Canon Digital Camera - Manual
Canon Digital Camera – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – #3 Remove the Camera Body from the Camera Cover; The camera body removed from the camera cover.
- Page 4 – #4 Modify Wire Route and Attach Wiring Harness; Locate camera body side with strap guide.
- Page 5 – #5 Wiring the Camera; This is the common wire.
- Page 6 – #6 Reassemble Camera Body and Cover
- Page 7 – Check fit on top of camera cover
- Page 8 – Finish screw reinstall for remaining screws.
- Page 9 – #9 Finish Hardwired Camera and Testing; Camera must be on, and back door must be latched.
How To hardwire the CANON SURE SHOT OWL PF DATE 35mm CAMERA
Revised 1/12/04
This document outlines the modification of the Canon Sure
Shot Owl PF Date Camera so the shutter controls can be
operated remotely. It is recommended that the following “three
wire” setup be used in all cameras modified, and alternate “2
wire” setups are converted outside the camera.
Please note that following these modifications will void the
camera’s warranty. No guarantee is implied or expressed in
these instructions. This is my way of modifying the Canon Sure
Shot Owl PF Date Camera and modifications have worked to
my satisfaction. Alternate modification methods are recognized
as valid alternatives.
#1 Remove the Screws
The first step is to remove the screws from the camera body. There are 7 screws that need to be
removed. #0 Philips Screwdriver is recommend for screw removal.
Remove screws next to battery door
Remove screw on back
Remove screws from side
Remove screw from door latch side
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
#3 Remove the Camera Body from the Camera Cover Remove the camera body from the camera cover by prying the body from the battery compartment. The camera body can be removed completely from the camera cover. The camera body removed from the camera cover. Camera body / cover.
#4 Modify Wire Route and Attach Wiring Harness Locate camera body side with strap guide. Notch the strap guide for the wire route. Insert wires through lower hole in camera cover, and hot glue “free” end into strap guide slot.
#5 Wiring the Camera Wire the camera with the following positions. One wire is soldered to the pad that connects to pin 6, (counted from right to left) on the top pc board of the camera. This is the refresh wire. One wire is soldered to the pad that connects to pin 5, (counted from right to left) on...
