Chauvet DMX512 - Manual - manualsarea.com

Page 3 - What is included

1. B EFORE Y OU B EGIN What is included ¾ 1 x SX Gobo™ ¾ EHJ 24V 250W Lamp ¾ 7 Replaceable Gobos ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in ...

Page 4 - Safety Instructions

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product. x Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they also receive this instructi...

Page 5 - NTRODUCTION; Features

2. I NTRODUCTION Features x High-output rotating gobo projector x Interchangeable rotating color/gobos 6 metal gobos with 5 dichroic colors + white x Dual spring clips for a single dichroic color x Adjustable rotation speed x 3-position switch: CW rotation Stop CCW rotation x Fan cooled Product Over...

Page 6 - ETUP; Lamp

3. S ETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. An 800W halogen lamp is included. Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. Do...

Page 7 - FUSE

Lamp Alignment How-To Lamp alignment screws Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is refered to as a hot spot. This is due to the most intense point of the lamp source not being positioned optimally within the reflector. There are thr...

Page 8 - Replacing Gobos

Figure A Figure B Figure C Replacing Gobos 1) Open the top cover by removing the six screws indicated in figure A. 2) Remove the retaining spring using a flathead screwdriver (figure B). 3) Remove the gobo and replace with a new gobo. Note: The black side of the gobo should be facing the lamp. 4) Re...

Page 9 - Mounting; O R I E N T A T I O N; PERATING

Mounting O R I E N T A T I O N This fixture may be mounted in any position provided there is adequate room for ventilation. R I G G I N G Hanging Clamp It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixtu...

Page 10 - General Troubleshooting

General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers & Chaser Auto shut off Check fan thermal switch reset 9 Beam is very dim or not bright Clean optical system or replace lamp Check 220/110v switch for proper setting 9 Breaker/Fuse keeps blowing C...

Page 11 - Technical Support; PPENDIX; General Maintenance

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-1115 - (Press 4) Fax: (954) 929-5560 - (Attention: Service) Website: http://www.chauvetlighting.com 5. A PPENDIX General Maintenance To maintain optimu...

Page 12 - Claims; Technical Specifications

Claims Damage incurred in shipping is the responsibility of the shipper; therefore the damage must be reported to the carrier upon receipt of merchandise. It is the customer's responsibility to notify and submit claims with the shipper in the event that a fixture is damaged due to shipping. Any othe...

Chauvet DMX512 - Manual

Table of Contents:

Summary

Other Chauvet Models