Desa 1204 - Manual
Desa 1204 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mount push button and chime.; Use either a screw or double sided tape to mount push button.; STOP
- Page 3 – Code and Tune Settings; Code Settings; Push Button Batteries
- Page 5 – Troubleshooting; Chime does not sound:; • Do not mount chime or push button on metal or near metal studs. This; Regulatory Information; This product complies with ASTM F963-96a.; Technical Service; tance at; NO SERVICE PARTS AVAILABLE FOR THESE PRODUCTS
- Page 6 – ONE YEAR LIMITED WARRANTY; Batteries are not covered.; To obtain a refund or a
This package includes (Style of push button and chime may vary from illus-
tration):
• Wireless chime
• Wireless push button with demostration batteries
• Hardware pack
• Audio cable (Model 1204 Only)
This chime requires 3 “C” alkaline batteries for the chime and 4 “AA”
alkaline batteries for the transmitter (Not Included).
In typical use, alka-
line batteries will last up to six months.
Say What?!
™
Wireless Chime
Open back of case by removing 2 screws at bottom of battery cover with
small philips-head screwdriver. Press in catch on bottom of chime and re-
move cover. Insert batteries according to markings inside the chime. Re-
verse above procedures to reattach battery cover.
© 2003 DESA Specialty Products™
598-1126-00
Open back of push button by removing screw at top of battery cover with
small philips-head screwdriver. Slide cover up and pull bottom of cover out to
remove. Remove demonstration batteries. Insert batteries according to mark-
ings inside push button. Reverse above procedures to reattach battery cover.
1.
Install 4 type “AA” alkaline batteries in push button.
2.
Install 3 type “C” alkaline batteries in chime.
RE
C.
5
4
3
2
1
ALL
Model 1204 Shown
Tune
Selector
Battery Cover
Jumpers
Record Button
Audio Cable Jack
(Model 1204 Only)
Screw
Volume Control
(Not Shown)
Keyhole
RE
C.
OPEN
Battery
Cover
Screw
Jumpers
Audio Cable Jack
(Model 1204 Only)
Keyhole
Record
Button
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
-2- 598-1126-00 5. Mount push button and chime. Use either a screw or double sided tape to mount push button. To mount with screw, determine where push button will be located. Using 3/16" drill bit, drill tap hole. If screw is not mounted directly into wood stud ortrim molding, use drywall ancho...
-3- 598-1126-00 Code and Tune Settings Code Settings Note: Most installations will not require you to change any jumpers onyour chime and push button. This manual includes operating instructions for different types of chimes. Allchimes work on the same principle and use the same channel setting info...
-5- 598-1126-00 Troubleshooting Chime does not sound: • Make sure push button and chime codes are the same (See page 3).• Check orientation of push button and chime batteries (See markings in- side push button and chime). • Check charge of push button and chime batteries, replace if necessary.• Veri...
