Dewalt DW9118- User Manual

Page 3 - SAVE THESE INSTRUCTIONS; Definitions: Safety Guidelines

1 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D E WALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ). SAFETY INSTRUCTIONS FOR POWER TOOLS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and pe...

Page 4 - Electrical Safety

2 d. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating par t of the power tool may result in personal injury. e. Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpecte...

Page 7 - Important Safety Instructions for Battery Chargers

5 Important Safety Instructions for Battery Chargers SAVE THESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers. • Before using charger, read all instructions and cautionary markings on charger, battery pack, and product using battery pack. DANGER: Electrocution...

Page 8 - Using Automatic Tune-UpTM Mode; SAVE THESE INSTRUCTIONS FOR FUTURE USE; Chargers; PROBLEM POWER LINE

6 Using Automatic Tune-Up™ Mode The Automatic Tune-Up™ Mode equalizes or balances the individual cells in the battery pack allowing it to function at peak capacity. Battery packs should be tuned up weekly or after 10 charge/discharge cycles or whenever the pack no longer delivers the same amount of ...

Page 12 - Drill Operation; IF DRILL STALLS; Hammerdrill Operation

10 OPERATIONInstalling and Removing FIG. 9 G the Battery Pack (Fig. 9) NOTE: Make sure your battery pack is fully charged. To install the battery pack into the tool handle, align the notch inside the tool’s handle with the battery pack and slide the battery pack firmly into the handle until you hear...

Page 13 - Cleaning; CHARGER CLEANING INSTRUCTIONS; Repairs; FREE ONE YEAR SERVICE CONTRACT

11 Cleaning WARNING: Blow dir t and dust out of all air vents with dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this procedure. CAUTION: Never use solvents or other harsh chemicals for cleaning the non- metallic par ...

Page 14 - FREE WARNING LABEL REPLACEMENT:; If your warning labels become illegible or

12 FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call (AUS) 1800 654 155 or (NZ) 09 259 1111 for a free replacement.

Page 16 - WALT

D E WALT Battery and Charger Systems Battery Output Chargers/Charge Time Nominal 240 Volts 12 Volts X Indicates that the battery pack is not compatible with that specific charger. All charge times are approximate. Actual charge time may vary. Read the instruction manual for more specific information...

Table of Contents:

Other Manuals for Dewalt DW9118

Summary

Other Dewalt Models