Cisco 6100 - Manual
Cisco 6100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Basic Cabling for Subtending
- Page 3 – Installation Procedures - Subtending; Installation Steps Checklist
- Page 4 – Connecting the DS3 Subtending Card; DS3 Subtend Card
- Page 5 – DS3 Subtending Card Connector
- Page 6 – DS3 Subtend Card - Standoffs
- Page 7 – Installing the DS3 Subtend Module; DS3 Subtending Host Module
- Page 8 – Thick Coaxial Cable through Ferrite Bead
- Page 9 – Ferrite Beads Close to BNC Connectors
- Page 10 – Adding a DS3 Subtend Card; Adding Standoffs for a DS3 Card
- Page 11 – Connect the DS3 I/O card to connector J48 as shown in Figure 8-4.
C H A P T E R
Cisco 6100 Set Up and Installation Manual
8-1
8
Installation - Subtended Network
This section discusses installation procedures for adding subtended 6100s to a subtending host 6100.
In this manual, the term “subtending” refers to the host 6100 node, and “subtended” refers to the
downstream 6100 node in a subtended network.
All 6100s in a subtended network are installed in either a Digital Off-Hook (DOH) or a direct
connect configuration first. Then if the network is to be subtended, the procedures in this section
apply.
8.1 Cabling Configuration - Subtending
This section provides an illustration showing the cabling requirements for a subtended 6100.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
8 Installation - Subtended Network 78-5481-02 09/15/98 Cisco 6100 Set Up and Installation Manual 8-2 8.1.1 Cable Diagram - Subtending The following is an illustration of the basic cabling of a subtended 6100. Some connectors are notused because they are specific to one of the other configurations of...
78-5481-02 09/15/98 Installation - Subtended Network 8 Cisco 6100 Set Up and Installation Manual 8-3 8.2 Installation Procedures - Subtending The following table shows a check list of the installation steps for subtended 6100s. Then subsequentsubsections, as noted in the last column of the Table 8-1...
8 Installation - Subtended Network 78-5481-02 09/15/98 Cisco 6100 Set Up and Installation Manual 8-4 8.2.2 Connecting the DS3 Subtending Card The DS3 subtending I/O card has two sets of DS3 75-ohm coaxial BNC connectors. Each setconsists of a transmit and a receive connector. The following figure il...
