Cadet Softheat EBHN500- User Manual
Cadet Softheat EBHN500– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WIRING PROVISIONS / WIRING; Wiring is done on left side only.; A thermostat is required.; AREA OF INSTALLATION; Installation Instructions; Wa
- Page 3 – THERMOSTAT; Maintenance; How To Operate Your Heater; How Softheat Hydronic Baseboards Work
- Page 4 – Warranty; Symptom; Troubleshooting Chart; These warranties do not apply:; Parts and Service
- Page 5 – GUÍA PARA EL PROPIETARIO; EL EBHA; INFORMACIÓN IMPORTANTE
- Page 6 – Instrucciones para la Instalación; Pared
- Page 7 – TERMOSTATO; Mantenimiento; Como funcionan los plintos radiantes hidrónicos Softheat; Aire Frío
- Page 8 – Garantía; SONAL DE SERVICIO ELÉCTRICO CALIFICADO.; Síntoma; GUÍA DE RESOLUCIÓN DE PROBLEMAS
Tools Required:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Drill or Hammer
Level
Punch or Chisel
Drill Bits
Utility Knife
4 Wood Screws
3 Wire Nuts
1 Strain Relief Connector
OWNER’S GUIDE
The EBHA
IMPORTANT INFORMATION
SAVE THESE INSTRUCTIONS
9
1
/
2
"
24,13
3
1
/
4
"
8,26
WARNING!
When working with electricity, turn the elec-
trical power off at the electrical panel board
and lock or tag the circuit breaker door.
Failure to do so could result in serious elec-
trical shock, burns, or possible death.
1.
Read all information labels.
Verify that the
electrical supply wires are the same voltage
as the heater.
2.
All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
3.
The heater must be grounded to the grounding pigtail
(copper wire) provided.
4.
If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
5.
Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
6.
WARNING
Overheating or fire may occur. DO NOT
place the heater be-
hind doors.
7.
WARNING
Fire or explosion may occur. DO NOT
place heater in any
area where combustible vapors, gases, liquids, or excessive
lint or dust are present.
8.
WARNING
Risk of Electrical Shock.
Turn off all power at the electrical
panel board supplying power to the heater before doing
any electrical wiring.
9.
WARNING
Risk of Fire.
Heater must be kept clear of all obstructions:
maintain a 12" minimum clearance in front and above the
heater with a 6" minimum on each side. Heaters must be kept
clean of lint, dirt and debris. (See Maintenance
Instructions)
10.
WARNING!
Element filled with heat transfer fluid con-
taining 20% Ethylene Glycol and 80% water. In the unlikely
event of leakage, if consumed, call your local poison
control center or seek medical attention immediately.
Models:
EBHA500
EBHA750
EBHA1000
EBHA1380
EBHA1500
EBHA500-8
EBHA750-8
EBHA1000-8
EBHA1380-8
EBHA1500-8
• Whisper quiet operation and low surface
temperatures
• Filled with 80% water 20% Ethylene Glycol
• Self-contained hermetically sealed element design
requires no plumbing, piping, or other water supply
• Higher fluid capacity offers better heat retention,
which creates less cycling and keeps more consistent
room temperatures
• Designed to reduce the effects of indoor allergens
• 5-year element warranty
Features & Benefits
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
9
1
/
2
"
24,13
3
1
/
4
"
8,26
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WIRING PROVISIONS / WIRING This heating unit is designed for permanent installa-tion. All wiring should be routed in compliance withthe National Electrical Code and all local codes,where applicable. A maximum of No. 10 AWG wiremay be used with this heater. All wiring should beplanned and run before ...
THERMOSTAT For best results, use a Cadet wall thermostat or an EBKA 1-24 end cap DPST thermostat kit. It is recommend-ed that a thermostat be provided for each room. In extremely large rooms, a Cadet low-voltage thermostatwith double relays will give the most comfortable results. The location of the...
Warranty CONSULT LOCAL ELECTRICAL CODES TO DETERMINE WHAT WORK MUST BE PERFORMED BY QUALIFIED ELECTRICAL SERVICE PERSONNEL Gurgling noise Heater not working Liquid found in or around unit Room does not heat quickly Heater will not shut off 1. Unit may not be level 2. Unit may have developed a leak 1...
