little as 10% lower voltage can cause loss of power and can result in...

Page 8 - WARNING: To reduce the risk of serious personal injury, ALWAYS; Features and Controls; WARNING: To reduce the risk of serious personal injury, turn off; Adjustment

66 NOTE: When using blades with a 5/8" (15.88 mm) diameter blade hole, the blade adapter will not be used and should be stored in a safe place for future use. The separate blade adapter is not available on all models. 5. Return the guard bracket to its original position and firmly tighten the gu...

Page 9 - Prior to Operation

7 not indicate exactly 22.5°, turn the crown adjustment screw contacting the pawl with a 10 mm (7/16") wrench until the bevel pointer indicates exactly 22.5°. FENCE ADJUSTMENT (FIG. 1) The upper par t of the fence can be adjusted to provide clearance, allowing the saw to bevel to a full 49° both...

Page 11 - Cutting Picture Frames, Shadow Boxes And Other Four-

99 3. When the saw comes up to speed, lower the arm smoothly and slowly to cut through the wood. Let the blade come to a full stop before raising arm. SLIDING CROSSCUT When cutting anything larger than a 51 x 150 mm (2" x 6" [51 x 105 mm (2" x 4") at 45º mitre]) workpiece, use an out...

Page 14 - Troubleshooting Guide

12 12 WARNING: Ensure the saw is mounted firmly to a stable flat sur face. Failure to do so could cause the saw to be unstable and fall causing personal injury. 4. Place the workpiece to be cut on top of the platform mounted to the table. Ensure the workpiece is firmly against the back of the base f...

Page 15 - ANGLE OF; SQU; MITER DEGREE SET; SET THIS BEVEL ANGLE ON SAW

13 10 10 10 20 20 20 30 30 30 40 40 40 50 50 50 60 60 60 70 70 70 80 80 80 TABLE 1: COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE AND THE NARROW EDGE AGAINST THE FENCE) SET THIS MITER ANGLE ON SAW ANGLE OF SIDE OF BOX (ANGLE A) SQU ARE BOX 6-SIDED BOX MITER DEGREE SET TING BEVE...

Dewalt DWS780 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models