Cadet 67063 - User Manual
Cadet 67063 Thermostat – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
1. If heater is installed, remove grill and heatbox.
2. Fasten thermostat to lower left corner of heat box cover
behind bottom flange. Use two no. 6 - 32 x 1/4 inch
screws. Exact location will have to be determined when
the grill is installed. The longer part of the thermostat
body must point to the right. Shaft should come through
the large center hole. This is required to fit the heater
into the wall can.
Thermostat Installation Instructions
GENERAl SAfETy INfORmATION
If you are uncomfortable working with electrical appliances, unable to follow these guidelines, or do not have the necessary
equipment, consult a licensed electrician.
INSTAllATION INSTRUCTIONS
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone
from turning on power while you are working on
the heater. Failure to do so could result in serious
electrical shock, burns, or possible death.
For Cadet C, CS, CST & CT Series Heaters
3. (A) For double pole thermostats*
Connect one black lead of the thermostat to one lead from
the heater. Connect the other black lead to the other lead
from the heater. Connect one red lead from the thermostat
to one of the supply lines. Connect the other red lead to the
other supply line. Use approved insulated wire connectors.
(B) For single pole thermostats**
Connect black lead from the thermostat to one lead from the
heater. Connect the red thermostat lead to one supply line.
Connect the other lead from the heater to the other supply
line. Use approved insulated wire connectors.
4. After installation (or reinstallation) of the heater and the grill,
check thermostat shaft alignment with the center of the grill
hole. Adjust position of the thermostat on the heat box cover
if necessary. Push knob on shaft securely - check alignment.
TOOLS REQUIRED: Phillips Screwdriver, Insulated Wire Connectors (Wire Nuts
®
)
* Double pole thermostat is not necessary on 120 volt service.
** Single pole thermostats may be used with 120 volts or 240 volts.
Double Pole Thermostat
Single Pole Thermostat
SAVE THESE INSTRUCTIONS
www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
