Bunn 14 - Manual
Bunn 14 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.
- Page 3 – WARNING; READ THE ENTIRE; USER NOTICES; a sturdy counter or shelf.; RELEASE BUTTON WHEN CUP IS 2/3 FULL
- Page 4 – DOOR COVER INSTALLATION; Remove
- Page 6 – ELECTRICAL REQUIREMENTS; An electrician must provide electrical service as specified.; CE REQUIREMENTS; single phase models
- Page 7 – and maintained in accordance with federal, state and local codes.; PLUMBING REQUIREMENTS
- Page 9 – Corporation at; Touchscreen special cleaning instructions:
- Page 10 – CLEANING
- Page 11 – Open the front door to access the two mode switches:
- Page 12 – PROGRAMMING SWITCHES; E D C B A; Cappuccino; Dispense switches
- Page 13 – GLOSSARY
- Page 17 – or; SCHEMATIC WIRING DIAGRAM IMIX-14
IMIX
®
-14
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
45304.0001A 09/11 ©2011 Bunn-O-Matic Corporation
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 45304.1 050511 BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specified below: 2 years parts and 1 year labor. 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compres...
3 WARNING • DO NOT OVERLOAD CIRCUIT.• ALWAYS ELECTRICALLY GROUND THE CHASSIS.• DO NOT DEFORM PLUG OR CORD.• FOLLOW NATIONAL AND LOCAL ELECTRICAL CODES.• KEEP COMBUSTIBLES AWAY. FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE OR SHOCK HAZARD. READ THE ENTIRE OPERATING MANUAL BEFORE USING THIS PRODUCT ...
4 INITIAL SET-UP 1. Apply the four non-skid pads from the parts box to the bottom of the legs. 2. Remove the drip tray assembly, drip tray bracket, and splash panel assembly from the parts box. 3. Place a set of key holes in the drip tray bracket over the lower two screws in the panel below the hopp...