Dakota Digital UTV-1500 - Manual
Dakota Digital UTV-1500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – page 2; will mount in this mounting location.; skip to step 10; Be prepared to catch any coolant that may drain out.
- Page 3 – page 3; SETUP
- Page 4 – page 4
- Page 5 – page 5; TEMP OIL; ADDITIONAL SETUP NOTES
- Page 6 – page 6; SERV; NOTE: Preset MUST be done with correct unit or odometer
- Page 7 – page 7; TEMP OIL; TROUBLESHOOTING; ENG
- Page 8 – page 8; TEMP; SERVICE AND REPAIR; ©Copyright 2009 Dakota Digital Inc.
page 1
MAN#650265
UTV-1500
Gauge for Polaris RZR
MPH
A
B
TEMP
OIL
km/h
E
F
VOLTS
FUEL
1
2
3
4
5
6
7
SERV
HR
Tachometer bar graph
Speed display
Light sensor location
Message center
Speed unit indicators
4x4 on indicator
Check engine indicator
Gear position indicators
Fuel bar graph
Operation menu
Switch functions:
Pressing the switch during normal gauge operation will move the message center through the below display functions.
Odometer
A
Trip odometer A (hold switch to reset)
B
Trip odometer B (hold switch to reset)
SERV
Countdown service odometer (hold switch to reset) *
not displayed if disabled
HR
Engine hour meter
SERV
HR
Countdown service hour meter (hold switch to reset) *
not displayed if disabled
VOLTS FUEL
volt and fuel display *
will only display volts if fuel display is disabled
TEMP OIL
Water temp and oil pressure display *
display can be disabled if not used, see setup
Tachometer readout
:
Clock (hold switch to set)
Setting clock:
Press and release switch changes current digit
Press and hold switch to move to next digit or leave set mode
IMPORTANT NOTE!
This gauge has an odometer and
hour meter preset option that is
only available for the first 10 miles
(16km) and 1 engine hour of
operation. See “preset odometer”
and/or “preset hour meter” for
instructions.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
page 2 MAN#650265 INSTALLATION: 1. Disconnect the battery to prevent possible damage to the electrical system or gauge during install. 2. Remove the rubber mounting ring and stock gauge by pushing the gauge out from behind the dash. The UTV gauge will mount in this mounting location. 3. If not insta...
page 3 MAN#650265 a. Turn the provided dual terminal pressure sensor into female end of pressure sensor extension assembly and tighten with appropriate wrenches. Teflon tape or similar sealant may be used to ensure a leak free installation. b. Locate and remove the plug from the pressure check port ...
page 4 MAN#650265 Follow the steps below for gauge setup: 1. Press and hold the switch while turning the key on. (If calibrating speed press and hold switch while starting engine.) 2. Release switch. Gauge will scroll through the main menu options. 3. When the desired option is displayed, press and ...
