Canon BCI-21- Manual

Canon BCI-21

Canon BCI-21– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
Page: / 9

Table of Contents:

  • Page 2 – REFILL INSTRUCTIONS FOR CANON; BLACK; cc’s
  • Page 3 – INKTANK upside down where the felt; THE LAST PAGE DOES NOT APPLY TO THIS CARTRIDGE
  • Page 5 – PERFORM THE NEXT SEVERAL STEPS OVER THE SINK; IF YOU NOTICE, THE SPONGES ARE ALL WHITE. THEY ARE SUPPOSE TO STAY; NEVER PLACE A LEAKING CARTRIDGE INTO THE PRINTER
  • Page 6 – See below
Loading the manual

1

Http://www.usaink.com

REFILL INSTRUCTIONS FOR ALL CANON CARTRIDGES

BLACK AND

COLOR

TABLE OF CONTENTS

INTRO.......................................................1

BCI-21 & BCI-24 BLACK............................... 2

BCI-21 & BCI-24

COLOR

..................................3

PG-40 BLACK..........................4

CL-41

COLOR

.......................5

BCI-3, BCI-5, BCI-6 BLACK...............6

BCI-3, BCI-5, BCI-6

COLOR

................same page...6

PGI 5BK & CLI 8

COLOR

...........

7

CONTACT AND RE-ORDER INFO ..................8

TROUBLESHOOTING.................................................9

PERFORM ALL OF THE FOLLOWING STEPS OVER THE SINK

HELPFUL HINTS TO REMEMBER AS REFILLING

IN REGARDS TO THE SYRINGE PROVIDED:

RINSE OUT THE SYRINGE AFTER EACH COLOR .........

ESPECIALLY THE BLACK.

SHOOT OUT ALL WATER BEFORE DRAWING UP NEW COLOR.
INSIDE OF THE SYRINGE DOES

NOT

HAVE TO BE “BONE DRY.”

Your bottles of ink will have electrical tape on the caps when you

receive them. One little trick is to not remove the cap but melt a little

hole into the top using the end of a heated paperclip.

Melt the hole, “Off center.”

SEE FIGURE > > > > > >

By doing this, all you have to do is stick the needle thru

the hole and

tilt the bottle a little to draw up the ink. When done, you can place a

piece of tape over the hole till next time.

1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Canon BCI-21

Summary

Page 2 - REFILL INSTRUCTIONS FOR CANON; BLACK; cc’s

2 REFILL INSTRUCTIONS FOR CANON BCI-21/ BCI-24 BLACK DO NOT MODIFY THE CARTRIDGE IN ANYWAY!!!! READ THESE DIRECTIONS BEFORE RELLING. 1) Turn the black cartridge upside down where the felt pad on the bottom is facing up towards you. SEE FIGURE 1 > > > 2) Using the syringe, draw up 2 cc’s of ...

Page 3 - INKTANK upside down where the felt; THE LAST PAGE DOES NOT APPLY TO THIS CARTRIDGE

3 REFILL INSTRUCTIONS FOR CANON BCI-21/ BCI-24 C O L O R DO NOT MODIFY THE CARTRIDGE IN ANYWAY!!!! PERFORM ALL STEPS OVER SINK When done refilling a certain color, simply rinse thesyringe out with water and choose your next color.Syringe does NOT have to be bone dry before refillingwith ink. Just ma...

Page 5 - PERFORM THE NEXT SEVERAL STEPS OVER THE SINK; IF YOU NOTICE, THE SPONGES ARE ALL WHITE. THEY ARE SUPPOSE TO STAY; NEVER PLACE A LEAKING CARTRIDGE INTO THE PRINTER

5 REFILL INSTRUCTIONS FOR THE CANON CL-41 C O L O R 1. The filler pads are located under the top. REMOVE the label and you will see little dimples in the plastic. You are going to melt a little hole thru three of these dimples. Use a simple heated paperclip to do this. Be carefull as the top plastic...

Other Canon Models