Desa PBT24HB16 - Manual
Desa PBT24HB16 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ASSEmBLy
- Page 3 – See Checking for Leaks
- Page 6 – ENSAMBLE
- Page 7 – Consulte Verificación de fugas
- Page 10 – assemblage
- Page 11 – Consultez Recherche de fuites
PROPANE/LP BISTRO TABLE INFRARED PATIO HEATER
ASSEmBLy INSTRucTIONS
mODEL
PBT24HB16
uNPAckINg
1. Remove all packing items applied to heater for shipment.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater is damaged,
promptly inform dealer where you bought heater.
You should have the following assembly parts:
Hardware Blister Pack (1), Base Assembly (1), Door Panel Assembly (1), Emitter Assembly (1), Grate Assembly (1), Table Top Assembly (1),
Foot Rail (1), Upper Table Pillar (3), Upper Foot Rail Bracket (3), Foot Rail Bracket (3), (see pages 8 thru 10 of your owner's manual).
Upper
Table
Pillars
Base Assembly
Grate Assembly
Emitter Assembly
Door Panel
Assembly
Hardware
Blister Pack
Upper and
Lower Foot
Rail Brackets
Foot Rail
Table Top
Assembly
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
www.desatech.com 123224-01A 2 4. Position 3 top support pillars over pillar support connectors. Secure each set with 1 screw (A) each. 2. Cut wire tie to release grate assembly. Wire Tie 3. Complete grate assembly by installing 2 screws into grate pillar (A). Add Screw 5. Locate tabs on grate assemb...
www.desatech.com 123224-01A 3 7. Locate upper and lower foot rail brackets. Lower Foot Rail Brackets Upper Foot Rail Brackets 8. Position upper and lower foot rail brackets as shown. Fasten to pillar using 2 screws (A) for each pillar. 9. Slide foot rail down over heater assembly. Position foot rail...
www.desatech.com 123224-01A 2 4. Coloque 3 pilares de soporte superiores sobre los conectores de soporte de los pilares. Fije cada conjunto con 1 tornillo (A). 2. Corte la abrazadera de cable para soltar el conjunto de la parrilla. Abrazadera de cable 3. Complete el ensamblaje de la parrilla instala...
