Cisco 3 - Manual
Cisco 3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Using the Console and the Management Ports; Modem Support; Modem Support for Recovering a System Image
- Page 3 – About Passwords; Configuring the Management Port
- Page 5 – Configuring the Host Name
- Page 6 – Viewing the Contents of Boot Flash Memory; Deleting Files from Boot Flash Memory
- Page 7 – Backing Up a System Image to a TFTP Server
- Page 9 – Erasing Files from a Full Boot Flash Memory SIMM
- Page 11 – Recovering a System Image Using Xmodem and Ymodem
- Page 12 – Xmodem Transfer Example Using the ROM Monitor
- Page 14 – Updating the System Image; Downloading System Images from CCO; Copying the System Image to the Switch Router
- Page 16 – Reloading the Switch Router
C H A P T E R
3-1
Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide
78-10408-01, Cisco IOS Release 12.0(7)W5(15d)
3
Initial Switch Router Configurations
This chapter describes how to initially configure the Layer 3 switch routers.
•
Starting Up the Layer 3 Switch Router
•
Using the Console and the Management Ports
•
Configuring the Management Port
•
•
Using the Boot Flash Memory SIMM
•
Recovering a System Image Using Xmodem and Ymodem
•
Note
You are at Step 2 in the suggested process for configuring your Layer 3 switch router
(see Table 2-1 on page 2-1). You should have already set up the hardware before
proceeding with the initial switch router configurations.
Starting Up the Layer 3 Switch Router
The following is a review of tasks you should have completed during hardware installation, including
starting up the switch router. These tasks must be completed before proceeding with configuring your
switch router.
Step 1
Check that the switch router is set for the correct AC (or DC) power voltages.
Refer to the
Catalyst 2948G-L3 Hardware Installation Guide
or the
Catalyst 4908G-L3 Hardware
Installation Guide
for correct power voltages.
Step 2
Connect the cables to the switch router.
Step 3
Connect the console terminal to the switch router.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3-2 Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide 78-10408-01, Cisco IOS Release 12.0(7)W5(15d) Chapter 3 Initial Switch Router Configurations Using the Console and the Management Ports Step 4 Power on the switch router. Step 5 Enter CLI configuration mode by answe...
3-3 Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide 78-10408-01, Cisco IOS Release 12.0(7)W5(15d) Chapter 3 Initial Switch Router Configurations Configuring the Management Port Xmodem or Ymodem protocols. The Xmodem and Ymodem protocols support different speeds of fi...
3-5 Catalyst 2948G-L3 and Catalyst 4908G-L3 Software Feature and Configuration Guide 78-10408-01, Cisco IOS Release 12.0(7)W5(15d) Chapter 3 Initial Switch Router Configurations Configuring the Host Name You can display the configuration file when you are in privileged EXEC (enable) mode. • To see t...
