Bushnell LS1440 - Manual - manualsarea.com

Page 2 - SPECIFICATIONS

2 SPECIFICATIONS Blade diameter .................................................................................................................................................... 355 mm Hole diameter......................................................................................................

Page 3 - GENERAL SAFETY RULES; Read all instructions.; Failure to follow all instructions listed below may result in; SAVE THESE INSTRUCTIONS

3 GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of thewarnings listed below refers to your mains-operated (corded) power tool or battery-operated (co...

Page 4 - ADDITIONAL SAFETY RULES FOR TOOL

4 or storing power tools. Such preventive safety measures reduce the risk of starting the power toolaccidentally. 19. Store idle power tools out of the reach of chil-dren and do not allow persons unfamiliar withthe power tool or these instructions to operatethe power tool. Power tools are dangerous ...

Page 6 - INSTALLATION; Bench mounting

6 INSTALLATION Bench mounting When the tool is shipped, the handle is locked in the lowered position by thehandle latch. Release the handle latch by lowering the handle slightly and turnthe handle latch to the released position. This tool should be bolted with four bolts to a level and stable surfac...

Page 8 - ASSEMBLY; Installing or removing saw blade

8 Fence plate The fence plate is designed to prevent smaller cutting scraps from jamminginside the blade case. The fence plate moves right or left automatically as theturn base is rotated. Switch action CAUTION: • Before plugging in the tool, always check to see that the switch triggeractuates prope...

Page 11 - Holders and holder assembly (optional accessories); OPERATION

11 Horizontal vise (Accessory) The horizontal vise can be installed on either the left or right side of the base.When performing 15° or greater miter cuts, install the horizontal vise on theside opposite the direction in which the turn base is to be turned. By turningthe vise knob counterclockwise, ...

Page 13 - Carrying tool

13 After changing the miter angle, cut the wood facing at that selectedangle. If there is a gap between the blade, the wood facing and the work-piece, move the wood facing slightly in the direction of the arrow and cutit again. CAUTION: • Use straight wood of even thickness as the wood facing. • Use...

Page 14 - MAINTENANCE; Adjusting the cutting angle

14 MAINTENANCE CAUTION: • Always be sure that the tool is switched off and unplugged beforeattempting to perform inspection or maintenance. WARNING: • Always be sure that the blade is sharp and clean for the best and safestperformance. Adjusting the cutting angle This tool is carefully adjusted and ...

Page 16 - ACCESSORIES

16 ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. Theuse of any other accessories or attachments might present a risk of injury to persons. Only use accessory orattachment for its stated purpose. If you need any assista...

Page 17 - Memo

Page 20 - Makita Corporation