Broan 755 - Manual

Page 1

MODEL 755

DECORATIVE SERIES
CEILING VENTILATOR

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC
S H O C K , O R I N J U RY TO P E R S O N S , O B -
SERVE THE FOLLOWING:
1. Use this unit only in the manner intended by

the manufacturer. If you have questions, con-
tact the manufacturer at the address or tele-
phone number listed in the warranty.

2. Before servicing or cleaning unit, switch power

off at service panel and lock the service dis-
connecting means to prevent power from be-
ing switched on accidentally. When the ser-
vice disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.

3. Installation work and electrical wiring must be

done by a qualified person(s) in accordance
with all applicable codes and standards, in-
cluding fire-rated construction codes and stan-
dards.

4. Sufficient air is needed for proper combus-

tion and exhausting of gases through the flue
(chimney) of fuel burning equipment to pre-
vent backdrafting. Follow the heating equip-
ment manufacturer ’s guideline and safety
standards such as those published by the
National Fire Protection Association (NFPA),
and the American Society for Heating, Refrig-
e r a t i o n a n d A i r C o n d i t i o n i n g E n g i n e e r s
(ASHRAE), and the local code authorities.

5. When cutting or drilling into wall or ceiling, do

not damage electrical wiring and other hid-
den utilities.

6. Ducted fans must always be vented to the out-

doors.

7. NEVER place a switch where it can be

reached from a tub or shower.

8. This unit must be grounded.
9. This unit is U.L. listed. Type I.C. inherently

protected.

CAUTION

!

1. For general ventilating use only. Do not use

to exhaust hazardous or explosive materials
and vapors.

2. This product is designed for installation in

FLAT CEILINGS ONLY. Do not mount this
product in a wall.

3. The light fixture assembly must be mounted

to the fan housing assembly included with this
product. Do not mount the light fixture as-
sembly to a wiring outlet box.

4. To avoid motor bearing damage and noisy

and/or unbalanced impellers, keep drywall
spray, construction dust, etc. off power unit.

5. Please read specification label on product for

further information and requirements.

TYPICAL INSTALLATIONS

HOUSING MOUNTED

TO ADDITIONAL FRAMING

Discharge 90

0

to joists.

HOUSING MOUNTED

DIRECTLY TO JOIST

2x6 (or larger)

Discharge parallel to joists.

HOUSING MOUNTED

TO 2x4 TRUSS

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

HOUSING MOUNTED TO “I” JOIST

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

HOUSING MOUNTED TO 2x4

TRUSS

Requires additional framing

for mounting tabs.

Discharge 90

0

to joists.

HOUSING MOUNTED TO “I” JOIST

Requires additional framing

for mounting tabs.

Discharge 90

0

to joists.

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 4.

*

Additional framing must be a 2x6 (minimum height), at least 9-inches long.

*

*

*

*

*