Chief MIWRF Series - Manual

Page 2 - DISCLAIMER

MIWRF SERIES Installation Instructions 2 DISCLAIMER Milestone AV Technologies, and its affiliated corporations andsubsidiaries (collectively, "Milestone"), intend to make thismanual accurate and complete. However, Milestone makes noclaim that the information contained herein covers all detai...

Page 3 - TOOLS REQUIRED FOR INSTALLATION AND PARTS; Figure 1

Installation Instructions MIWRF SERIES 3 TOOLS REQUIRED FOR INSTALLATION AND PARTS Figure 1 x1 I/M F2 (4) A (1) J (8) F (1) B (2) D (4) C (4) E (2) F1 (4) G (2) Universal Interface Bracket provided with Models MIWRFUB and MIWRFVB not shown. L (4) H (8) K (4) 5/16" x 2 1/2" 5/16-18 5/16" ...

Page 4 - Installation; Using the lateral shift feature will impact; Figure 2

MIWRF SERIES Installation Instructions 4 Installation WARNING: IMPROPER INSTALLATION CAN RESULT IN DEATH OR SERIOUS PERSONAL INJURY! This accessoryshould be installed by qualified personnel only. WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURYOR DAMAGE TO EQUI...

Page 5 - Figure 4

Installation Instructions MIWRF SERIES 5 WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL WIRES OR CABLESCAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!ALWAYS make certain area behind mounting surfaces is freeof electrical wires and cables before cutting, drilling, orinstalling fast...

Page 6 - Figure 7; Cover and Trim Installation; Cover Installation

MIWRF SERIES Installation Instructions 6 Figure 7 Cover and Trim Installation Cover Installation To install covers: 1. Install upper and lower wall channel covers (E) by tippingcover top down and positioning as shown in end view offigure below. (See Figure 8) 2. Tap firmly across bottom of channels ...

Page 7 - Trim Installation; Figure 9; Display Installation

Installation Instructions MIWRF SERIES 7 Trim Installation To install optional trim; 1. Orient two trim pieces (G) as shown in figure below.(See Figure 9) 2. Slide slat in trim edge over lip in mount enclosure and presstrim (G) onto enclosure. (See Figure 9) Figure 9 Display Installation WARNING: IM...

Page 8 - CABLE MANAGEMENT; ADJUSTMENTS; Pitch Tension Adjustment

MIWRF SERIES Installation Instructions 8 CABLE MANAGEMENT WARNING: IMPROPER INSTALLATION CAN LEAD TO SERIOUS PERSONAL INJURY OR DAMAGE TOEQUIPMENT! Make sure cables do not run through pinchpoints. 1. Locate and install cable tie clips (J) where desired for propercable routing. (See Figure 12) Figure...

Page 9 - Extend/Retract Tension Adjustment; Display Height Adjustment

Installation Instructions MIWRF SERIES 9 Figure 15 Extend/Retract Tension Adjustment Arm Extend and Retract tension is pre-set at the factory and isadjusted to accommodate displays with weights near the top ofthe mounts capacity. If smaller displays are used it may be difficult to reposition thedisp...

Page 10 - YAW Tension Adjustment; TOP VIEW

MIWRF SERIES Installation Instructions 10 YAW Tension Adjustment The mount is designed to accommodate up to 37.5 deg. oftravel to left and right of center. To adjust YAW tension: 1. With display installed, loosen adjustment screw using hexwrench. (See Figure 18) 2. Check for desired tension. 3. Repe...

Page 11 - DIMENSIONS

Installation Instructions MIWRF SERIES 11 DIMENSIONS

Page 12 - Europe; Asia Pacific

MIWRF SERIES Installation Instructions Chief Manufacturing, a products divisionof Milestone AV Technologies 8805-000249 Rev A 2008 Milestone AV Technologies www.chiefmfg.com 11/08 USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.69...

Chief MIWRF Series - Manual

Table of Contents:

Summary

Other Chief Models