Cadet C - Manual
Cadet C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; How do I install in an existing wall?; READ ALL
- Page 3 – After you have followed all instructions in PART ONE
- Page 4 – The Com-Pak Twin Plus; Operation & Maintenance; WARNING; With Thermostat; The Com-Pak Twin Plus; Important Instructions
- Page 5 – Warranty; Symptom; Troubleshooting Chart
- Page 6 – GUÍA DEL PROPIETARIO; CONSERVE ESTAS INSTRUCCIONES; Plus Modelo C; Twin Plus Modelo CT; Protección térmica primaria y secundaria.
- Page 7 – Instrucciones para la Instalación; LEER TODAS LAS; Parte Uno; guía
OWNER’S GUIDE
The Com-Pak
™
Plus
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
11
1
/
2
”
29.21
3
1
/
4
”
8.26
1
1
/
4
”
3.18
10”
25.4
1
3
/
4
”
4.45
1
1
/
4
”
3.18
7
7
/
8
”
20.00
4”
10.16
3”
7.62
9”
22.86
12”
30.48
10”
25.4
11
1
/
8
”
28.26
12”
30.48
16
1
/
4
”
41.27
The Com-Pak
TM
Plus Model C
The Com-Pak
TM
Twin Plus Model CT
Side
Wall Can Side
Grill Front
Wall Can Bottom
Side
Wall Can Side
Grill Front
TOOLS REQUIRED:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Utility Knife
4 1
1
/
2
“ Wood Screws
3 Insulated Wire Connectors
1 Strain Relief Connector
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
l o c k o r t a g t h e p a n e l b o a r d d o o r t o p r e v e n t
someone from turning on power while you are
working on the heater. Failure to do so could
r e s u l t i n s e r i o u s e l e c t r i c a l s h o c k , b u r n s , o r
possible death.
1.
Read all instructions before using this heater.
2.
Read all information labels.
Verify that the electrical supply
wires are the same voltage as the heater.
3.
All electrical work and materials must comply with the National
Electric Code (NEC), the Occupational Safety and Health Act
(OSHA), and all state and local codes.
4.
Connect the grounding pigtail (copper wire) provided in the wall
can to the supply ground wire.
5.
If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6.
Protect electrical supply from kinks, sharp objects, oil, grease,
hot surfaces or chemicals.
7.
WARNING
Overheating or fire may occur. Do not
install the heater in a floor,
behind doors, or outdoors.
8.
WARNING
Fire or explosion may occur.
Heater has hot and arcing or sparking
parts inside. Do not install heater in any area where combustible
vapors, gases, liquids, or excessive lint or dust are present.
9.
WARNING
Burn Hazard.
This heater is hot when in use. To avoid burns, do
not let bare skin touch hot surfaces. Use extreme caution when
any heater is used by or near children or invalids and whenever
the heater is left operating unattended.
10.
WARNING
Risk of Electrical Shock.
Keep all foreign objects out of heater.
Do not operate after heater malfunctions or has been dropped or
damaged in any manner.
11.
WARNING
Risk of Fire. Do not block heater.
Heater must be kept clear of all
obstructions: a minimum of 3 feet in front, 6 inches above and on
both sides. Heaters must be kept clean of excessive lint, dirt and
debris. (See Maintenance Instructions).
12. Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
3”
7.62
14
1
/
2
”
36.83
4”
10.16
Features & Benefits
•
Primary and secondary thermal safeguards
•
Commercial grade high temperature
manual reset
•
Over temperature one-time thermal
device
•
Nichrome element wrapped around mica
insulators for durability
•
Powder coat paint process eliminates
sharp cutting edges
•
Two year extended warranty
•
Wall can designed for ease of installation
•
Factory tested
MODELS
The Com-Pak
TM
Plus
C051
*C051T
C152
*C152T
C052
*C052T
C202
*C202T
C072
*C072T
C208
*C208T
C102
*C102T
C101
*C101T
C122
*C122T
C151
*C151T
The Com-Pak
TM
Twin Plus
CT252
*CT252T
CT102
CT302
*CT302T
CT402
*CT402T
CT408
*CT408T
*Standard built-in thermostat is single pole and has no
“OFF” position
Wall Can
Bottom
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation Instructions How do I install fornew construction walls? Figure 1 Face of wall can mustextend 1 / 2 inch or 5 / 8 inch from face of stud to allowfor thickness of sheetrock. STEP 1 Mount The Wall Can How do I install in an existing wall? STEP 1 Cut Hole In Wall Route supply wire from cir...
6” Min. 6” Min. 6” Min. 6” Min. Figure 7 Figure 6 Installation Instructions The C Series REQUIRES A MINIMUM distance of6 inches from all adjacent surfaces. However, CadetRECOMMENDS 12 inches from all adjacent surfacesfor longer and cleaner performance. Important: Do not mount the heater in low-densi...
The Com-Pak Plus Without Thermostat The Com-Pak Twin Plus Without Thermostat Operation & Maintenance How to operate your heater 1. Once installation is complete and power has been restored, turn the thermostat knob fully clockwise. 2. When the room reaches your comfort level, turn the thermostat...
