Dakota Digital UTV-1200 - Manual
Dakota Digital UTV-1200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Be sure to check engine oil level and add oil if needed; SETUP
- Page 4 – ADDITIONAL SETUP NOTES; ADJUST
- Page 5 – TROUBLESHOOTING; SERVICE DUE; GAUGE WIRE COLOR CHART
- Page 6 – SERVICE AND REPAIR; ©Copyright 2009 Dakota Digital Inc.
page 1
MAN#650244:A
UTV-1200
Multi Gauge for
2008 Yamaha Rhino
Operation menu
Left switch functions
Pressing the left switch during normal gauge operation will move through the below commonly viewed functions
for convenience.
00000.0
Odometer
12:00A
Clock (hold left switch to set)
Setting clock:
Left switch press moves between hours and minutes
Right switch press changes current value
Hold left switch again to exit clock set mode
H 0.0
Hourmeter
Right switch functions
Pressing the right function switch during normal operation will scroll through the following display functions. A
heading will first appear after each press to display the currently selected function. After about 2 seconds, the
display will show the data for the selected function.
Heading
Data
Description
trip A
a 0.0
Trip A (hold right switch to reset)
trip b
b 0.0
Trip B (hold right switch to reset)
srv mi
(
srv km
)
s 0000
Count down Service odometer if enabled (hold right switch to reset)
srv hr
sh 000
Count down service hour meter if enabled (hold right switch to reset)
mph
(
KPH
)
00 mph
(
00 KPH
)
Alternate speed display (hold right switch to change primary unit)
tach
r 0000
Tachometer displays in information center
IMPORTANT NOTE!
This gauge has an hour meter and
odometer preset option available only
for the first 1.0 engine hour and 10
miles (16km). See “ODO/HR
PRESET” for instructions.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
page 2 MAN#650244:A INSTALLATION: 1. Disconnect the battery to prevent possible damage to the electrical system or gauge during install. 2. Remove the stock gauge or indicator panel (see service manual for removal instructions). The UTV gauge will mount in this mounting location. 3. Remove the seats...
page 4 MAN#650244:A ADDITIONAL SETUP NOTES : SPEED – AUTO This setup option allows calibrating to a known mile or kilometer. By default, the speed is calibrated to use the Rhino Factory speed signal. Calibration should only be needed if the factory calibration is no longer correct due to changes to ...
page 5 MAN#650244:A OPTION – DIM OUT The dim out option allows the dim output to be turned on or off. The dim output is used if you have installed other Dakota Digital gauges and would like this gauge to also control the dimming of these gauges. If the dim out option is turned on, 12v is sent out on...
