Delta SS250 - Manual - manualsarea.com

Page 2 - GENERAL SAFETY RULES

2 GENERAL SAFETY RULES Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with the operation of the product. Using the machine with respect and caution willconsiderably lessen the possibility of personal inj...

Page 3 - SAVE THESE INSTRUCTIONS.

ADDITIONAL SAFETY RULES FOR SCROLL SAWS 3 WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY. SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others. 1. DO NOT OPERATE your scroll saw until it is completely assembled and installed according to theinstr...

Page 5 - EXTENSION CORDS; OPERATING INSTRUCTIONS; FOREWORD; UNPACKING AND CLEANING; NOTICE: THE MANUAL COVER PHOTO ILLUSTRATES THE CURRENT

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug and matching receptacle which will accept the machine’s plug. When using anextension cord, be sure to use one heavy enough to carry the current of the ...

Page 6 - SCROLL SAW PARTS

6 SCROLL SAW PARTS Fig. 1 Fig. 2 Fig. 1 1. Scroll Saw with blade attached 1 Fig. 2 2. Table 3. Quickset Blade Changing Wrench 4. Holddown Rod 5. 4mm Hex Wrench 6. Locking Handle 7. M10 Flat Washer 8. Blank Table Insert 9. Table Insert 10. Special Screw M6x1x45mm (2) 11. M6 Locknut (2) 2 3 4 5 6 7 8 ...

Page 7 - ASSEMBLY

7 ASSEMBLY 1. Remove the blade from the scroll saw. 2. Move the blade lever tension handle (A) Fig. 3, to the foreword position as shown. 3. Push chuck locking lever (B) Fig. 4 to the rear as shown. This will release the blade (C) from the upperchuck assembly (D). 4. Insert long end (F) Fig. 5, of q...

Page 10 - OPERATING CONTROLS AND ADJUSTMENTS

10 FASTENING SCROLL SAWTO SUPPORTING SURFACE Your scroll saw MUST be securely fastened to a stand or workbench using the holes in the four rubber feet,three of which are shown at (A) Fig. 16. IMPORTANT: When mounting the saw to a stand or workbench DO NOT over-tighten mounting bolts. Leave some cush...

Page 17 - LUBRICATION; BLADE BREAKAGE

17 LUBRICATION Fig. 39 Fig. 40 Fig. 42 1. DISCONNECT MACHINE FROM POWER SOURCE. 2. Remove four screws (A) Fig. 39, and remove side panel (B) from the scroll saw. 4. Lubricate the shafts of two special screws (D) Fig. 41, with a few drops of light machine oil in the areaswhere they pass through the c...

Page 18 - NOTES

Page 20 - Two Year Limited Warranty; PARTS, SERVICE OR WARRANTY ASSISTANCE

Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a Delta factory service c...

Delta SS250 - Manual

Table of Contents:

Summary

Other Delta Models