Page 2 - CONTENTS; WARNINGS; Carbon monoxide poisoning may lead to death!; Carbon Monoxide Poisoning:; Early signs of carbon monoxide poisoning; SAFETY
2 103807 CONTENTS WARNINGS DANGER Carbon monoxide poisoning may lead to death! IMPORTANT: Read this Owner’s Manual carefully and completelybefore trying to assemble, operate, or service this heater. Improperuse of this heater can cause serious injury or death from burns, fire,explosion, electrical s...
Page 3 - • Fueling; Continued
3 103807 SAFETY INFORMATION Continued Make certain you read and understand all Warnings. Keep this manual forreference. It is your guide to safe and proper operation of this heater.• Use only kerosene or No. 1 fuel oil to avoid risk of fire or explosion. Never use gasoline, naphtha, paint thinners, ...
Page 4 - TOOLS NEEDED
4 103807 PRODUCT IDENTIFICATION UNPACKING 1. Remove all protective packing applied to heater for shipment. 2. Remove heater from shipping container. 3. Check heater for any shipping damage. If heater is damaged, promptly inform dealer where you bought heater. ASSEMBLY This model is furnished with wh...
Page 5 - ASSEMBLY
5 103807 ASSEMBLY Continued Air Inlet ;; ;; ;; Front Handle CotterPin RearHandle Screw Axle ExtendedHub Nut Flat Washer Wheel Spacer Flat Washer Figure 2 - Wheel and Handle Assembly Wheel WheelSupportFrame Fuel TankFlange Hot AirOutlet
Page 6 - The motor turns the fuel pump. The fuel pump pulls fuel from; The Ignition System:; The electronic ignitor sends voltage to the spark plug. The; The Burner Control System:; This system causes the heater to shut down if the
6 103807 THEORY OF OPERATION The Fuel System: The motor turns the fuel pump. The fuel pump pulls fuel from the fuel tank. The fuel pump pushes fuel through a filter and a solenoid valve and outthe burner head nozzle. A fine mist of fuel is sprayed into the combustion chamber. The Air System: The mot...
Page 7 - FUELS; Use a KEROSENE ONLY storage container. Be sure storage; WARNING; VENTILATION; Fresh Air Opening Requirements; Square
7 103807 FUELS Do not use heavy fuels such as No. 2 fuel oil or No. 2 diesel. Using heavy fuelswill result in: • clogged fuel filter and nozzle• carbon build-up on spark plug• the need of non-toxic anti-icer in fuel during very cold weather IMPORTANT: Use a KEROSENE ONLY storage container. Be sure s...
Page 8 - OPERATION; To Start Heater; Follow all ventilation and safety information.
8 103807 OPERATION To Start Heater 1. Follow all ventilation and safety information. 2. Fill fuel tank with kerosene or No. 1 fuel oil. 3. Attach fuel cap. 4. Set thermostat dial to desired temperature. Note: Thermostat setting must be higher than surrounding air temperature. 5. Plug power cord of h...
Page 9 - To Stop Heater; OR SHIPPING; To Restart Heater; CAUTION
9 103807 To Stop Heater CAUTION Never unplug heater while heater is running. Heater must gothrough purge cycle. The purge cycle cools the combustionchamber. Damage to heater can occur if combustion chamber isnot cooled. Do not restart heater until purge cycle is complete. Note: If shipping, transpor...
Page 10 - How To; PREVENTATIVE; Item
10 103807 How To See Storage, page 9. Lift out of fuel tank and rinse with clean kerosene. See Fuel Filters, page 17. See Fuel Lines, Page 16. See Fuel Filters, page 17. See Spark Plug, page 15. See Fan Blades, page 14. Remove dirt and trash with clean, soft cloth. PREVENTATIVE MAINTENANCE SCHEDULE ...
Page 11 - SHOOTING; POSSIBLE CAUSE
11 103807 OBSERVEDPROBLEM TROUBLE- SHOOTING Motor does notstart when heateris plugged in andthermostat settingis higher thansurrounding airtemperature. 1. No power or low voltage at heater due to:A) Damaged power cordor extension cordB) Wrong size extensioncordC) Heater plugged intooutlet with volta...
Page 14 - Upper Shell Removal
14 103807 SERVICE PROCEDURES Upper Shell Removal 1. Remove screws and lockwashers along each sideand top of heater using 5/16"nut-driver. These screwsattach upper and lower shellstogether (see Figure 5). 2. Lift upper shell off. Fan Blades 1. Remove upper shell (see above). 2. Clean fan blades w...
Page 16 - Fuel Lines
16 103807 Pump (Procedure if pump is binding) 1. Remove upper shell (see page 14). 2. Loosen hex screw on flange clamp at rear of motor with5/16" nut-driver (see Figure11). 3. Turn fan with hand (see Figure 12). 4. If fan turns freely, tighten screw on flange clamp. 5. If fan does not turn freel...
Page 17 - Fuel Filters
17 103807 B. Pump Fuel Filter 1. Unscrew canister bottom from canister top withChannellock pliers. 2. Remove fuel filter and gasket from canister bottom (seeFigure 16). 3. Inspect canister bottom and fuel filter for water or dirt. 4. Rinse canister bottom in clean kerosene. 5. Wipe inside of caniste...
Page 18 - HIGH PRESSURE AIR GAGE - M4574; ACCESSORY
18 103807 WIRING DIAGRAM SPECIFICATIONS 1 3 2 Fan Switch 7 5 B A Motor Relay White Red Orange Orange Red Black White Black White Blue Blue White Black Black Thermostat B R Burner Control Reset Button Red Yellow Yellow White Solenoid Valve White Terminal Board Terminal Board Ignitor White Spark Plug ...
Page 19 - Burner Head Assembly; Motor and Pump Assembly; PARTS LIST
19 103807 4 1 2 3 30 5 6 7 8 9 10 11 12 8 13 14 15 16 17 18 20 19 21 32 32 30 30 23 24 25 27 26 28 29 30 33 31 36 35 34 22 REF.NO. PART NO. DESCRIPTION QTY. 1 097495-02AA Wiring cover 1 2 HF5-5C Screw, 5/16-24 x 5/16" 4 3 WLE-5 Lockwasher, 5/16" 4 4 M11084-26 Screw, #10-16 x 3/8" 3 5 M50...
Page 22 - EC CONFORMITY DECLARATION
22 103807 EC CONFORMITY DECLARATION EC CONFORMITY DECLARATION DESA Europe B.V. Innsbruckweg 144, NL-3047 AH Postbus 11158 NL-3004 ED Rotterdam Holland Manufacturer: DESA International, Inc. 2701 Industrial Drive Bowling Green, KY 42101 U.S.A. Kerosene Portable Forced Air Heater Model Number: B350CEA...
Page 23 - NOTES
23 103807 NOTES _______________________________________________________________ _______________________________________________________________ _______________________________________________________________ _______________________________________________________________ ____________________________...
Page 24 - WARRANTY AND REPAIR SERVICE; CERTIFICATE OF GENERAL
24 103807 WARRANTY AND REPAIR SERVICE 103807-01Rev. A08/96 POSE. IN ANY EVENT IMPLIED WARRANTIES INCLUDINGTHOSE OF MERCHANTABILITY AND FITNESS FOR A PAR-TICULAR PURPOSE ARE LIMITED TO THE DURATION OFTHIS EXPRESS WARRANTY. Any transportation charges, costs of installation, duty, taxes or any other ch...