Dayton SPA1200/2400DSP - Manual
Dayton SPA1200/2400DSP – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Subwoofer Power Amplifiers; Table of Contents
- Page 6 – Do NOT bridge outputs. Dual voice coil and dual driver loads only!
- Page 7 – Feature control-panel key; Green LED when amp is operating normally
- Page 8 – Amp system block diagram
- Page 11 – Starting iEQ; : Selecting the GUI’s
- Page 14 – iOS Subwoofer Remote Control “App” Guide; Your SPA1200 or 2400DSP amp has its own internal Wi-Fi communica; Note: App Coming Soon; Discover the app (click page for
- Page 15 – If you have; not; connected your iPhone to the amp, the app will
- Page 16 – Firmware Update Guide:; procedure if such an update is provided to all amp owners:
- Page 17 – above “Load File” button:
- Page 19 – Press “RUN”; or; cycle power on your amp and the device will now run the new
- Page 20 – DSP Functions; Feature C; ti; Advanced C; GUI gives post-correc
- Page 21 – Base Specifications (AudioPrecision
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
(4) Operating Guide: Dayton Audio SPA1200/2400DSP Subwoofer Power Amplifiers Table of Contents Back panel and input/output (I/O) definition ........................................................... 5 SPA1200DSP and SPA2400DSP wiring .....................................................................
(6) SPA1200DSP and SPA2400DSP wiring SPA1200DSP SPA2400DSP - NOTE: Do NOT bridge outputs. Dual voice coil and dual driver loads only!
(7) Feature control-panel key • Power ON LED: Green LED when amp is operating normally • Standby (STB ) LED : Red when amp is in energy saving “stand by” state • LIMIT LED (Yellow): Lit when Limiter is active • FEATURE SETUP: Single knob digital actuator with single/double-click enabled with rotary ...
