Dakota Digital MCL-30K-SPD - Manual
Dakota Digital MCL-30K-SPD – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Stock VSS
- Page 4 – restart until the speed reaches zero and you start driving again.
- Page 5 – Common problems during calibration:
- Page 6 – Possible cause
- Page 7 – SERVICE AND REPAIR
1
MAN#650334:A
MCL-30K-SPD
Thank you for purchasing the Dakota Digital MCL-30K-SPD gauge for your Harley Davidson Touring bike. This is
designed to be a replacement for all touring models from 1996 – 2003. This is part of a six gauge package for touring
models so you can add additional gauges as you choose.
INSTALLATION
First read and familiarize yourself with all of the components and this manual. The first step is to remove the
seat and disconnect the negative side of the battery, as with any electronic install. Once the battery is disconnected you
are ready to start.
Remove the outer fairing for FLHT models; this will vary from model to model, please follow the service manual
to expose the wiring and gauges. Road Glide (FLTR) models will not need the outer fairing removed.
Ultra (FLHT) with outer removed
Remove Factory Gauges
Now you are ready to start unplugging and removing the original speedometer.
ULTRA FLHT (batwing fairings)
Remove the clamps that hold the Speed and Tach in place with a screw driver or wrench depending on
application, and remove the gauges.
Remove speedo cable/unplug gauges Remove nuts/screws and clamp to remove factory gauges
IMPORTANT NOTE!
This gauge has an odometer preset option that is only available for the first
100 miles (160km) of operation. See “preset odometer” for instructions.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 MAN#650334:A WIRING First locate your speedometer connectors in the factory wiring harness that were unplugged from the original speed gauge. The wires needed for the Dakota Digital speedometer should all be found here. The factory connector can be cut off or the new wires can be spliced into the ...
4 MAN#650334:A FUNCTION SWITCH The push button function switch mounted beside the speedometer allows access to all of the mileage and performance information. Pressing and releasing the function switch toggles through the different displays. Pressing and holding the switch for about 2 seconds will r...
5 MAN#650334:A SPEEDOMETER SETUP Main Menu Sub Menu Description SPD Avto select speed unit and auto calibrate speed AdJvSt select speed unit and adjust calibrate speed S SEt miles to service setting PErF enable/disable performance readings -odoMK one-time odometer preset (only shown while odometer h...
