Desa SL-5326 - Manual
Desa SL-5326 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INSTALLATION; WARNING: Turn power off at circuit breaker.; Wall Mount
- Page 3 – TEST AND ADJUSTMENT; Motion; SPECIFICATIONS; Bottom of Sensor
- Page 4 – 0 DAY LIMITED WARRANTY; TROUBLESHOOTING GUIDE; If the; No Service Parts Available for this Product
- Page 5 – Prueba; FUNCIONAMIENTO; Mueva el interruptor de tiempo; Resumen de las modalidades del interruptor; Apague el interruptor por; PRUEBA; Requisitos; Características; TEMPORIZADOR DEL ALUMBRADO DE 2
- Page 6 – INSTALACION; Blanco; Montaje en pared; ADVERTENCIA: Apague la energía en el fusible
- Page 7 – Parte de abajo del detector
- Page 8 – GUIA DE INVESTIGACION DE AVERIAS; GARANTÍA LIMITADA A 90 DÍAS; SERVICIO TÉCNICO; No hay piezas de servicio disponibles para este producto
Models 5312 & 5318
Motion Sensor Light
Control with 2-Level
Lighting
© 2007 DESA Specialty Products™
598-1274-00
TEST
2 Shells*
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• 2-Level Lighting Timer.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
TEST
1 5 20
ON-TIME
Off
3 6 Dusk to
Dawn
2-Level Lighting
Put ON-TIME switch on
the sensor bottom to
TEST and the 2-Level
Lighting switch OFF.
2-LEVEL LIGHTING TIMER
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). If motion is sensed,
the light turns on full bright for the ON-TIME (1, 5,
or 20 minutes) then returns to dim mode.
* Model SL-5318 only
®
Mode: On-Time:
Works:
Day
Night
Test
5
Sec
x
x
Auto
1, 5, 20 min.
x
Manual
Until
Dawn*
x
OPERATION
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
TEST
1 5 20
... back on.
AUTO
1 Second OFF
then...
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Move ON-TIME Switch to
1, 5, or 20 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
Note:
When fi rst turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
This package includes:
Light Control
Sensor
Cover
Plate
Lamp
Holders
Plastic Hanger
Rubber Plug
Gasket
6 Screws
(3 sizes included)
Mounting Strap
Mounting Bolt
2 Wire
Connectors
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
•
S o m e c o d e s r e q u i r e i n s t a l l a t i o n b y a
qualifi ed electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 598-1274-00 INSTALLATION For easy installation, select an existing light with a wall switch for replacement. W IRE THE L IGHT C ONTROL WARNING: Turn power off at circuit breaker. ❒ Remove the existing light fi xture. ❒ Install the mounting strap as shown using two screws that fi t your junction bo...
3 598-1274-00 TEST AND ADJUSTMENT ❒ Turn on the circuit breaker and light switch. Motion Motion The detector is most sensitive to motion across its fi eld of view. ❒ Loosen the clamp screw in the sensor ball joint and gently rotate the sensor. ❒ Walk through the coverage area noting where you are wh...
4 598-1274-00 SYMPTOM Lights will not come on. L i g h t s c o m e o n in daylight. L i g h t s c o m e o n f o r n o a p p a r e n t reason. Lights turn off too l a t e i n D u s k - t o -Dawn setting POSSIBLE CAUSE 1. Light switch is turned off.2. F l o o d l i g h t i s l o o s e o r burned out. ...
